About the Role of Hydrogen in Stress Corrosion Cracking of a 7xxx Aluminium Alloy (Al-Zn-Mg)
The effects of hydrogen during stress corrosion cracking mechanisms (SCC) have been highlighted for many years but hydrogen trapping mechanisms are not yet well understood for 7xxx aluminium alloys. The 7046-T4 Al-Zn-Mg alloy has been chosen for this study because its low corrosion susceptibility allows hydrogen embrittlement (HE) to be more easily distinguished during SCC tests. Tensile stress tests have been carried out at a strain rate of 10-3 s-1 on tensile samples after an exposure at their corrosion potential in a 0.6M chloride solution for 165 hours under an imposed loading of 80%Rp0.2. The results were compared to those obtained for samples pre-corroded without mechanical loading applied and healthy specimens. A loss of mechanical properties was observed for the pre-corroded samples and presumably attributed to the absorption, the diffusion and the trapping of hydrogen which affects a volume under the surface of the alloy and modifies its mechanical properties. Scanning electron microscope (SEM) observations highlighted a strong effect of hydrogen on fracture modes. The ductile-intergranular initial fracture mode observed on the healthy samples was partially replaced for the pre-corroded samples by a combination of two main fracture modes, i.e. brittle intergranular and cleavage, in relation with the nature of the hydrogen trapping sites and local stress state.