scholarly journals Failure mode of rainfall-induced landslide of granite residual soil, southeastern Guangxi province, China

2021 ◽  
Author(s):  
Shanbai Wu ◽  
Ruihua Zhao ◽  
Liping Liao ◽  
Yunchuan Yang ◽  
Yao Wei ◽  
...  
Keyword(s):  
Failure Mode ◽  
Pore Water ◽  
Surface Runoff ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Failure Process ◽  
Dry Density ◽  
Residual Soil ◽  
Guangxi Province ◽  
Granite Residual Soil

Abstract. Granite residual soil landslides are widely distributed in southeastern Guangxi province, China. They are posing a huge threat to local communities and hindering social and economic development. To understand the failure mode of the landslide can provide a scientific basis for early warning and prevention. In this study, it conducted artificial flume model tests to investigate the failure mode of granite residual soil landslide. The macroscopic phenomena of landslides in the flume were summarized. The changes of soil moisture content along with pore water pressure were analyzed. And the differences and commonness in the initiation patterns of landslides were discussed. The results had four aspects. (1) There were significant similarities in the phenomenon of slope failures. In the beginning of the artificial rain, slopes were infiltrated, following by the slope toe soil softened and slipped. Another similar pattern was that continuous rainfall could cause soil crusts and runoff on the slope surface. Short-term low-lying areas and interlocking ditches would appear due to surface runoff and rainwater erosion. (2) The increase of initial dry density enhanced the permeability resistance of rainwater to the residual soil, which led to a delay in the response time of water content and pore water pressure, and a decrease in pore water pressure. Moreover, the fluctuation characteristics of pore water pressure may be related to the type of soil shear deformation. (3) The starting time of a landslide was delayed as the initial dry density and slope angle increased, but it was shortened due to the increase in rainfall intensity. Meanwhile, the initiation pattern changed from a sudden sliding type to a progressive failure type due to the increase of initial dry density. (4) The failure process of the granite residual soil landslide could be classified into five stages: rainwater infiltration, soil sliding at the slope toe, the occurrence of surface runoff and erosion, the formation of a steep free face, and the upper soil sliding. Above research results can provide valuable references for the prevention and warning of granite residual soil landslide in southeast Guangxi.

Infiltration characteristics of two instrumented residual soil slopes

2003 ◽  
Vol 40 (5) ◽  
pp. 1012-1032 ◽  
Author(s):  
Illias Tsaparas ◽  
Harianto Rahardjo ◽  
David G Toll ◽  
Eng-Choon Leong
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Field Measurements ◽  
Residual Soil ◽  
Rainfall Runoff ◽  
Rainfall Events ◽  
Pore Water Pressures ◽  
Soil Slopes ◽  
Pressure Changes

This paper presents the analysis of a 12 month long field study of the infiltration characteristics of two residual soil slopes in Singapore. The field measurements consist of rainfall data, runoff data of natural and simulated rainfall events, and pore-water pressure changes during infiltration at several depths and at several locations on the two slopes. The analysis of the field measurements identifies the total rainfall and the initial pore-water pressures within the two slopes as the controlling parameters for the changes in the pore-water pressures within the slopes during infiltration.Key words: infiltration, rainfall, runoff, pore-water pressure, field measurements.

Aspects of the behaviour of compacted clayey soils on drying and wetting paths

2002 ◽  
Vol 39 (6) ◽  
pp. 1341-1357 ◽  
Author(s):  
Jean-Marie Fleureau ◽  
Jean-Claude Verbrugge ◽  
Pedro J Huergo ◽  
António Gomes Correia ◽  
Siba Kheirbek-Saoud
Keyword(s):  
Water Content ◽  
Pore Water ◽  
Unsaturated Soils ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Dry Density ◽  
Clayey Soils ◽  
Maximum Dry Density ◽  
Optimum Water Content ◽  
Optimum Water

A relatively large number of drying and wetting tests have been performed on clayey soils compacted at the standard or modified Proctor optimum water content and maximum density and compared with tests on normally consolidated or overconsolidated soils. The results show that drying and wetting paths on compacted soils are fairly linear and reversible in the void ratio or water content versus negative pore-water pressure planes. On the wet side of the optimum, the wetting paths are independent of the compaction water content and can be approached by compaction tests with measurement of the negative pore-water pressure. Correlations have been established between the liquid limit of the soils and such properties as the optimum water content and negative pore-water pressure, the maximum dry density, and the swelling or drying index. Although based on a limited number of tests, these correlations provide a fairly good basis to model the drying–wetting paths when all the necessary data are not available.Key words: compaction, unsaturated soils, clays, drying, wetting, Proctor conditions.

scholarly journals Swelling phenomena and effective stress in compacted expansive clays

2016 ◽  
Vol 53 (1) ◽  
pp. 134-147 ◽  
Author(s):  
David Mašín ◽  
Nasser Khalili
Keyword(s):  
Pore Water ◽  
Effective Stress ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Swelling Pressure ◽  
Constitutive Modelling ◽  
Dry Density ◽  
Expansive Clay ◽  
Experimental Database ◽  
Clay Aggregates

The central aim of this paper is to discuss the applicability of the effective stress principle as defined by Terzaghi (total stress minus pore-water pressure) to predict the behaviour of expansive clay aggregates. Phenomena occurring between individual clay minerals are reviewed first at the molecular level obtained in the colloid science research. In particular, it is noted that, for interparticle distances higher than approximately 1.5 nm, the pore-water pressure in the bulk equilibrium solution forms an additive component of the interparticle disjoining pressure. It is concluded that for these distances Terzaghi’s effective stress principle should be adequate to describe the clay behaviour. To support these developments, an extensive experimental database of nine different sodium and calcium bentonites available in the published literature was analysed. With the aid of double structure constitutive modelling, procedures were developed to extract information about the behaviour of clay aggregates from the experimental measurements. It was then shown that unconfined water retention curves, swelling pressure tests, swelling under constant load tests, and mechanical unloading tests are all uniquely related in terms of the dependency of dry density (or void ratio) of clay aggregate versus mean effective stress. By considering reversibility of aggregate behaviour and full saturation of aggregates, this implies that the effective stress principle is a valid way of predicting expansive clay aggregate volumetric deformation.

scholarly journals Study on the Variation Rule and Characteristics of Pore Water Pressure in the Failure Process of Saturated Rock

2021 ◽  
Vol 2021 ◽  
pp. 1-9
Author(s):  
Yuezheng Zhang
Keyword(s):  
Rock Mass ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Failure Process ◽  
Engineering Practice ◽  
Surrounding Area ◽  
Saturated Rock ◽  
In Situ Conditions ◽  
Variation Rule

With the development of tunnels and other engineering constructions into the deep strata, rock masses are more prone to dynamic damage such as rock bursts under in situ conditions and excavation disturbances. The pore water in the rock mass will produce pressure changes during this process. According to the relationship between the change of pore water pressure and the development of rock mass damage, the variation rule and precursor characteristics of pore water pressure in the process of rock mass failure can be found. In this paper, through mechanical analysis, the evolution law of pore water pressure during the failure process of saturated rock is obtained. The study found that, in the process of rock failure, the pore water pressure presents three stages of linear growth, transition, and decrease. The rise and fall of pore water pressure are closely related to rock damage and influence each other. Through the observation of pore water pressure during coal mining, it is found that the coseismic effect of pore water pressure is significant. It is proved that there is a close correlation between the evolution of the stress field in the surrounding area of the stope and the change of pore water pressure in the surrounding area under the effect of mining disturbance. During the engineering practice, dynamic monitoring can be carried out on the change of pore water pressure inside the rock mass according to the law, and the precursor information of rock mass instability and failure can be explored.

Sign in / Sign up

Export Citation Format

Share Document