scholarly journals Preliminary determination of the energy potential of ocean currents along the southern coast of Brazil

2013 ◽  
Vol 4 (5) ◽  
pp. 879-894
Author(s):  
Andrea Fischer ◽  
Alexandre Beluco ◽  
Luiz Emílio B. de Almeida
2014 ◽  
Vol 10 (1) ◽  
pp. 38-45
Author(s):  
Angel Terziev ◽  
Ivan Antonov ◽  
Rositsa Velichkova

Abstract Increasing the share of renewable energy sources is one of the core policies of the European Union. This is because of the fact that this energy is essential in reducing the greenhouse gas emissions and securing energy supplies. Currently, the share of wind energy from all renewable energy sources is relatively low. The choice of location for a certain wind farm installation strongly depends on the wind potential. Therefore the accurate assessment of wind potential is extremely important. In the present paper an analysis is made on the impact of significant possible parameters on the determination of wind energy potential for relatively large areas. In the analysis the type of measurements (short- and long-term on-site measurements), the type of instrumentation and the terrain roughness factor are considered. The study on the impact of turbulence on the wind flow distribution over complex terrain is presented, and it is based on the real on-site data collected by the meteorological tall towers installed in the northern part of Bulgaria. By means of CFD based software a wind map is developed for relatively large areas. Different turbulent models in numerical calculations were tested and recommendations for the usage of the specific models in flows modeling over complex terrains are presented. The role of each parameter in wind map development is made. Different approaches for determination of wind energy potential based on the preliminary developed wind map are presented.


Author(s):  
Maciej Mazurkiewicz ◽  
Ewelina Tkaczewska ◽  
Radosław Pomykała ◽  
Alicja Uliasz-Bocheńczyk

Streszczenie Wymagania dotyczące ochrony środowiska, takie jak: ograniczenie emisji CO2, NOx i SO2 spowodowały coraz większe zainteresowanie nowymi technologiami energetycznego wykorzystania węgla. Jednąz testowanych i promowanych obecnie technologii jest zgazowanie węgla. Jednak, jak każda technologia produkcji energii wykorzystująca węgiel, powoduje ona powstawanie odpadów: popiołów lotnych i żużli. Ze względu na niewielką ilość instalacji zgazowania węgla funkcjonujących obecnie w świecie, odpady te sąwniewielkim stopniupoznane, dlatego też przed podjęciem decyzji o wprowadzaniu technologii zgazowania węgla, powinno się opracować technologię utylizacji powstających w niej odpadów. Najlepszym rozwiązaniem będzie oczywiście opraco­wanie kierunku ich gospodarczego wykorzystania. Jedną z możliwości rozpatrywanych dla gospodarczego wykorzystania żużli ze zgazowania jest zastosowanie ich jako składnika spoiw mineralnych o charakterze pucolanowym. W artykule przedstawiono wyniki badań aktywności pucolanowej dwóch żużli: żużla ze zgazowania węgla z instalacji energetycznego zgazowania oraz podziemnego zgazowania. Ze względu na skład chemiczny żużel MI można zaklasyfikować jako żużel zasadowy o składzie chemicznym zbliżonym do krzemionkowego po­piołu lotnego ze spalania węgla kamiennego. Z kolei żużel BA, z powodu czteroktrotnie wyższej zawartości tlenku wapnia, należy do grupy żużli słabozasadowych. Podstawowym i jedynym składnikiem mineralnym żużla MI jest faza szklista. W żużlu BA, obok fazy szklistej, tworzą się również fazy krystaliczne, a mianowicie: mullit 3 AI2O3 · 2 SiO2, kwarc p-SiO2-, anortyt Ca(Al2Si2O8), gehlenit Ca2Al[(Si,Al)2O7], wollastonit Ca3[Si3O9], 2CaO · SiO2 i 4 CaO • Al2O3 • Fe2O3. W wyniku badań stwierdzono, że żużel BA wykazuje większe wartości wskaźnika aktywności pucolanowej (75,1% po 90 dniach) od żużla MI (69,9% po 90 dniach). Niestety, wstępne badania pozwalają stwierdzić, że żużle te charakteryzują się zbyt niską aktywnością pucolanową i nie mogą być traktowane jako materiał pucolanowy w technologii produkcji cementu i betonu.


Author(s):  
Augusto César de Mendonça Brasil

This chapter presents in a consolidated manner the step-by-step methodology to estimate the electrical energy potential of industrial wood residues considering the dependency of the efficiency of the power plants with their size. A function of the overall efficiency with power was obtained from a best curve fit of real data both taken from the literature and from Brazilian biomass-fired power plants. The methodology was applied to the determination of the electrical energy potential of wood industry residues in the State of Pará (data collected in 2004). Two cases were analyzed: one where a constant electrical efficiency of 25% was considered (independently of the amount of residues generated) and another where the proposed function of efficiency with power was used. Results show that in the State of Pará, the existent 675 sawmills generated 2.95 × 106 t in dry basis. When the dependency of efficiency with plant size is not considered, the electrical energy potential and average installed power (3140.4 GWh and 2 MWe) are overestimated in comparison to the herein proposed methodology (1868.8 GWh and 1 MWe). The present methodology, considering the efficiency as a function of the power, results in an average efficiency of 12.3% (lower than 25%).


Sign in / Sign up

Export Citation Format

Share Document