Recent Progress in Drug Release Testing Methods of Biopolymeric Particulate System

Biopolymeric microparticles have been widely used for long-term release formulations of short half-life chemicals or synthetic peptides. Characterization of the drug release from microparticles is important to ensure product quality and desired pharmacological effect. However, there is no official method for long-term release parenteral dosage forms. Much work has been done to develop methods for in vitro drug release testing, generally grouped into three major categories: sample and separate, dialysis membrane, and continuous flow (flow-through cell) methods. In vitro drug release testing also plays an important role in providing insight into the in vivo performance of a product. In vitro release test with in vivo relevance can reduce the cost of conducting in vivo studies and accelerate drug product development. Therefore, investigation of the in vitro–in vivo correlation (IVIVC) is increasingly becoming an essential part of particulate formulation development. This review summarizes the principles of the in vitro release testing methods of biopolymeric particulate system with the recent research articles and discusses their characteristics including IVIVC, accelerated release testing methods, and stability of encapsulated drugs.

Dewatering Behavior of a Wood-Cellulose Nanofibril Particulate System

The novel use of aqueous suspensions of cellulose nanofibrils (CNF) as an adhesive/binder in lignocellulosic-based composite manufacture requires the removal of a considerable amount of water from the furnish during processing, necessitating thorough understanding of the dewatering behavior referred to as “contact dewatering”. The dewatering behavior of a wood-CNF particulate system (wet furnish) was studied through pressure filtration tests, centrifugation, and characterization of hard-to-remove (HR) water, i.e. moisture content in the wet furnish at the transition between constant rate part and the falling rate part of evaporative change in mass from an isothermal thermogravimetric analysis (TGA). The effect of wood particle size thereby particle specific surface area on the dewatering performance of wet furnish was investigated. Permeability coefficients of wet furnish during pressure filtration experiments were also determined based on Darcy’s law for volumetric flow through a porous medium. Results revealed that specific particle surface area has a significant effect on the dewatering of wet furnish where dewatering rate significantly increased at higher specific particle surface area levels. While the permeability of the systems decreased over time in almost all cases, the most significant portion of dewatering occurred at very early stages of dewatering (less than 200 seconds) leading to a considerable increase in instantaneous dewatering when CNF particles come in contact with wood particles.