Evolution of oxide and nitride inclusions during processing of stainless steel

Because of its superior properties, stainless steel has been widely used for many applications. Nonmetallic inclusions can influence the quality of stainless steel products. A set of samples was used to track the response of inclusion composition during processing of a heat of titanium-bearing 18% chromium steel, from deoxidation after decarburization, to the solidified slab. The oxide inclusions responded as expected to additions of deoxidizers and calcium treatment, changing from silica to alumina and spinels, and then to calcium aluminates. The samples confirmed that titanium nitride can nucleate on liquid calcium aluminate during steel solidification.

Influence of the nitrided layer thickness of dies made of two types of tool steel used in hot extrusion of valve forgings made of nickel–chromium steel on the durability of these tools

The study constitutes an analysis of the durability of dies used in the first operation of producing valve forgings from chromium–nickel steel (NCF 3015) for motor trucks. The average durability of the dies (subjected to standard thermal treatment and nitriding) in this operation equals about 800 forgings. To perform an in-depth analysis of the effect of the nitrided layer thickness (0.1 mm and 0.2 mm) and the tool material (W360 and QRO90) on the possibilities of increasing the die durability, complex studies were carried out, which included: a macroscopic analysis combined with 3D scanning, microstructural examinations using a scanning microscope and a metallographic microscope, as well as hardness measurements. A minimum of three tools were tested for different variants, and for each of them, one representative die was selected for detailed examinations. The research showed the presence of abrasive wear, thermo-mechanical fatigue and traces of adhesive wear as well as plastic deformation on the surface of the working impressions. Also observed was the effect of the extruded material sticking to the tools (high friction and the presence of intermetallic phases in the extruded material) and the forging being blocked in the smallest section of the die, which is a critical factor causing a production shutdown and the necessity of tool replacement. The highest mean durability equalling 2600 forgings was obtained for the dies with a lower carbon content and a higher content of vanadium and the nitrided layer thickness at the level of 0.2 mm. The lowest mean durability (after one forging item) was recorded for the dies made of steel with a higher carbon content and a higher chromium content, forming less stable compound carbides and the thickness layer at the level of 0.1 mm.

On the Application of Magnetoacoustic Emission for a Nondestructive Assessment of the Post Welding Heat Treatment of High Chromium Steel Weld Seams

The paper analyses the possibility of post weld heat treatment (PWHT) quality assessment with the help of magnetoacoustic emission (MAE) signal measurements. Two welded superheater tubes, made of high chromium VM12 steel, were analysed—as welded and heat treated one. The analysed sample in the as welded state exhibited significantly higher hardness, accompanied by a big difference in the MAE signal intensity (of order of about 50%). In order to explain that, the influence of tempering on the MAE signal intensity is demonstrated for the very similar X20CrMoV12.1 steel. It is shown that the observed increase of the MAE intensity as a function of annealing time is directly correlated with the change in hardness. The as described dependence allows to propose a method based on the MAE signal measurements as a new tool for the PWHT assessment.