Influence of Crosslink Characteristics Induced by Aromatic-Based Antioxidants on the Swelling and Stress-Strain Behavior of Natural Rubber Vulcanizates

2003 ◽  
Vol 76 (2) ◽  
pp. 334-347 ◽  
Author(s):  
Tarek M. Madkour ◽  
Rasha A. Azzam

Abstract Stress-strain measurements were performed on dry and swollen natural rubber vulcanizates prepared using both sulfur as the crosslinking agent and aromatic-based bound antioxidants acting as a second crosslinking agent. The aromatic-based antioxidants were synthesized and analyzed spectroscopically in order to relate the final behavior of the vulcanizates to the nature of the crosslink characteristics. The anomalous upturn in the modulus values of these networks in response to the imposed stress was shown to persist in the dry as well as the swollen state. Since the swollen elastomeric chains cannot undergo a strain-induced crystallization, the abnormal upturns in the modulus values in an absence of a filler were explained on the basis of the limited extensibility of the short chains of networks prepared using two different crosslinking agents in line with earlier modeling predictions. Remarkably, the swelling experiments revealed the increase in the crosslink density of the networks in the early stages of the thermal oxidative degradation procedure indicating a post-cure of the chemically bound antioxidants to the elastomeric chains, which incidentally corresponds to a maximum in the modulus values of the networks. The rheological and other mechanical properties such as the hardness were shown not to have been affected as a result of the incorporation of the chemically bound antioxidants.

1974 ◽  
Vol 47 (5) ◽  
pp. 1234-1240 ◽  
Author(s):  
D. P. Mukherjee

Abstract With respect to stress-birefringence, isomerized natural rubber behaves the same as natural rubber at low elongations, but at high elongation levels the natural rubber sample exhibits higher stress-hysteresis accompanied by higher mechanical loss energy. Therefore, it appears that at low elongation level the viscoelastic rate process governing the stress-strain hysteresis is not sensitive to structural imperfection (within the range of cis-1,4 content studied here), but the crystallization process at higher elongation is strongly dependent on the cis content. This is in agreement with the conclusion made by Scott and co-workers from their dynamic measurements on synthetic poly(isoprene)s. The difference in cis-content between Natsyn and natural rubber and the effect on crystallizability explains the lower hysteresis on the stress-birefringence plot for Natsyn. Similar reasoning explains the stress-birefringence difference between the A.C. rubber and Natsyn. The data, however, shows that Natsyn has the lowest amount of loss energy of the three samples (except at very high input energy >4.5). This difference might be due to effects of physical entanglements or gels which may differ. In addition, the difference in microstructure contributes to the difference in extent of strain-induced crystallization. Since the viscoelastic rate process governing the stress-strain behavior and the strain-induced crystallization are associated with molecular motion, they may not be independent.


2017 ◽  
Vol 90 (4) ◽  
pp. 728-742 ◽  
Author(s):  
Watcharin Sainumsai ◽  
Shigeyuki Toki ◽  
Sureerut Amnuaypornsri ◽  
Adun Nimpaiboon ◽  
Jitladda Sakdapipanich ◽  
...  

ABSTRACT Strain-induced crystallization (SIC) and stress–strain relations of varied crosslink structures and varied crosslink densities of vulcanized natural rubber (NR), vulcanized synthetic polyisoprene rubber (IR), and un-vulcanized natural rubber are compared using a synchrotron X-ray. The onset strain of SIC does not depend on crosslink density and crosslink structures. Un-vulcanized NR shows a smaller onset strain of SIC than that of vulcanized NR. Therefore, entanglements in NR are pivot points to induce SIC, just as entanglements in semi-crystalline plastics induce flow-induced crystallization (FIC). During deformation, complicated phenomena occur simultaneously such as cavitation, crosslink breakdown, SIC with temperature upturn, and limited extensibility of chains between crosslinks, because rubber is a significantly inhomogeneous material. It is still difficult to evaluate the contribution of SIC to stress-upturn of the stress–strain relation of rubber.


RSC Advances ◽  
2015 ◽  
Vol 5 (15) ◽  
pp. 11317-11324 ◽  
Author(s):  
Yueqing Ren ◽  
Suhe Zhao ◽  
Qian Yao ◽  
Qianqian Li ◽  
Xingying Zhang ◽  
...  

Effects of different type of plasticizers on the strain-induced crystallization and stress–strain curves of crystallizable rubber.


2013 ◽  
Vol 46 (13) ◽  
pp. 5238-5248 ◽  
Author(s):  
Shigeyuki Toki ◽  
Justin Che ◽  
Lixia Rong ◽  
Benjamin S. Hsiao ◽  
Sureerut Amnuaypornsri ◽  
...  

2005 ◽  
Vol 97 (10) ◽  
pp. 103529 ◽  
Author(s):  
Sirilux Poompradub ◽  
Masatoshi Tosaka ◽  
Shinzo Kohjiya ◽  
Yuko Ikeda ◽  
Shigeyuki Toki ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document