ultrasound radiation
Recently Published Documents


TOTAL DOCUMENTS

154
(FIVE YEARS 1)

H-INDEX

23
(FIVE YEARS 0)

2021 ◽  
Author(s):  
Madhvi Garg ◽  
Navneet Bhullar ◽  
Bharat Bajaj ◽  
Dhiraj Sud

The present manuscript reports the ultrasound radiation induced synthesis of grafted chitosan hydrogels (CAAT and CAAG) using terephthalaldehyde/glutaraldehyde as crosslinking agents and its application for removal of synthetic dyes from...



2020 ◽  
Vol 23 (8) ◽  
pp. 201-206
Author(s):  
Luca Basso ◽  
Alberto Di Mascio ◽  
Grazia Di Leo

Over the past decade, the experience gained on the use of Contrast Enhancement Ultrasound (CEUS) and the increasing number of scientific publications about the topic have allowed this method to become an alternative to the traditional imaging methods, especially in paediatric Radiology. CEUS is a bedside ultrasound, radiation-free, repeatable and almost without risk of adverse reactions to the contrast. CEUS represent an additional weapon for diagnostic and follow-up purposes in the paediatric patient.



2020 ◽  
Vol 49 ◽  
pp. 118-132
Author(s):  
Gabriela Calderó ◽  
Gaio Paradossi
Keyword(s):  


2020 ◽  
Vol 1605 ◽  
pp. 012055
Author(s):  
Sichao Su ◽  
Ruiqing Li ◽  
Xiaoqian Li


2020 ◽  
Vol 57 ◽  
pp. 101713 ◽  
Author(s):  
Zongxia Zhao ◽  
Lijuan Qu ◽  
Ting Shuang ◽  
Shenjun Wu ◽  
Yuqiang Su ◽  
...  


2020 ◽  
Vol 5 (4) ◽  
pp. 81-83
Author(s):  
Suman Sen ◽  
◽  
Sheuli Sen ◽  
Keyword(s):  


2019 ◽  
Vol 64 (9) ◽  
pp. 820
Author(s):  
Yu. M. Stula

Ultrasound absorption in aqueous alcoholic solutions has been studied in the vicinity of their singular points. The abnormal ultrasound absorption is assumed to occur due to the formation of unstable nuclei of a new phase. A model for the time evolution of those nuclei is proposed. The model makes it possible to explain the emergence of the resonance ultrasound absorption in the vicinity of the singular point of the 2-propanol solution. The dependences of the absorption intensity on the nucleus parameters, temperature, and ultrasound frequency are analyzed. A contribution of the ultrasound radiation from the nuclei to the effective shear viscosity of the solutions is estimated. The results of theoretical calculations are compared with available experimental data.



Author(s):  
Outi Supponen ◽  
Awaneesh Upadhyay ◽  
Jordan Lum ◽  
Francesco Guidi ◽  
Todd Murray ◽  
...  


Materials ◽  
2019 ◽  
Vol 12 (18) ◽  
pp. 2998 ◽  
Author(s):  
Giuseppina Barra ◽  
Liberata Guadagno ◽  
Luigi Vertuccio ◽  
Bartolome Simonet ◽  
Bricio Santos ◽  
...  

Different industrial mixing methods and some of their combinations ((1) ultrasound; (2) mechanical stirring; (3) by roller machine; (4) by gears machine; and (5) ultrasound radiation + high stirring) were investigated for incorporating multi-walled carbon nanotubes (MWCNT) into a resin based on an aeronautical epoxy precursor cured with diaminodiphenylsulfone (DDS). The effect of different parameters, ultrasound intensity, number of cycles, type of blade, and gear speed on the nanofiller dispersion were analyzed. The inclusion of the nanofiller in the resin causes a drastic increase in the viscosity, preventing the homogenization of the resin and a drastic increase in temperature in the zones closest to the ultrasound probe. To face these challenges, the application of high-speed agitation simultaneously with the application of ultrasonic radiation was applied. This allowed, on the one hand, a homogeneous dispersion, and on the other hand, an improvement of the dissipation of heat generated by ultrasonic radiation. The most efficient method was a combination of ultrasound radiation assisted by a high stirring method with the calendar, which was used for the preparation of a carbon fiber reinforced panel (CFRP). The manufactured panel was subjected to dynamic and vibroacoustic tests in order to characterize structural damping and sound transmission loss properties. Under both points of view, the new formulation demonstrated an improved efficiency with reference to a standard CFRP equivalent panel. In fact, for this panel, the estimated damping value was well above the average of the typical values representative of the carbon fiber laminates (generally less than 1%), and also a good vibroacoustic performance was detected as the nanotube based panel exhibited a higher sound transmission loss (STL) at low frequencies, in correspondence with the normal mode participation region. The manufactured panel was also characterized in terms of fire performance using a cone calorimeter and the results were compared to those obtained using a commercially available monocomponent RTM6 (Hexcel composites) epoxy aeronautic resin with the same process and the same fabric and lamination. Compared to the traditional RTM6 resin, the panel with the epoxy nanofilled resin exhibits a significant improvement in fire resistance properties both in terms of a delay in the ignition time and in terms of an increase in the thermal resistance of the material. Compared to the traditional panel, made in the same conditions as the RTM6 resin, the time of ignition of the nanotube-based panel increased by 31 seconds while for the same panel, the heat release rate at peak, the average heat release rate, and the total heat release decreased by 21.4%, 48.5%, and 15%, respectively. The improvement of the fire performance was attributed to the formation of a non-intumescent char due to the simultaneous presence of GPOSS and carbon nanotubes.



Sensors ◽  
2019 ◽  
Vol 19 (4) ◽  
pp. 955 ◽  
Author(s):  
Siavash Ghavami ◽  
Adriana Gregory ◽  
Jeremy Webb ◽  
Mahdi Bayat ◽  
Max Denis ◽  
...  

Vibrational characteristics of bone are directly dependent on its physical properties. In this study, a vibrational method for bone evaluation is introduced. We propose a new type of quantitative vibro-acoustic method based on the acoustic radiation force of ultrasound for bone characterization in persons with fracture. Using this method, we excited the clavicle or ulna by an ultrasound radiation force pulse which induces vibrations in the bone, resulting in an acoustic wave that is measured by a hydrophone placed on the skin. The acoustic signals were used for wave velocity estimation based on a cross-correlation technique. To further separate different vibration characteristics, we adopted a variational mode decomposition technique to decompose the received signal into an ensemble of band-limited intrinsic mode functions, allowing analysis of the acoustic signals by their constitutive components. This prospective study included 15 patients: 12 with clavicle fractures and three with ulna fractures. Contralateral intact bones were used as controls. Statistical analysis demonstrated that fractured bones can be differentiated from intact ones with a detection probability of 80%. Additionally, we introduce a “healing factor” to quantify the bone healing progress which successfully tracked the progress of healing in 80% of the clavicle fractures in the study.



Sign in / Sign up

Export Citation Format

Share Document