Sediment Thickness and Moho Depth Beneath Western Indonesian Region From Teleseismic Receiver Function

The Earth's crust layer and sediment in Western Indonesia has been studied using the inversion of teleseismic receiver function from BMKG’s seismic network. Earthquake events were analyzed in this study with a moment magnitude greater than 6.0 with epicentral distances of 30° to 90°. A total of 60 earthquake events were observed and recorded by 91 stations around the study area. Furthermore, an inversion process was carried out using the initial velocity model from the modification of the AK135f velocity model to obtain the shear wave velocity structure below each stations. The velocity model from the azimuthally stacked vertical receiver function showed that the sediment layer had a relatively medium shear wave velocity value with an average of 2.1 km/s, while the crust layer had 4.60 km/s. The sedimentary layer thickness in this region also varies between 2 km to 10 km. A relatively thick sediment layer of about 8 km to 10 km was observed in two locations, in East Kalimantan associated with the Kutai Basin and Northern part of Sumatera in the North Sumatera Basin, a two major oil producer basinal area in Indonesia. The Moho discontinuity was also found at depths that vary between 16 km to 50 km. In addition, the most shallow Moho depth is 16 km below the North Kalimantan and North part of West Java, while the deeper Moho depth of 50 km is located below East Kalimantan, Central Kalimantan, North Sumatera and South Sumatera.

Predictive models for the deep geometry of a thick-skinned thrust matched to crustal structure: Wind River Range, western USA

The ability of models designed to use near-surface structural information to predict the deep geometry of a faulted block is tested for a thick-skinned thrust by matching the surface geometry to the crustal structure beneath the Wind River Range, Wyoming, USA. The Wind River Range is an ∼100-km-wide, thick-skinned rotated basement block bounded on one side by a high-angle reverse fault. The availability of a deep seismic-reflection profile and a detailed crustal impedance profile based on teleseismic receiver-function analysis makes this location ideal for testing techniques used to predict the deep fault geometry from shallow data. The techniques applied are the kinematic models for a circular-arc fault, oblique simple-shear fault, shear fault-bend fold, and model-independent excess area balancing. All the kinematic models imply that the deformation cannot be exclusively rigid-body rotation but rather require distributed deformation throughout some or all of the basement. Both the circular-arc model and the oblique-shear models give nearly the same best fit to the master fault geometry. The predicted lower detachment matches a potential crustal detachment zone at 31 km subsea. The thrust ramp is located close to where this zone dies out to the southwest. The circular-arc model implies that the penetrative deformation could be focused at the trailing edge of the basement block rather than being distributed uniformly throughout and thus helps to explain the line of second-order anticlines along the trailing edge of the Wind River block. Key points: (1) The circular-arc fault model and the oblique-shear model predict a lower detachment for the Wind River rotated block to be ∼31 km subsea, consistent with the crustal structure as defined by teleseismic receiver-function analysis. The thrust ramp starts where this zone dies out. (2) The kinematic models require distributed internal deformation within the basement block, probably concentrated at the trailing edge. (3) The uplift at the trailing edge of the rotated block is explained by the circular-arc kinematic model as a requirement to maintain area balance of a mostly rigid block above a horizontal detachment; the oblique-shear model can explain the uplift as caused by displacement on a dipping detachment.