Experimental Investigation of Light-Medium Load Operating Sensitivity in a Gasoline Compression Ignition (GCI) Light-Duty Diesel Engine

2013 ◽  
Author(s):  
Paul Loeper ◽  
Youngchul Ra ◽  
Cory Adams ◽  
David E. Foster ◽  
Jaal Ghandhi ◽  
...  
Keyword(s):  
Experimental Investigation ◽  
Diesel Engine ◽  
Compression Ignition ◽  
Light Duty ◽  
Light Medium

An Experimental Investigation of Reactivity-Controlled Compression Ignition Combustion in a Single-Cylinder Diesel Engine Using Hydrous Ethanol

2014 ◽  
Vol 137 (3) ◽  
Author(s):  
Wei Fang ◽  
Junhua Fang ◽  
David B. Kittelson ◽  
William F. Northrop
Keyword(s):  
Experimental Investigation ◽  
Diesel Engine ◽  
Thermal Efficiency ◽  
Alternative Fuels ◽  
Compression Ignition ◽  
Reactivity Controlled Compression Ignition ◽  
Single Cylinder ◽  
Diesel Injection ◽  
Soot Emissions ◽  
Hydrous Ethanol

Dual-fuel reactivity-controlled compression ignition (RCCI) combustion using port injection of a less reactive fuel and early-cycle direct injection (DI) of a more reactive fuel has been shown to yield both high thermal efficiency and low NOX and soot emissions over a wide engine operating range. Conventional and alternative fuels such as gasoline, natural gas, and E85 as the lower reactivity fuel in RCCI have been studied by many researchers; however, published experimental investigations of hydrous ethanol use in RCCI are scarce. Making greater use of hydrous ethanol in internal combustion engines has the potential to dramatically improve the economics and life cycle carbon dioxide emissions of using bioethanol. In this work, an experimental investigation was conducted using 150 proof hydrous ethanol as the low reactivity fuel and commercially available diesel as the high reactivity fuel in an RCCI combustion mode at various load conditions. A modified single-cylinder diesel engine was used for the experiments. Based on previous studies on RCCI combustion by other researchers, early-cycle split-injection strategy of diesel fuel was used to create an in-cylinder fuel reactivity distribution to maintain high thermal efficiency and low NOX and soot emissions. At each load condition, timing and mass fraction of the first diesel injection was held constant, while timing of the second diesel injection was swept over a range where stable combustion could be maintained. Since hydrous ethanol is highly resistant to auto-ignition and has large heat of vaporization, intake air heating was needed to obtain stable operations of the engine. The study shows that 150 proof hydrous ethanol can be used as the low reactivity fuel in RCCI through 8.6 bar indicated mean effective pressure (IMEP) and with ethanol energy fraction up to 75% while achieving simultaneously low levels of NOX and soot emissions. With increasing engine load, less intake heating is needed and exhaust gas recirculation (EGR) is required to maintain low NOX emissions.

scholarly journals Effect of Preheating Temperature and Fuel Properties on Combustion and Emission Characteristics of Homogeneous Charge Compression Ignition (HCCI) Engine

2021 ◽  
Vol 9 (5) ◽  
pp. 558-564
Keyword(s):  
Experimental Investigation ◽  
Diesel Engine ◽  
Air Temperature ◽  
Homogeneous Charge Compression Ignition ◽  
Fuel Properties ◽  
Emission Characteristics ◽  
Compression Ignition ◽  
Hcci Engine ◽  
Di Diesel Engine ◽  
Homogeneous Charge

The homogeneous charge compression ignition (HCCI) engine is the promising technology to reduce the pollutants without affecting its performance and it is also proved by the many studies. This study investigates the performance and emission characteristics of HCCI engine fuelled with diesel –waste cooking oil (WCO) blends and also analysed the effect of air temperature and fuel properties on HCCI engine combustion. The experimental investigation was conducted with single cylinder DI diesel engine and it was slightly modified to port injection system for premixing the charge. The electric air heater was adopted in suction pipe to preheat the inlet air. The experimental investigation conducted in two phases, in the first phase the conventional DI diesel engine was tested with different fuel blends such as B25, B50, B75 and B100 and notes the readings. In the next phase, HCCI engine was operated with same blend ratios. During the experimentation on HCCI engine, the suction air temperature was varied between 40⁰C to 90⁰C. From the experimental results, it was found that the HCCI engine has emitted low NOx and smoke emissions at 80⁰C of air temperature for all the blends. Whereas the HCCI engine emitted more carbon monoxide (CO) and hydrocarbon (HC) emissions due to lean mixture causes misfiring in the chamber. In addition, it is also noted that the value of CO and HC has been varied with diesel –WCO blends. The specific fuel consumption (SFC) is increased for diesel and biodiesel fuel in HCCI engine compared to compression ignition (CI) engine

Operating strategy for gasoline/diesel dual-fuel premixed compression ignition in a light-duty diesel engine

2017 ◽  
Vol 18 (6) ◽  
pp. 943-950 ◽  
Author(s):  
Jeongwoo Lee ◽  
Sanghyun Chu ◽  
Jaegu Kang ◽  
Kyoungdoug Min ◽  
Hyunsung Jung ◽  
...  
Keyword(s):  
Diesel Engine ◽  
Dual Fuel ◽  
Compression Ignition ◽  
Operating Strategy ◽  
Light Duty

An Experimental Investigation of Reactivity-Controlled Compression Ignition Combustion in a Single-Cylinder Diesel Engine Using Hydrous Ethanol

2013 ◽  
Author(s):  
Wei Fang ◽  
David B. Kittelson ◽  
William F. Northrop ◽  
Junhua Fang
Keyword(s):  
Experimental Investigation ◽  
Diesel Engine ◽  
Thermal Efficiency ◽  
Compression Ignition ◽  
Reactivity Controlled Compression Ignition ◽  
Engine Load ◽  
Single Cylinder ◽  
Diesel Injection ◽  
Soot Emissions ◽  
Hydrous Ethanol

Dual-fuel reactivity-controlled compression ignition (RCCI) combustion using port injection of a less reactive fuel and early-cycle direct injection of a more reactive fuel has been shown to yield both high thermal efficiency and low NOX and soot emissions over a wide engine operating range. Conventional and alternative fuels such as gasoline, natural gas and E85 as the lower reactivity fuel in RCCI have been studied by many researchers; however, published experimental investigations of hydrous ethanol use in RCCI are scarce. Making greater use of hydrous ethanol in internal combustion engines has the potential to dramatically improve the economics and life cycle carbon dioxide emissions of using bio-ethanol. In this work, an experimental investigation was conducted using 150 proof hydrous ethanol as the low reactivity fuel and commercially-available diesel as the high reactivity fuel in an RCCI combustion mode at various load conditions. A modified single-cylinder diesel engine was used for the experiments. Based on previous studies on RCCI combustion by other researchers, early-cycle split-injection strategy of diesel fuel was used to create an in-cylinder fuel reactivity distribution to maintain high thermal efficiency and low NOX and soot emissions. At each load condition, timing and mass fraction of the first diesel injection was held constant, while timing of the second diesel injection was swept over a range where stable combustion could be maintained. Since hydrous ethanol is highly resistant to auto-ignition and has large heat of vaporization, intake air heating was needed to obtain stable operations of the engine. The study shows that 150 proof hydrous ethanol can be used as the low reactivity fuel in RCCI through 8.6 bar IMEP and with ethanol energy fraction up to 75% while achieving simultaneously low levels of NOX and soot emissions. With increasing engine load, less intake heating is needed and EGR is required to maintain low NOX emissions. Future work will look at stability of hydrous ethanol RCCI at higher engine load.

Sign in / Sign up

Export Citation Format

Share Document