A Solid-State Reaction Route to Synthesize Crystallinic FeB Nanoflowers and their Magnetic Properties

2011 ◽  
Vol 306-307 ◽  
pp. 1280-1283 ◽  
Author(s):  
Jing Fa Li ◽  
Yan Yan ◽  
Yi Tai Qian

In this paper, crystallinic FeB nanoflowers were successfully prepared at 500°C for 8h with FeCl3 and NaBH4 as the reactants. Field-emission scanning electronic microscope (FESEM) and transmission electronic microscope (TEM) images showed that the flowers composed of thin flakes are in the thickness of about 30 nm. More significantly, this is the first time to synthesize crystallinic FeB nanoflowers self-assembled by thin flake. Magnetic measurement showed that the flowers were a kind of soft magnetic materials (Hc = 600 Oe, Mr = 34.6 emu/g).

2018 ◽  
Vol 13 (3) ◽  
pp. 341-343 ◽  
Author(s):  
Juanjuan Lu ◽  
Liangbiao Wang ◽  
Junhao Zhang ◽  
Qianwen Li ◽  
Weiqiao Liu ◽  
...  

2013 ◽  
Vol 340 ◽  
pp. 5-9 ◽  
Author(s):  
Feng Wang ◽  
Wei-Wei Huang ◽  
Shan-Yu Li ◽  
A-Qiang Lian ◽  
Xiao-Ting Zhang ◽  
...  

2021 ◽  
Author(s):  
Mehak Arora ◽  
Shubhpreet Kaur ◽  
Kanika aggarwal ◽  
Sunil Kumar ◽  
Parambir Singh Malhi ◽  
...  

Abstract Present work investigates the detailed multiferroic properties of Pb1 − xSmxTi1−xFexO3, (x = 0.21, 0.22, 0.23, 0.24 and 0.25) synthesize through solid state reaction route. The structural, dielectric, ferroelectric and magnetic properties were measured. A sincere study is carried out to detect the magneto-electric coupling in all the samples through magneto-dielectric, magnetization after electric poling and magneto-pe response. The maximum value of coupling coefficient (γ) and magneto-dielectric response (MDR) of sample x = 0.24 has shown by magneto-dielectric properties and magnetization after electric poling whereas magneto-pe has shown that all the samples possess multiferroic nature.


Materials ◽  
2020 ◽  
Vol 14 (1) ◽  
pp. 5
Author(s):  
Lukasz Hawelek ◽  
Tymon Warski ◽  
Patryk Wlodarczyk ◽  
Marcin Polak ◽  
Przemyslaw Zackiewicz ◽  
...  

The complex structural and magnetic studies of the annealed rapidly quenched Cu-free Fe72Ni8Nb4Si2B14 alloy (metallic ribbons form) are reported here. Based on the calorimetric results, the conventional heat treatment process (with heating rate 10 °C/min and subsequent isothermal annealing for 20 min) for wound toroidal cores has been optimized to obtain the least lossy magnetic properties (for the minimum value of coercivity and magnetic core losses at 50 Hz). For optimal conditions, the complex permeability in the 104–108 Hz frequency range together with core power losses obtained from magnetic induction dependence up to the frequency of 400 kHz was successfully measured. The average and local crystal structure was investigated by the use of the X-ray diffraction method and the transmission electron microscopy observations and proved its fully glassy state. Additionally, for the three temperature values, i.e., 310, 340 and 370 °C, the glass relaxation process study in the function of annealing time was carried out to obtain a deeper insight into the soft magnetic properties: magnetic permeability and cut-off frequency. For this type of Cu-free soft magnetic materials, the control of glass relaxation process (time and temperature) is extremely important to obtain proper magnetic properties.


2010 ◽  
Vol 24 (12) ◽  
pp. 1267-1273 ◽  
Author(s):  
RAMAN KASHYAP ◽  
TANUJ DHAWAN ◽  
PRIKSHIT GAUTAM ◽  
O. P. THAKUR ◽  
N. C. MEHRA ◽  
...  

CaCu 3 Ti 4 O 12 ( CCTO ) ceramics were prepared by the solid-state reaction route. Effect of sintering time was studied on the polarization (P) versus electric field (E) behavior. Unlike conventional ferroelectric hysteresis loop, PE hysteresis behavior in CCTO ceramics was observed to exhibit ferroelectric-like loop where polarization does not saturate but gives a maximum value. Remnant polarization and maximum polarization was observed to increase with sintering time. Current (I)–voltage (V) characteristics shows a nonlinear behavior making them useful for varistor applications. Coefficient of non-linearity (α) is also found to depend on sintering duration.


2012 ◽  
Vol 41 (3) ◽  
pp. 871-875 ◽  
Author(s):  
Yuede Pan ◽  
Yan Wang ◽  
Yanliang Liang ◽  
Zhanliang Tao ◽  
Jun Chen

2004 ◽  
Vol 405 (3-4) ◽  
pp. 271-274 ◽  
Author(s):  
Liang Shi ◽  
Yunle Gu ◽  
Tian Qian ◽  
Xiaoguang Li ◽  
Luyang Chen ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document