Hybrid oscillator-based no-delay hip exoskeleton control for free walking assistance

Purpose Walking-aid exoskeletons can assist and protect effectively the group with lower limb muscle strength decline, workers, first responders and military personnel. However, there is almost no united control strategy that can effectively assist daily walking. This paper aims to propose a hybrid oscillators’ (HOs) model to adapt to irregular gait (IG) patterns (frequent alternation between walking and standing or rapid changing of walking speed, etc.) and generate compliant and no-delay assistive torque. Design/methodology/approach The proposed algorithm, HOs, combines adaptive oscillators (AOs) with phase oscillator through switching assistive mode depending on whether or not the AOs' predicting error of hip joint degree is exceeded our expectation. HOs can compensate for delay by predicting gait phase when in AOs mode. Several treadmill and free walking experiments are designed to test the adaptability and effectiveness of HOs model under IG. Findings The experimental results show that the assistive strategy based on the HOs is effective under IG patterns, and delay is compensated totally under quasiperiodic gait conditions where a smoother human–robot interaction (HRI) force and the reduction of HRI force peak are observed. Delay compensation is found very effective at improving the performance of the assistive exoskeleton. Originality/value A novel algorithm is proposed to improve the adaptability of a walking assist hip exoskeleton in daily walking as well as generate compliant, no-delay assistive torque when converging.

A four-state adaptive Hopf oscillator

Adaptive oscillators (AOs) are nonlinear oscillators with plastic states that encode information. Here, an analog implementation of a four-state adaptive oscillator, including design, fabrication, and verification through hardware measurement, is presented. The result is an oscillator that can learn the frequency and amplitude of an external stimulus over a large range. Notably, the adaptive oscillator learns parameters of external stimuli through its ability to completely synchronize without using any pre- or post-processing methods. Previously, Hopf oscillators have been built as two-state (a regular Hopf oscillator) and three-state (a Hopf oscillator with adaptive frequency) systems via VLSI and FPGA designs. Building on these important implementations, a continuous-time, analog circuit implementation of a Hopf oscillator with adaptive frequency and amplitude is achieved. The hardware measurements and SPICE simulation show good agreement. To demonstrate some of its functionality, the circuit’s response to several complex waveforms, including the response of a square wave, a sawtooth wave, strain gauge data of an impact of a nonlinear beam, and audio data of a noisy microphone recording, are reported. By learning both the frequency and amplitude, this circuit could be used to enhance applications of AOs for robotic gait, clock oscillators, analog frequency analyzers, and energy harvesting.

Pre-Impact Detection Algorithm to Identify Tripping Events Using Wearable Sensors

This study aimed to investigate the performance of an updated version of our pre-impact detection algorithm parsing out the output of a set of Inertial Measurement Units (IMUs) placed on lower limbs and designed to recognize signs of lack of balance due to tripping. Eight young subjects were asked to manage tripping events while walking on a treadmill. An adaptive threshold-based algorithm, relying on a pool of adaptive oscillators, was tuned to identify abrupt kinematics modifications during tripping. Inputs of the algorithm were the elevation angles of lower limb segments, as estimated by IMUs located on thighs, shanks and feet. The results showed that the proposed algorithm can identify a lack of balance in about 0.37 ± 0.11 s after the onset of the perturbation, with a low percentage of false alarms (<10%), by using only data related to the perturbed shank. The proposed algorithm can hence be considered a multi-purpose tool to identify different perturbations (i.e., slippage and tripping). In this respect, it can be implemented for different wearable applications (e.g., smart garments or wearable robots) and adopted during daily life activities to enable on-demand injury prevention systems prior to fall impacts.