Study on Mode I Quasi-Static Growing Crack in a Rigid-Viscoelastic Material Interfacial Crack

2012 ◽  
Vol 525-526 ◽  
pp. 353-356
Author(s):  
Yong Yang ◽  
Zai Lin Yang ◽  
Li Qiang Tang

Under high temperature, many metals show viscoelastic properties, which are closely related to environmental factors and strain rate. Engineering practice also shows that time-dependent deformation of materials have great effects on the structural strength, rigidity and life duration. So visco-elasticity has drawn much attention in the mechanical and engineering fields.

Plant Disease ◽  
2008 ◽  
Vol 92 (12) ◽  
pp. 1695-1700 ◽  
Author(s):  
A. Murillo-Williams ◽  
G. P. Munkvold

Fusarium verticillioides causes seedling decay, stalk rot, ear rot, and mycotoxin contamination (primarily fumonisins) in maize. Systemic infection of maize plants by F. verticillioides can lead to kernel infection, but the frequency of this phenomenon has varied widely among experiments. Variation in the incidence of systemic infection has been attributed to environmental factors. In order to better understand the influence of environment, we investigated the effect of temperature on systemic development of F. verticillioides during vegetative and reproductive stages of plant development. Maize seeds were inoculated with a green fluorescent protein-expressing strain of F. verticillioides, and grown in growth chambers under three different temperature regimes. In the vegetative-stage and reproductive-stage experiments, plants were evaluated at tasseling (VT stage), and at physiological maturity (R6 stage), respectively. Independently of the temperature treatment, F. verticillioides was reisolated from nearly 100% of belowground plant tissues. Frequency of reisolation of the inoculated strain declined acropetally in aboveground internodes at all temperature regimes. At VT, the high-temperature treatment had the highest systemic development of F. verticillioides in aboveground tissues. At R6, incidence of systemic infection was greater at both the high- and low-temperature regimes than at the average-temperature regime. F. verticillioides was isolated from higher internodes in plants at R6, compared to stage VT. The seed-inoculated strain was recovered from kernels of mature plants, although incidence of kernel infection did not differ significantly among treatments. During the vegetative growth stages, temperature had a significant effect on systemic development of F. verticillioides in stalks. At R6, the fungus reached higher internodes in the high-temperature treatment, but temperature did not have an effect on the incidence of kernels (either symptomatic or asymptomatic) or ear peduncles infected with the inoculated strain. These results support the role of high temperatures in promoting systemic infection of maize by F. verticillioides, but plant-to-seed transmission may be limited by other environmental factors that interact with temperature during the reproductive stages.


2010 ◽  
Vol 654-656 ◽  
pp. 2523-2526 ◽  
Author(s):  
Keun Bong Yoo ◽  
Han Sang Lee

Many investigations about superalloys and coatings have been done in the laboratory, but evaluating the degradation condition of hot section components during service is still important not only for repair and reuse but also for outage prevention. Time dependent degradation for second stage blades of gas turbine was investigated. The degradation analysis for used blades was divided into microstructure changes by position of the blade and mechanical tests of high temperature tensile test. In the microstructure analysis, the rafting and coarsening of γ', MC decomposition and TCP phase formation occurred and progressed with increasing service time, and especially the leading and trailing edge of top layer should be a check points for used blade. High temperature tensile results of 25,000 and 52,000 hrs used blades were also compared with serviced time and position in each blade.


2004 ◽  
Vol 449-452 ◽  
pp. 57-60
Author(s):  
I.G. Lee ◽  
A.K. Ghosh

In order to analyze high temperature deformation behavior of NiAl alloys, deformation maps were constructed for stoichiometric NiAl materials with grain sizes of 4 and 200 µm. Relevant constitute equations and calculation method will be described in this paper. These maps are particularly useful in identifying the location of testing domains, such as creep and tensile tests, in relation to the stress-temperature-strain rate domains experienced by NiAl.


2000 ◽  
Vol 40 (7) ◽  
pp. 1553-1563 ◽  
Author(s):  
Francesco Briatico-Vangosa ◽  
Marta Rink ◽  
Francesco D'Oria ◽  
Alberto Verzelli

Sign in / Sign up

Export Citation Format

Share Document