Electrical Signal-to-Noise Ratio  Enhancement in Detection of Mid-IR Signals by Four-Wave Mixing in As2S3-on-LiNbO3 Waveguides

The signal-to-noise ratio (SNR) is a major factor that limits the detection sensitivity of quartz-enhanced photoacoustic spectroscopy (QEPAS) sensors. The higher the electrical signal level compared to the noise amplitude is the lower the concentration of gases that can be detected. For this reason the preamplifier circuits used in QEPAS should be optimized for low-frequency narrow-band applications. Moreover, special care should be taken when choosing a particular operational amplifier in either a transimpedance or voltage (differential) configuration. It turns out that depending on the preamp topology different operational amplifier parameters should be carefully considered when a high SNR of the whole QEPAS system is required. In this article we analyzed the influence of the crucial parameters of low-noise operational preamplifiers used in QEPAS applications and show the resulting limitations of transimpedance and voltage configurations.

Download Full-text

Electrical signal-to-noise ratio improvement in indirect detection of mid-IR signals by wavelength conversion in silicon-on-sapphire waveguides

Applied Physics Letters ◽

10.1063/1.3651292 ◽

2011 ◽

Vol 99 (18) ◽

pp. 181122 ◽

Cited By ~ 17

Author(s):

Y. Huang ◽

E. K. Tien ◽

S. Gao ◽

S. K. Kalyoncu ◽

Q. Song ◽

...

Keyword(s):

Wavelength Conversion ◽

Signal To Noise Ratio ◽

Electrical Signal ◽

Indirect Detection ◽

Signal To Noise ◽

Noise Ratio

Download Full-text

Higher-Order Amplitude Squeezing in Six-Wave Mixing Process

International Journal of Optics ◽

10.1155/2011/629605 ◽

2011 ◽

Vol 2011 ◽

pp. 1-9 ◽

Cited By ~ 2

Author(s):

Sunil Rani ◽

Jawahar Lal ◽

Nafa Singh

Keyword(s):

Fundamental Mode ◽

Signal To Noise Ratio ◽

Photon Number ◽

Higher Order ◽

Field Amplitude ◽

Fourth Power ◽

Wave Mixing ◽

Mixing Process ◽

Signal To Noise ◽

Noise Ratio

We investigate theoretically the generation of squeezed states in spontaneous and stimulated six-wave mixing process quantum mechanically. It has been found that squeezing occurs in field amplitude, amplitude-squared, amplitude-cubed, and fourth power of field amplitude of fundamental mode in the process. It is found to be dependent on coupling parameter “g” (characteristics of higher-order susceptibility tensor) and phase values of the field amplitude under short-time approximation. Six-wave mixing is a process which involves absorption of three pump photons and emission of two probe photons of the same frequency and a signal photon of different frequency. It is shown that squeezing is greater in a stimulated interaction than the corresponding squeezing in spontaneous process. The degree of squeezing depends upon the photon number in first and higher orders of field amplitude. We study the statistical behaviour of quantum field in the fundamental mode and found it to be sub-Poissonian in nature. The signal-to-noise ratio has been studied in different orders. It is found that signal-to-noise ratio is higher in lower orders. This study when supplemented with experimental observations offers possibility of improving performance of many optical devices and optical communication networks.

Download Full-text

Determination of the Best Emulsion for the Microscopy of Crystals

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100096886 ◽

1981 ◽

Vol 39 ◽

pp. 32-33

Author(s):

David A. Grano ◽

Kenneth H. Downing

Keyword(s):

Spatial Frequency ◽

Information Transfer ◽

Signal To Noise Ratio ◽

Experimental Situation ◽

Photographic Emulsion ◽

Modulation Transfer ◽

Signal To Noise ◽

Frequency Space ◽

Noise Ratio

The retrieval of high-resolution information from images of biological crystals depends, in part, on the use of the correct photographic emulsion. We have been investigating the information transfer properties of twelve emulsions with a view toward 1) characterizing the emulsions by a few, measurable quantities, and 2) identifying the “best” emulsion of those we have studied for use in any given experimental situation. Because our interests lie in the examination of crystalline specimens, we've chosen to evaluate an emulsion's signal-to-noise ratio (SNR) as a function of spatial frequency and use this as our critereon for determining the best emulsion.The signal-to-noise ratio in frequency space depends on several factors. First, the signal depends on the speed of the emulsion and its modulation transfer function (MTF). By procedures outlined in, MTF's have been found for all the emulsions tested and can be fit by an analytic expression 1/(1+(S/S0)2). Figure 1 shows the experimental data and fitted curve for an emulsion with a better than average MTF. A single parameter, the spatial frequency at which the transfer falls to 50% (S0), characterizes this curve.

Download Full-text

Experiments in Bright-Field Imaging with Hollow-Cone Illumination

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100097703 ◽

1981 ◽

Vol 39 ◽

pp. 226-227

Author(s):

W. Kunath ◽

K. Weiss ◽

E. Zeitler

Keyword(s):

Signal To Noise Ratio ◽

Carbon Support ◽

Electronic System ◽

Optic Axis ◽

Hollow Cone ◽

Signal To Noise ◽

Bright Field ◽

Noise Ratio ◽

Single Field ◽

Field Imaging

Bright-field images taken with axial illumination show spurious high contrast patterns which obscure details smaller than 15 ° Hollow-cone illumination (HCI), however, reduces this disturbing granulation by statistical superposition and thus improves the signal-to-noise ratio. In this presentation we report on experiments aimed at selecting the proper amount of tilt and defocus for improvement of the signal-to-noise ratio by means of direct observation of the electron images on a TV monitor.Hollow-cone illumination is implemented in our microscope (single field condenser objective, Cs = .5 mm) by an electronic system which rotates the tilted beam about the optic axis. At low rates of revolution (one turn per second or so) a circular motion of the usual granulation in the image of a carbon support film can be observed on the TV monitor. The size of the granular structures and the radius of their orbits depend on both the conical tilt and defocus.

Download Full-text

Information capacity and bandwidth limitations in the SEM

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100152392 ◽

1989 ◽

Vol 47 ◽

pp. 84-85

Author(s):

D. C. Joy ◽

R. D. Bunn

Keyword(s):

Signal To Noise Ratio ◽

Critical Dimension ◽

Information Capacity ◽

Acquisition Time ◽

Signal To Noise ◽

Sem Image ◽

Probe Size ◽

Minimum Number ◽

Noise Ratio ◽

Signal Channel

The information available from an SEM image is limited both by the inherent signal to noise ratio that characterizes the image and as a result of the transformations that it may undergo as it is passed through the amplifying circuits of the instrument. In applications such as Critical Dimension Metrology it is necessary to be able to quantify these limitations in order to be able to assess the likely precision of any measurement made with the microscope.The information capacity of an SEM signal, defined as the minimum number of bits needed to encode the output signal, depends on the signal to noise ratio of the image - which in turn depends on the probe size and source brightness and acquisition time per pixel - and on the efficiency of the specimen in producing the signal that is being observed. A detailed analysis of the secondary electron case shows that the information capacity C (bits/pixel) of the SEM signal channel could be written as :

Download Full-text

Speech Reception in the Presence of Classroom Noise

Language Speech and Hearing Services in Schools ◽

10.1044/0161-1461.1004.221 ◽

1979 ◽

Vol 10 (4) ◽

pp. 221-230 ◽

Cited By ~ 2

Author(s):

Veronica Smyth

Keyword(s):

Signal To Noise Ratio ◽

Learning Processes ◽

Speech Discrimination ◽

Signal To Noise ◽

Speech Reception ◽

Monosyllabic Words ◽

Noise Ratio

Three hundred children from five to 12 years of age were required to discriminate simple, familiar, monosyllabic words under two conditions: 1) quiet, and 2) in the presence of background classroom noise. Of the sample, 45.3% made errors in speech discrimination in the presence of background classroom noise. The effect was most marked in children younger than seven years six months. The results are discussed considering the signal-to-noise ratio and the possible effects of unwanted classroom noise on learning processes.

Download Full-text