scholarly journals Purification of Plasmodium and Babesia- infected erythrocytes using a non-woven fabric filter

2020 ◽  
Vol 37 (4) ◽  
pp. 911-918
Keyword(s):  
2011 ◽  
Vol 10 (1) ◽  
pp. 251 ◽  
Author(s):  
Zhi-Yong Tao ◽  
Hui Xia ◽  
Jun Cao ◽  
Qi Gao

2007 ◽  
Vol 55 (1-2) ◽  
pp. 51-58 ◽  
Author(s):  
G.T. Seo ◽  
B.H. Moon ◽  
Y.M. Park ◽  
S.H. Kim

The filtration characteristics of two different module configurations with coarse pore filter (non-woven fabric) were investigated for sludge floc separation in an activated sludge reactor for domestic wastewater reclamation. A polypropylene non-woven fabric filter (35 g/m2) was used for the two different module configurations, one flat and one tubular type, each with a filtration area of 0.052 m2. The different module types, submerged in the oxic compartment of A/O (anaerobic/oxic) type reactors, were operated simultaneously. The filtration fluxes were gradually increased from 0.5 to 1.2 and 1.73 m/d. The filtration pressures were more stably maintained for the tubular type module than the plate type. The tubular type module installed horizontally with two-side suction showed less filtration pressures than the tubular type module installed vertically with one-side suction. The solid separation was significantly high showing less than 5 mg/L effluent solids. The organic and T-N removal efficiencies were around 95 and 50%, respectively. The 85% removal of T-P was achieved with 20 mg/L injection of PAC (poly-aluminum chloride).


2009 ◽  
Vol 42 (4) ◽  
pp. 248-254
Author(s):  
Tatsuhiro Oshita ◽  
Kazuho Nakamura ◽  
Takuya Kosaka ◽  
Yoshie Marutani ◽  
Kanji Matsumoto

2012 ◽  
Vol 35 (8) ◽  
pp. 1389-1398 ◽  
Author(s):  
Jung-Yeol Lee ◽  
Bo-Kyung Choi ◽  
Kyu-Hong Ahn ◽  
Sung Kyu Maeng ◽  
Kyung-Guen Song

2012 ◽  
Vol 57 (3) ◽  
pp. 1-13 ◽  
Author(s):  
Nicholas Bojdo ◽  
Antonio Filippone

An inlet barrier filter system is integrated into the intake of a helicopter to perform the task of removing potentially harmful particles from engine-bound air. While performing a vital duty in the prolonging of engine life, their use may incur a loss of engine performance as a result of the pressure loss that is synonymous with air passing through a porous barrier. Furthermore, as particles collect on the filter they pose additional restriction to the flow of air, causing the pressure drop to increase over time. It is the objective of the present work to propose a low-order model to predict this transient pressure loss, in order that the performance of helicopters operating with inlet barrier filters may be analyzed. The contribution includes a model to predict the temporal separation efficiency of a woven fabric filter and the temporal change in pressure drop due to the buildup of particles on the filter.


2011 ◽  
Vol 21 (6) ◽  
pp. 837-844 ◽  
Author(s):  
Seon-Hong Kim ◽  
Ki-Hoon Lee ◽  
Do-Hyeon Kim ◽  
Jong-Pill Park ◽  
Ji-Hoon Kim ◽  
...  

The purpose of this study was to assess the removal efficiency of formaldehyde using nano-size carbon colloid (NCC), which was produced by a comparatively easy and cheap method. In this study, nano-size carbon colloid based on water was produced by an electro-chemical method. The particles which have mostly a spherical shape with a diameter of, what is called, “nano-size” were produced. Non-woven fabric filter, which is currently on the market as a medium filter, was used for the removal efficiency test. Known concentration (0.5 ppm) of formaldehyde standard gas was used as a pollutant. The overall results indicate that: (1) nano-size carbon colloid which has a stable dispersibility, and of which diameter is approximately 10 nm or less was produced; (2) filters treated with nano-size carbon colloids showed a higher removal efficiency, 44.47 µg of HCHO removed/g of carbon and 19.28 µg of HCHO removed/g of carbon when compared to the control experiment using a normal carbon filter. The normal carbon filter system could only achieve 1.45 µg of HCHO removed/g of carbon.


2018 ◽  
Vol 48 (10) ◽  
pp. 1566-1579 ◽  
Author(s):  
G Thilagavathi ◽  
N Muthukumar ◽  
S Neelakrishnan ◽  
R Santhosh Egappan

This paper reports the development of nonwoven fabric by needle-punching technique for filter press application in textile effluent treatment plant. For filter press development, the nonwoven fabric was reinforced with the nylon scrim as the central layer in order to withstand the filtration pressure. The nonwoven fabrics were developed using different denier polyester fibres and changing punch density. The influence of fibre fineness and punch density on the properties of nonwovens was investigated. The filtration parameters such as filtration efficiency, dewatering efficiency, blinding tendency and cake discharge properties of the developed nonwoven filter fabrics filter fabrics were evaluated and compared with existing woven fabric filter media. The influence of calendering on the filtration properties of the nonwovens was also studied. The results showed that bursting strength of the developed nonwovens increased with increase in fibre fineness and decrease in punch density. It was also found that the air permeability of the developed nonwovens varied inversely in relation to punch density and the proportion of fine fibres. It was observed that developed nonwovens had 8% higher filtration efficiency and 6% higher dewatering efficiency compared to the existing woven fabric filter media. The blinding resistance and cake discharge properties were slightly lower than that of woven fabric filter. It was found that calendering improves filtration properties of the developed nonwoven fabrics.


2005 ◽  
Vol 10 (5) ◽  
pp. 247-256 ◽  
Author(s):  
Yoo-Jin Jung ◽  
Hyun-Woong Koh ◽  
Won-Tae Shin ◽  
Nak-Chang Sung

2007 ◽  
Vol 55 (7) ◽  
pp. 79-86 ◽  
Author(s):  
J.H. Ho ◽  
S.K. Khanal ◽  
S. Sung

Non-woven fabric filter and poly-tetrafluoroethylene (PTFE) composite membrane were investigated to determine their applicability to treat low strength wastewater in an anaerobic membrane bioreactor (AMBR). Sludge cake resistance of the membrane was quantified using pure water flux of anaerobic sludge cake accumulated on the glass fiber filter of similar pore size. It is hypothesized that the formation of thin cake layer on the porous medium, e.g. non-woven and PTFE acts as a dynamic membrane. Thus, the capture of thin sludge cake inside the non-woven fabric matrix and accumulation on the PTFE membrane surface forms a membrane system equivalent to a commercial membrane system. The permeate quality was found to improve as the cake became more dense with filtration time. The PTFE composite membrane coated with thin PTFE film on the non-woven fabric filter enhanced the filtration performance by improving flux and minimizing the propensity of bio-fouling. The membrane flux was restored by back-flushing with permeate. The AMBR coupled with PTFE laminated membrane was operated continuously during the experiment at a cross flow velocity (CFV) of 0.1–0.2 m/sec and a transmembrane pressure (TMP) of 0.5–3 psi. Although about a month of acclimation was required to reach steady state, the effluent chemical oxygen demand (COD), volatile fatty acids (VFAs) as acetic acid, and suspended solids (SS) concentrations were below 30, 20 and 10 mg/L, respectively, during 90 days of operation with intermittent back washing. The lower operation TMP and CFV were subjected to less shear stress on the microbial community during continuous AMBR operation. In addition, thin sludge film accumulated on the membrane surface also acted as a biofilm bioreactor to remove additional COD in this study


Author(s):  
Gabriele Spohn ◽  
Anne-Sophie Witte ◽  
Anja Kretschmer ◽  
Erhard Seifried ◽  
Richard Schäfer

BackgroundMesenchymal stromal cells (MSCs), multipotent progenitors that can be isolated from a variety of different tissues, are becoming increasingly important as cell therapeutics targeting immunopathologies and tissue regeneration. Current protocols for MSC isolation from bone marrow (BM) rely on density gradient centrifugation (DGC), and the production of sufficient MSC doses is a critical factor for conducting clinical MSC trials. Previously, a Good Manufacturing Practice (GMP)–compatible non-woven fabric filter device system to isolate MSCs was developed to increase the MSC yield from the BM. The aim of our study was to compare high-resolution phenotypic and functional characteristics of BM-MSCs isolated with this device and with standard DGC technology.MethodsHuman BM samples from 5 donors were analyzed. Each sample was divided equally, processing by DGC, and with the filter device. Stem cell content was assessed by quantification of colony-forming units fibroblasts (CFU-F). Immunophenotype was analyzed by multicolor flow cytometry. In vitro trilineage differentiation potential, trophic factors, and IDO-1 production were assessed. Functionally, immunomodulatory potential, wound healing, and angiogenesis were assayed in vitro.ResultsThe CFU-F yield was 15-fold higher in the MSC preparations isolated with the device compared to those isolated by DGC. Consequently, the MSC yield that could be manufactured at passage 3 per mL collected BM was more than 10 times higher in the device group compared to DGC (1.65 × 109 vs. 1.45 × 108). The immunomodulatory potential and IDO-1 production showed donor-to-donor variabilities without differences between fabric filter-isolated and DGC-isolated MSCs. The results from the wound closure assays, the tube formation assays, and the trilineage differentiation assays were similar between the groups with respect to the isolation method. Sixty-four MSC subpopulations could be quantified with CD140a+CD119+CD146+ as most common phenotype group, and CD140a+CD119+CD146+MSCA-1–CD106–CD271– and CD140a+CD119+CD146–MSCA-1–CD106–CD271– as most frequent MSC subpopulations. As trophic factors hepatocyte growth factor, epidermal growth factor, brain-derived neurotrophic factor, angiopoietin-1, and vascular endothelial growth factor A could be detected in both groups with considerable variability between donors, but independent of the respective MSC isolation technique.ConclusionThe isolation of MSCs using a GMP-compatible fabric filter system device resulted in higher yield of CFU-F, producing substantially more MSCs with similar subpopulation composition and functional characteristics as MSCs isolated by DGC.


Sign in / Sign up

Export Citation Format

Share Document