New results of a palynological study of the Lake Doroninskoe sediments (Eastern Siberia, Transbaikalia)

This article presents the results of the study of the bottom sediments of the meromictic Lake Doroninskoe. For the study, the method of spore-pollen analysis was used. The record showed that during the accumulation of 65 cm of the sediment layer in the Chita-Ingodinskaya depression, pine and larch predominated along the ridges, with steppe and meadow associations in the lower parts of the depression. According to regional correlations, the distribution of light-coniferous-taiga vegetation in Transbaikalia occurred as early as the Middle Holocene, and it did not undergo cardinal changes until modern times. According to these data, sediments may have accumulated during this time period.

Determination of earthquake prone zones at university of tadulako based on dominant periods and peak ground acceleration (PGA)

University of Tadulako is the largest State University in Palu City. When an earthquake with a magnitude of 7.4 Mw on September 28, 2018, occurred, many buildings were damaged and even collapsed at that time, even causing casualties due to the rubble. Research on the Local Site Effect is essential for the assessment of seismic hazard. In this study, the local site effect was analyzed using the HVSR method based on microtremor data. The predominant Period (To) ranges between 1.709 s to 3.816 s, indicates that this area consists of alluvium and has a very thick sediment layer. Another parameter calculated in this paper is the peak ground acceleration (PGA) with values from 0.914 g to 0.924 g. This value is the first indicated soil damage level due to ground motions. The results of this study can be used as a consideration in the development of regional spatial planning and building structures based on earthquake analysis.

Loading Criteria and Deposit Layer Characteristics as Causes of Sediment Settlement in an Estuary

Sediment compaction due to the extraction of groundwater and self-weight consolidation, and monitoring land settlement of the river delta using geodetic measurement has been executed in several studies, while sediment settlement in the estuary is hypothesized due to dynamic loads. The present study aimed to observe clues for the occurrence of sediment settlement due to loading variation and deposit layer characteristics in the estuary. This research was based on four loading data for examination, i.e., hydraulic head pressure, sediment transport rate, sediment deposition, and water density. Two years of previous research simulations, including the rainy and dry seasons, were recalculated to gain the load pressure and were considered to assess the maximum load prediction. This review found evidence that dynamic loads predominated in maximum pressure changes in boreholes (BH2) and (BH3), and were due to river discharge and tidal occurrence, respectively. The dynamic load of sediment in BH2 contributed more than in BH3, where it was almost nonexistent. Observing the sediment layer characteristics, both settled for almost a month and two weeks, respectively, showed sediment settlement of more or less than 2 and 8 mm. Despite insignificant loading changes, these findings can further our understanding of loading criteria and settlement in different geometric locations.

Water flow through sediments and at the ice-sediment interface beneath Sermeq Kujalleq (Store Glacier), Greenland

Subglacial hydrology modulates basal motion but remains poorly constrained, particularly for soft-bedded Greenlandic outlet glaciers. Here, we report detailed measurements of the response of subglacial water pressure to the connection and drainage of adjacent water-filled boreholes drilled through kilometre-thick ice on Sermeq Kujalleq (Store Glacier). These measurements provide evidence for gap opening at the ice-sediment interface, Darcian flow through the sediment layer, and the forcing of water pressure in hydraulically-isolated cavities by stress transfer. We observed a small pressure drop followed by a large pressure rise in response to the connection of an adjacent borehole, consistent with the propagation of a flexural wave within the ice and underlying deformable sediment. We interpret the delayed pressure rise as evidence of no pre-existing conduit and the progressive decrease in hydraulic transmissivity as the closure of a narrow (< 1.5 mm) gap opened at the ice-sediment interface, and a reversion to Darcian flow through the sediment layer with a hydraulic conductivity of ≤ 10−6 m s−1. We suggest that gap opening at the ice-sediment interface deserves further attention as it will occur naturally in response to the rapid pressurisation of water at the bed.

Enhanced Sediment Denitrification for Nitrogen Removal by Manipulating Water Level in the Lakeshore Zone

Denitrification of sediments is an important way to remove reactive nitrogen in lakeshore zones. In this work, we analyzed sediment denitrification patterns across the shore zone of Lake Taihu and explored their underlying mechanisms using flooding simulation experiments. The results showed that denitrification mainly occurred in the upper sediment layer (0–10 cm) and the denitrification rate was highest at the land–water interface (6.2 mg N/m2h), where there was a frequent rise and fall in the water level. Denitrification was weaker in the lakebed sediments (4.6 mg N/m2h), which were inundated long-term, and in the sediments of the near-shore zone (2.3 mg N/m2h), which were dried out for extended periods. Flooding simulation experiments further indicated a strong positive relationship between sediment denitrification rate and flooding frequency. When the flooding occurred once every 3, 6, 9, 12, or 15 days, the denitrification rate reached 7.6, 5.7, 2.8, 0.9, and 0.6 mg N/m2h, respectively. Frequent flooding caused alternating anoxic and aerobic conditions in sediments, accelerating nitrogen substrate supply and promoting the growth and activity of denitrifying bacteria. Based on these findings, we propose a possible strategy for enhancing sediment denitrification by manipulating the water level, which can help guide nitrogen removal in lakeshore zones.

Impact of Sediment Layer on Longitudinal Dispersion in Sewer Systems

Experiments focused on pollution transport and dispersion phenomena in conditions of low flow (low water depth and velocities) in sewers with bed sediment and deposits are presented. Such conditions occur very often in sewer pipes during dry weather flows. Experiments were performed in laboratory conditions. To simulate real hydraulic conditions in sewer pipes, sand of fraction 0.6–1.2 mm was placed on the bottom of the pipe. In total, we performed 23 experiments with 4 different thicknesses of sand sediment layers. The first scenario is without sediment, the second is with sediment filling 3.4% of the pipe diameter (sediment layer thickness = 8.5 mm), the third scenario represents sediment filling 10% of the pipe diameter (sediment layer thickness = 25 mm) and sediment fills 14% of the pipe diameter (sediment layer thickness = 35 mm) in the last scenario. For each thickness of the sediment layer, a set of tracer experiments with different flow rates was performed. The discharge ranges were from (0.14–2.5)·10−3 m3·s−1, corresponding to the range of Reynolds number 500–18,000. Results show that in the hydraulic conditions of a circular sewer pipe with the occurrence of sediment and deposits, the value of the longitudinal dispersion coefficient Dx decreases almost linearly with decrease of the flow rate (also with Reynolds number) to a certain limit (inflexion point), which is individual for each particular sediment thickness. Below this limit the value of the dispersion coefficient starts to rise again, together with increasing asymmetricity of the concentration distribution in time, caused by transient (dead) storage zones.

The effect of sediments on the dynamics and accretionary style of subduction margins

Subduction zones represent the only major pathway by which continental material can be returned to the Earth's mantle. Constraining the sediments mass flux through subduction zones is important to the understanding of both petrogenesis of continental crust, and the recycling of volatiles and continental material back into the mantle over long periods of geologic time. When sediments are considered, convergent margins appear to fall into one of two classes: accretionary and erosive. Accretionary margins are dominated by accretion of thick piles of sediments (> 1 km) from the subducting plate, while tectonic erosion is favored in regions where the sedimentary cover is < 1 km. However, as data help define geometry of the global subduction system, the consequences of the two styles of margins on subduction dynamics remain poorly resolved. In this study, we run systematic 2-D numerical simulations of subduction to investigate how sediment fluxes influence subduction dynamics and plate coupling. We vary the thickness and viscosity of the sediment layer entering subduction, the thickness of the upper plate, and the driving velocity of the subducting plate (i.e., kinematic boundary conditions). Our results show three modes of subduction interface: a) Tectonic erosion margin (high viscosity sediment layer), b) Low angle accretionary wedge margin (low viscosity, thin sediment layer), and c) High angle accretionary wedge margin (low viscosity, thick sediment layer). We find that the properties of the sediment layer modulate the extent of viscous coupling at the interface between the subducting and overriding plates. When the viscous coupling is increased, an erosive style margin will be favored over an accretionary style. On the other hand, when the viscous coupling is reduced, sediments are scrapped-off the subducting slab to form an accretionary wedge. Diagnostic parameters are extracted automatically from numerical simulations to analyze the dynamics and differentiate between these modes of subduction margin. Models of tectonic erosion margins show small radii of curvature, slow convergence rates and thin subduction interfaces, while results of accretionary margins show large radii of curvature, faster convergence rates and dynamic accretionary wedges. These diagnostics parameters are then linked with observations of present-day subduction zones.