scholarly journals A Unified Control Strategy of Distributed Generation for Grid-Connected and Islanded Operation Conditions Using an Artificial Neural Network

2021 ◽  
Vol 13 (11) ◽  
pp. 6388
Author(s):  
Karim M. El-Sharawy ◽  
Hatem Y. Diab ◽  
Mahmoud O. Abdelsalam ◽  
Mostafa I. Marei
Keyword(s):  
Neural Network ◽  
Artificial Neural Network ◽  
Control System ◽  
Distributed Generation ◽  
Control Strategy ◽  
Current Control ◽  
Operating Conditions ◽  
Pi Controllers ◽  
Artificial Neural ◽  
The Stability

This article presents a control strategy that enables both islanded and grid-tied operations of a three-phase inverter in distributed generation. This distributed generation (DG) is based on a dramatically evolved direct current (DC) source. A unified control strategy is introduced to operate the interface in either the isolated or grid-connected modes. The proposed control system is based on the instantaneous tracking of the active power flow in order to achieve current control in the grid-connected mode and retain the stability of the frequency using phase-locked loop (PLL) circuits at the point of common coupling (PCC), in addition to managing the reactive power supplied to the grid. On the other side, the proposed control system is also based on the instantaneous tracking of the voltage to achieve the voltage control in the standalone mode and retain the stability of the frequency by using another circuit including a special equation (wt = 2πft, f = 50 Hz). This utilization provides the ability to obtain voltage stability across the critical load. One benefit of the proposed control strategy is that the design of the controller remains unconverted for other operating conditions. The simulation results are added to evaluate the performance of the proposed control technology using a different method; the first method used basic proportional integration (PI) controllers, and the second method used adaptive proportional integration (PI) controllers, i.e., an Artificial Neural Network (ANN).

scholarly journals Active and Reactive Powers Control of DFIG Based WECS Using PI Controller and Artificial Neural Network Based Controller

2020 ◽  
Vol 93 (1-4) ◽  
pp. 31-38
Author(s):  
Bilal Boudjellal ◽  
Tarak Benslimane
Keyword(s):  
Neural Network ◽  
Artificial Neural Network ◽  
Wind Energy ◽  
Control Strategy ◽  
Energy System ◽  
Maximum Power ◽  
Point Tracking ◽  
Pi Controllers ◽  
Artificial Neural ◽  
Artificial Neural Network Ann

The purpose of this study is to improve the control performance of a Doubly Fed Induction Generator (DFIG) in a Wind Energy Conversion System (WECS) by using both of the conventional Proportional-Integral (PI) controllers and an Artificial Neural Network (ANN) based controllers. The rotor-side converter (RSC) voltages are controlled using a stator flux oriented control (FOC) to achieve an independent control of the active and reactive powers, exchanged between the stator of the DFIG and the power grid. Afterward, the PI controllers of the FOC are replaced with two ANN based controllers. A Maximum Power Point Tracking (MPPT) control strategy is necessary in order to extract the maximum power from the of wind energy system. A simulation model was carried out in MATLAB environment under different scenarios. The obtained results demonstrate the efficiency of the proposed ANN control strategy.

Development of a Hybrid Artificial Neural Network and Genetic Algorithm Model for Regime Identification of Slurry Transport in Pipelines

2009 ◽  
Vol 4 (1) ◽  
Author(s):  
Sandip K Lahiri ◽  
Kartik Chandra Ghanta
Keyword(s):  
Neural Network ◽  
Genetic Algorithm ◽  
Artificial Neural Network ◽  
Operating Conditions ◽  
Misclassification Error ◽  
Wide Range ◽  
Artificial Neural ◽  
Artificial Neural Network Ann ◽  
Pipeline Design ◽  
Hybrid Artificial Neural Network

Four distinct regimes were found existent (namely sliding bed, saltation, heterogeneous suspension and homogeneous suspension) in slurry flow in pipeline depending upon the average velocity of flow. In the literature, few numbers of correlations has been proposed for identification of these regimes in slurry pipelines. Regime identification is important for slurry pipeline design as they are the prerequisite to apply different pressure drop correlation in different regime. However, available correlations fail to predict the regime over a wide range of conditions. Based on a databank of around 800 measurements collected from the open literature, a method has been proposed to identify the regime using artificial neural network (ANN) modeling. The method incorporates hybrid artificial neural network and genetic algorithm technique (ANN-GA) for efficient tuning of ANN meta parameters. Statistical analysis showed that the proposed method has an average misclassification error of 0.03%. A comparison with selected correlations in the literature showed that the developed ANN-GA method noticeably improved prediction of regime over a wide range of operating conditions, physical properties, and pipe diameters.

KNT-artificial neural network model for flux prediction of ultrafiltration membrane producing drinking water

2004 ◽  
Vol 50 (8) ◽  
pp. 103-110 ◽  
Author(s):  
H.K. Oh ◽  
M.J. Yu ◽  
E.M. Gwon ◽  
J.Y. Koo ◽  
S.G. Kim ◽  
...  
Keyword(s):  
Neural Network ◽  
Experimental Data ◽  
Artificial Neural Network ◽  
Correlation Coefficient ◽  
Network Model ◽  
Operating Conditions ◽  
Transmembrane Pressure ◽  
Feed Water ◽  
Permeate Flux ◽  
Artificial Neural

This paper describes the prediction of flux behavior in an ultrafiltration (UF) membrane system using a Kalman neuro training (KNT) network model. The experimental data was obtained from operating a pilot plant of hollow fiber UF membrane with groundwater for 7 months. The network was trained using operating conditions such as inlet pressure, filtration duration, and feed water quality parameters including turbidity, temperature and UV254. Pre-processing of raw data allowed the normalized input data to be used in sigmoid activation functions. A neural network architecture was structured by modifying the number of hidden layers, neurons and learning iterations. The structure of KNT-neural network with 3 layers and 5 neurons allowed a good prediction of permeate flux by 0.997 of correlation coefficient during the learning phase. Also the validity of the designed model was evaluated with other experimental data not used during the training phase and nonlinear flux behavior was accurately estimated with 0.999 of correlation coefficient and a lower error of prediction in the testing phase. This good flux prediction can provide preliminary criteria in membrane design and set up the proper cleaning cycle in membrane operation. The KNT-artificial neural network is also expected to predict the variation of transmembrane pressure during filtration cycles and can be applied to automation and control of full scale treatment plants.

scholarly journals Experimental implementation of artificial neural network-based active vibration control & chatter suppression

2021 ◽  
Author(s):  
Yong Xia
Keyword(s):  
Neural Network ◽  
Neural Networks ◽  
Artificial Neural Network ◽  
Control System ◽  
Vibration Control ◽  
Control Strategies ◽  
Active Vibration Control ◽  
Chatter Suppression ◽  
Active Vibration ◽  
Artificial Neural

Vibration control strategies strive to reduce the effect of harmful vibrations such as machining chatter. In general, these strategies are classified as passive or active. While passive vibration control techniques are generally less complex, there is a limit to their effectiveness. Active vibration control strategies, which work by providing an additional energy supply to vibration systems, on the other hand, require more complex algorithms but can be very effective. In this work, a novel artificial neural network-based active vibration control system has been developed. The developed system can detect the sinusoidal vibration component with the highest power and suppress it in one control cycle, and in subsequent cycles, sinusoidal signals with the next highest power will be suppressed. With artificial neural networks trained to cover enough frequency and amplitude ranges, most of the original vibration can be suppressed. The efficiency of the proposed methodology has been verified experimentally in the vibration control of a cantilever beam. Artificial neural networks can be trained automatically for updated time delays in the system when necessary. Experimental results show that the developed active vibration control system is real time, adaptable, robust, effective and easy to be implemented. Finally, an experimental setup of chatter suppression for a lathe has been successfully implemented, and the successful techniques used in the previous artificial neural network-based active vibration control system have been utilized for active chatter suppression in turning.

scholarly journals Neuro-Fuzzy Control of a Robotic Manipulator

2014 ◽  
Vol 19 (3) ◽  
pp. 575-584 ◽  
Author(s):  
P. Gierlak ◽  
M. Muszyńska ◽  
W. Żylski
Keyword(s):  
Neural Network ◽  
Artificial Neural Network ◽  
Control System ◽  
Intelligent Control ◽  
Fuzzy System ◽  
Operating Conditions ◽  
Intelligent Control System ◽  
Hybrid Controller ◽  
Compensatory Control ◽  
Neuro Fuzzy

Abstract In this paper, to solve the problem of control of a robotic manipulator’s movement with holonomical constraints, an intelligent control system was used. This system is understood as a hybrid controller, being a combination of fuzzy logic and an artificial neural network. The purpose of the neuro-fuzzy system is the approximation of the nonlinearity of the robotic manipulator’s dynamic to generate a compensatory control. The control system is designed in such a way as to permit modification of its properties under different operating conditions of the two-link manipulator

Sign in / Sign up

Export Citation Format

Share Document