High-resolution LA-ICP-MS trace-element mapping of magmatic biotite: A new approach for studying syn- to post-magmatic evolution

2020 ◽  
Vol 58 (3) ◽  
pp. 293-311 ◽  
Author(s):  
Zeinab Azadbakht ◽  
David R. Lentz

ABSTRACT Biotite grains from 22 felsic intrusions in New Brunswick were mapped in situ using a laser ablation-inductively coupled plasma-mass spectrometer (LA-ICP-MS). We investigated the extent to which biotite can retain its magmatic zoning patterns and, where zoning does exist, how it can be used to elucidate early to late stage, syn-magmatic to post-crystallization processes. Although the major element and halogen contents of the examined biotite phenocrysts are homogeneous, two-thirds of the grains display trace-element zoning for Ba, Rb, and Cs. The results also indicated that zoning is better retained in larger grains (i.e., > 500 × 500 μm) with minimal alteration and mineral inclusions. An exceptionally well-zoned Li-rich siderophyllite from the Pleasant Ridge topaz granite in southwestern New Brunswick shows Ti, Ta, Sn, W, Cs, Rb, and V (without Li or Ba) zoning. Cesium values increase from 200 to 1400 ppm from core to rim. Conversely, Sn and W values decrease toward the rim (50 to 10 and 100 to 10 ppm, respectively). Tantalum and Ti values show fewer variations but drop abruptly close to the rim of the grain (100 to 20 and 2000 to 500 ppm, respectively). These observations may indicate crystallization of mineral phases with high partition coefficients for these highly incompatible elements (except Ti) (e.g., cassiterite and rutile) followed by fractionation of a fluid phase at a later stage of magma crystallization. The preservation of zoning may indicate rapid cooling post-crystallization of the parent magma.

2006 ◽  
Vol 10 ◽  
pp. 25-28 ◽  
Author(s):  
Dirk Frei ◽  
Julie A. Hollis ◽  
Axel Gerdes ◽  
Dan Harlov ◽  
Christine Karlsson ◽  
...  

Laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) was developed in 1985 and the first commercial laser ablation systems were introduced in the mid 1990s. Since then, LA-ICP-MS has become an important analytical tool in the earth sciences. Initially, the main interest for geologists was in its ability to quantitatively determine the contents of a wide range of elements in many minerals at very low concentrations (a few ppm and below) with relatively high spatial resolution (spot diameters of typically 30–100 μm). The potential of LA-ICP-MS for rapid in situ U–Th–Pb geochronology was already realised in the early to mid 1990s. However, the full potential of LA-ICP-MS as the low-cost alternative to ion-microprobe techniques for highly precise and accurate in situ U–Th–Pb age dating was not realised until the relatively recent advances in laser technologies and the introduction of magnetic sectorfield ICP-MS (SF-ICPMS) instruments. In March 2005, the Geological Survey of Denmark and Greenland (GEUS) commissioned a new laser ablation magnetic sectorfield inductively coupled plasma mass spectrometry (LA-SF-ICP-MS) facility employing a ThermoFinnigan Element2 high resolution magnetic sectorfield ICP-MS and a Merchantek New Wave 213 nm UV laser ablation system. The new GEUS LA-SF-ICP-MS facility is widely used on Survey research projects in Denmark and Greenland, as well as in collaborative research and contract projects conducted with partners from academia and industry worldwide. Here, we present examples from some of the these ongoing studies that highlight the application of the new facility for advanced geochronological and trace element in situ microanalysis of geomaterials. The application of LASF-ICP-MS based in situ zircon geochronology to regional studies addressing the Archaean geology of southern West Greenland is presented by Hollis et al. (2006, this volume).


Minerals ◽  
2020 ◽  
Vol 10 (2) ◽  
pp. 147 ◽  
Author(s):  
Allan Pring ◽  
Benjamin Wade ◽  
Aoife McFadden ◽  
Claire E. Lenehan ◽  
Nigel J. Cook

The nature of couple substitutions of minor and trace element chemistry of expitaxial intergrowths of wurtzite and sphalerite are reported. EPMA and laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) analyses display significant differences in the bulk chemistries of the two epitaxial intergrowth samples studied. The sample from the Animas-Chocaya Mine complex of Bolivia is Fe-rich with mean Fe levels of 4.8 wt% for wurztite-2H and 2.3 wt% for the sphalerite component, while the sample from Merelani Hills, Tanzania, is Mn-rich with mean Mn levels in wurztite-4H of 9.1 wt% and for the sphalerite component 7.9 wt% In both samples studied the wurtzite polytype is dominant over sphalerite. LA-ICP-MS line scans across the boundaries between the wurtzite and sphalerite domains within the two samples show significant variation in the trace element chemistries both between and within the two coexisting polytypes. In the Merelani Hills sample the Cu+ + Ga3+ = 2Zn2+ substitution holds across both the wurztite and sphalerite zones, but its levels range from around 1200 ppm of each of Cu and Ga to above 2000 ppm in the sphalerite region. The 2Ag+ + Sn4+ = 3Zn2+ coupled substitution does not occur in the material. In the Animas sample, the Cu+ + Ga3+ = 2Zn2+ substitution does not occur, but the 2(Ag,Cu)+ + Sn4+ = 3Zn2+ substitution holds across the sample despite the obvious growth zoning, although there is considerable variation in the Ag/Cu ratio, with Ag dominant over Cu at the base of the sample and Cu dominant at the top. The levels of 2(Ag,Cu)+ + Sn4+ = 3Zn2+ vary greatly across the sample from around 200 ppm to 8000 ppm Sn, but the higher values occur in the sphalerite bands.


Minerals ◽  
2020 ◽  
Vol 10 (10) ◽  
pp. 890 ◽  
Author(s):  
Sergey Lipko ◽  
Vladimir Tauson ◽  
Valeriy Bychinskii

The characteristics of Au partitioning in a multiphase, multicomponent hydrothermal system at 450 °C and 1 kbar pressure were obtained using experimental and computational physicochemical modelling and laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) analysis. Sphalerite and magnetite contained 0.1–0.16 ± 0.02 µg/g Au and coexisted with galena and bornite which contained up to 73 ± 5 and 42 ± 10 µg/g Au, respectively. Bornite and chalcopyrite were the most effective Au scavengers with cocrystallization coefficients Au/Fe and Au/Cu in mineral-fluid system n–n × 10−2. Sphalerite and magnetite were the weakest Au absorbers, although Fe impurity in sphalerite facilitated Au uptake. Using the phase composition correlation principle, Au solubility in minerals was estimated (µg/g Au): low-Fe sphalerite = 0.7, high-Fe sphalerite = 5, magnetite = 1, pyrite = 3, pyrite-Mn = 7, pyrite-Cu = 10, pyrrhotite = 21, chalcopyrite = 110, bornite = 140 and galena = 240. The sequence reflected increasing metallicity of chemical bonds. Gold segregation occurred at crystal defects, and on surfaces, and influenced Au distribution due to its segregation at crystal interblock boundaries enriched in Cu-containing submicron phases. The LA-ICP-MS analysis of bulk and surficial gold admixtures revealed elevated Au content in surficial crystal layers, especially for bornite and galena, indicating the presence of a superficial nonautonomous phase (NAP) and dualism in the distribution of gold. Thermodynamic calculations showed that changes in experimental conditions, primarily in sulfur regime, increased the content of the main gold species (AuCl2− and AuHS0) and decreased the content of FeCl20, the prevailing form of iron in the fluid phase. The elevation of S2 and H2S fugacity affected Au partitioning and cocrystallization coefficients. Using Au content in pyrite, chalcopyrite, magnetite and bornite from volcanic-sedimentary, skarn-hosted and magmatic-hydrothermal sulfide deposits, the ranges of metal ratios in fluids were estimated: Au/Fe = n × 10−4−n × 10−7 and Au/Cu = n × 10−4−n × 10−6. Pyrite and magnetite were crystallized from solutions enriched in Au compared to chalcopyrite and bornite. The presence of NAP, and associated dualism in distribution coefficients, strongly influenced Au partitioning, but this effect does not fully explain the high gold fractionation into mineral precipitates in low-temperature geothermal systems.


2011 ◽  
Vol 17 (S2) ◽  
pp. 566-567 ◽  
Author(s):  
A Netting ◽  
J Payne ◽  
B Wade ◽  
T Raimondo

Extended abstract of a paper presented at Microscopy and Microanalysis 2011 in Nashville, Tennessee, USA, August 7–August 11, 2011.


2017 ◽  
Vol 32 (5) ◽  
pp. 975-986 ◽  
Author(s):  
Lie-Wen Xie ◽  
Jin-Hui Yang ◽  
Qing-Zhu Yin ◽  
Yue-Heng Yang ◽  
Jing-Bo Liu ◽  
...  

A new LA-MIC-ICP-MS analytical technique has been developed for the rapid measurement of 206Pb/238U zircon age (<1%, 2s) at a high spatial resolution. We show that this technique can be routinely employed to date U–Pb in small and/or complex zircons, providing a powerful tool for geochronology.


2019 ◽  
Vol 34 (9) ◽  
pp. 1800-1809 ◽  
Author(s):  
Wen Zhang ◽  
Zaicong Wang ◽  
Frédéric Moynier ◽  
Edward Inglis ◽  
Shengyu Tian ◽  
...  

An in situ Zr isotopic analytical method for zircons was developed using LA-MC-ICP-MS to reveal the Zr stable isotope variation in the complex mineral crystallization history.


Sign in / Sign up

Export Citation Format

Share Document