Low-Frequency Phase-sensitive Resistivity Measurements, Manitoba (62H,K) and Quebec (21E)

1970 ◽  
Author(s):  
W J Scott
2017 ◽  
Vol 110 (2) ◽  
pp. 021106 ◽  
Author(s):  
Fang Liu ◽  
Yaoyao Zhou ◽  
Juan Yu ◽  
Jiale Guo ◽  
Yang Wu ◽  
...  

Author(s):  
Joana F. Reis ◽  
Catarina N. Matias ◽  
Francesco Campa ◽  
José P. Morgado ◽  
Paulo Franco ◽  
...  

Background and aim: Monitoring bioelectric phase angle (PhA) provides important information on the health and the condition of the athlete. Together with the vector length, PhA constitutes the bioimpedance vector analysis (BIVA) patterns, and their joint interpretation exceeds the limits of the evaluation of the PhA alone. The present investigation aimed to monitor changes in the BIVA patterns during a training macrocycle in swimmers, trying to ascertain if these parameters are sensitive to training load changes across a 13-week training period. Methods: Twelve national and international level swimmers (four females; eight males; 20.9 ± 1.9 years; with a competitive swimming background of 11.3 ± 1.8 years; undertaking 16–20 h of pool training and 4–5 h of dry-land training per week and 822.0 ± 59.0 International Swimming Federation (FINA) points) were evaluated for resistance (R) and reactance (Xc) using a single frequency phase sensitive bioimpedance device at the beginning of the macrocycle (M1), just before the beginning of the taper period (M2), and just before the main competition of the macrocycle (M3). At the three-time assessment points, swimmers also performed a 50 m all-out first stroke sprint with track start (T50 m) while time was recorded. Results: The results of the Hotelling T2 test showed a significant vector displacement due to simultaneous R and Xc changes (p < 0.001), where shifting from top to bottom along the major axis of the R-Xc graph from M1 to M2 was observed. From M2 to M3, a vector displacement up and left along the minor axis of the tolerance ellipses resulted in an increase in PhA (p < 0.01). The results suggest a gain in fluid with a decrease in cellular density from M1 to M2 due to decrements in R and Xc. Nevertheless, the reduced training load characterizing taper seemed to allow for an increase in PhA and, most importantly, an increase of Xc, thus demonstrating improved cellular health and physical condition, which was concomitant with a significant increase in the T50 m performance (p < 0.01). Conclusions: PhA, obtained by bioelectrical R and Xc, can be useful in monitoring the condition of swimmers preparing for competition. Monitoring BIVA patterns allows for an ecological approach to the swimmers’ health and condition assessment without resorting to equations to predict the related body composition variables.


2011 ◽  
Vol 291-294 ◽  
pp. 1259-1262
Author(s):  
Nan Li ◽  
Yi Nan Wang ◽  
Hong Shan Nie ◽  
Hong Qi Yu ◽  
Hui Xu

This paper presents the design method of a novel biomaterial impedance analyzer based on digital auto balancing bridge method. The system hardware mainly consists of FPGA, ADC, DACs and operational amplifiers. Many DSP algorithms such as direct digital frequency synthesis (DDS), digital phase sensitive demodulation (DPSD), digital modulation and digital filter are implemented in FPGA to realize the auto balancing function of the bridge circuit. Simulation results show that the system has good performance from low frequency to 10MHz. It is suitable for EIS application in biomaterial analysis.


1993 ◽  
Vol 07 (12) ◽  
pp. 797-811
Author(s):  
S. HUNSCHE ◽  
H.J. BAKKER ◽  
H. KURZ

We present a time-resolved study of phonon-polaritons in the ferroelectric LiTaO 3 at room temperature. The coherent generation and phase-sensitive detection of polaritons, using femtosecond Laser pulses, allow precise determination of polariton frequencies and dephasing times. The experimental data clearly show a resonance at 0.95 THz that has not been found in previous IR and Raman studies. The simultaneous coherent excitation of polaritons in the upper and the lower dispersion branch associated with this resonance leads to the observation of phonon-polariton beats, A quantum-mechanical model of the lowest A 1 lattice vibration in LiTaO 3 is developed, which provides a quantitative description of the low-frequency dielectric response, including the polariton dispersion and dephasing. Within this model, the transition at 0.95 THz can be identified as a classically forbidden tunneling resonance.


Geophysics ◽  
1994 ◽  
Vol 59 (11) ◽  
pp. 1695-1712 ◽  
Author(s):  
Roger Guerin ◽  
Alain Tabbagh ◽  
Pierre Andrieux

The ratio of the horizontal electric and magnetic components of the electromagnetic field generated by a radio transmitter in the very low frequency (VLF) range is used in MT-VLF resistivity mapping to determine the apparent resistivity of the ground. A theoretical calculation of the responses of simple 2-D and 3-D prismatic bodies shows that the measurable lateral variations in both fields are independent, uncoupled, and correspond to frequency‐independent, static variations. It is advantageous therefore to process and map the fields separately. Processing methods used in gravimetry and magnetics are especially appropriate in correcting the apparent anisotropy related to the horizontal polarization of the primary field and in integrating (upward continuation) the high‐frequency spatial variations. The different processes tested on a synthetic case and on data obtained at the Centre de Recherches Géophysiques (CRG) test site showed how to eliminate shallow features and a current channeling conductor to favor the anomaly of a fault. A third example with a hydrogeological application shows the advantages of this method over Wenner direct‐current resistivity measurements.


Sign in / Sign up

Export Citation Format

Share Document