scholarly journals Spectroscopic and Voltammetric Analysis of Platinum Group Metals in Road Dust and Roadside Soil

Environments ◽  
2018 ◽  
Vol 5 (11) ◽  
pp. 120 ◽  
Author(s):  
Charlton van der Horst ◽  
Bongiwe Silwana ◽  
Emmanuel Iwuoha ◽  
Vernon Somerset

The emission of toxic compounds by increasing anthropogenic activities affects human health and the environment. Heavy road traffic and mining activities are the major anthropogenic activities contributing to the presence of metals in the environment. The release of palladium (Pd), platinum (Pt), and rhodium (Rh) into the environment increases the levels of contamination in soils, road sediments, airborne particles, and plants. These Pd, Pt, and Rh in road dusts can be soluble and enter aquatic environment posing a risk to environment and human health. The aim of this study is to determine the levels of Pd, Pt, and Rh with spectroscopy and voltammetric methods. Potential interferences by other metal ions (Na(I), Fe(III), Ni(II), Co(II)) in voltammetric methods have also been investigated in this study. At all the sampling sites very low concentrations of Pd, Pt, and Rh were found at levels that range from 0.48 ± 0.05 to 5.44 ± 0.11 ng/g (dry weight (d.wt)) for Pd(II), with 17.28 ± 3.12 to 81.44 ± 3.07 pg/g (d.wt) for Pt(II), and 14.34 ± 3.08 to 53.35 ± 4.07 pg/g (d.wt) for Rh(III). The instrumental limit of detection for Pd, Pt, and Rh for Inductively Coupled Plasma Quadrupole-based Mass Spectrometry (ICP-QMS) analysis was found to be 3 × 10−6 µg/g, 3 × 10−6 µg/g and 1 × 10−6 µg/g, respectively. In the case of voltammetric analysis the instrumental limit of detection for Pd(II), Pt(II), and Rh(III) for differential pulse adsorptive stripping voltammetry was found to be 7 × 10−8 µg/g, 6 × 10−8 µg/g, and 2 × 10−7 µg/g, respectively. For the sensor application, good precision was obtained due to consistently reproduced the measurements with a reproducibility of 6.31% for Pt(II), 7.58% for Pd(II), and 5.37% for Rh(III) (n = 10). The reproducibility for ICP-QMS analysis were 1.58% for Pd(II), 1.12% for Pt(II), and 1.37% for Rh(III) (n = 5). In the case of repeatability for differential pulse adsorptive stripping voltammetry (DPAdSV) and ICP-QMS, good standard deviations of 0.01 for Pd(II); 0.02 for Pt(II), 0.009 for Rh(III) and 0.011 for Pd, 0.019 for Pt and 0.013 for Rh, respectively.

Chemosensors ◽  
2021 ◽  
Vol 9 (5) ◽  
pp. 94
Author(s):  
Víctor Padilla ◽  
Núria Serrano ◽  
José Manuel Díaz-Cruz

A commercial and disposable screen-printed carbon electrode (SPCE) has been proposed for a fast, simple and low-cost determination of Ni(II) at very low concentration levels by differential pulse adsorptive stripping voltammetry (DPAdSV) in the presence of dimethylglyoxime (DMG) as complexing agent. In contrast with previously proposed methods, the Ni(II)-DMG complex adsorbs directly on the screen-printed carbon surface, with no need of mercury, bismuth or antimony coatings. Well-defined stripping peaks and a linear dependence of the peak area on the concentration of Ni(II) was achieved in the range from 1.7 to 150 µg L−1, with a limit of detection of 0.5 µg L−1 using a deposition time of 120 s. An excellent reproducibility and repeatability with 0.3% (n = 3) and 1.5% (n = 15) relative standard deviation, respectively, were obtained. In addition, the suitability of the SPCE as sensing unit has been successfully assessed in a wastewater certificated reference material with remarkable trueness and very good reproducibility.


2012 ◽  
Vol 2012 ◽  
pp. 1-6
Author(s):  
S. N. Prashanth ◽  
Shankara S. Kalanur ◽  
Nagappa L. Teradal ◽  
J. Seetharamappa

The electrochemical behavior of isothipendyl hydrochloride (IPH) was investigated at bare and multiwalled-carbon-nanotube modified glassy carbon electrode (MWCNT-GCE). IPH (55 μM) showed two oxidation peaks in Britton-Robinson (BR) buffer of pH 7.0. The oxidation process of IPH was observed to be irreversible over the pH range of 2.5–9.0. The influence of pH, scan rate, and concentration of the drug on anodic peak was studied. A differential pulse voltammetric method with good precision and accuracy was developed for the determination of IPH in pure and biological fluids. The peak current was found to be linearly dependent on the concentration of IPH in the range of 1.25–55 μM. The values of limit of detection and limit of quantification were noticed to be 0.284 and 0.949 μM, respectively.


2013 ◽  
Vol 11 (5) ◽  
pp. 736-741 ◽  
Author(s):  
Robert Piech ◽  
Beata Paczosa-Bator

AbstractThe renewable mercury film electrode, applied for the determination of papaverine traces using differential pulse adsorptive stripping voltammetry (DP AdSV) is presented. The calibration graph obtained for papaverine is linear from 1.25 nM (0.42 µg L−1) to 95 nM (32.2 µg L−1) for a preconcentration time of 60 s, with correlation coefficient of 0.998. For the renewable mercury electrode (Hg(Ag)FE) with a surface area of 9.1 mm2 the detection limit for a preconcentration time of 60 s is 0.7 nM (0.24 µg L−1). The repeatability of the method at a concentration level of the analyte as low as 17 µg L−1, expressed as RSD is 3.3% (n=5). The proposed method was successfully applied and validated by studying the recovery of papaverine from drugs, urine and synthetic solution.


1990 ◽  
Vol 336 (3) ◽  
pp. 222-225 ◽  
Author(s):  
Lucas Hernandez ◽  
Pedro Hernandez ◽  
Encarnacion Lorenzo ◽  
Claudio Gonzalez ◽  
Inmaculada Gonzalez

1993 ◽  
Vol 15 (4) ◽  
pp. 121-125 ◽  
Author(s):  
Andrés Izquierdo ◽  
M. D. Luque de Castro ◽  
Miguel Valcárcel

An automatic-continuous method for the simultaneous determination of copper and lead based on flow injection analysis (FIA) and stripping voltammetry (SV) is proposed. The method affords the determination of the analytes at the ng/ml level (linear ranges 0.64 to 64.0 ng/ml and 2.1 to 62.2 ng/ml for copper and lead, respectively) with good precision (r.s.d. values smaller than 4%). The selectivity of SV allows the method to be applied to the determination of these analytes in bovine liver fresh samples and certified reference materials from the National Institute for Standards and Technology and the Community Bureau of Reference. The performance of the method was assessed by repeatability and validation statistical studies.


1993 ◽  
Vol 281 (2) ◽  
pp. 281-290 ◽  
Author(s):  
Robert I. Mrzljak ◽  
Alan M. Bond ◽  
Terence J. Cardwell ◽  
Robert W. Cattrall ◽  
Roger W. Knight ◽  
...  

2002 ◽  
Vol 454 (1) ◽  
pp. 83-91 ◽  
Author(s):  
A Navalón ◽  
R Blanc ◽  
L Reyes ◽  
N Navas ◽  
J.L Vílchez

Sign in / Sign up

Export Citation Format

Share Document