Author(s):  
Alessandro Longato ◽  
Sebastiano Picco ◽  
Lorenzo Moro ◽  
Matteo Buffolo ◽  
Carlo De Santi ◽  
...  

2014 ◽  
Vol 61 (26) ◽  
pp. 31-36 ◽  
Author(s):  
Y.-R. Chung ◽  
C.-K. Chang ◽  
J.-H. Liao ◽  
F.-B. Wu

2016 ◽  
Vol 55 (3-4) ◽  
pp. 172-184 ◽  
Author(s):  
O. R. Parkhomei ◽  
N. D. Pinchuk ◽  
O. E. Sych ◽  
T. V. Tomila ◽  
G. B. Tovstonog ◽  
...  

2008 ◽  
Vol 368-372 ◽  
pp. 1422-1425 ◽  
Author(s):  
An Guo Lu ◽  
Tai Qiu

Calcium borosilicate (CaO-B2O3-SiO2, CBS) glass based glass-ceramic composites were prepared by introducing borosilicate glass. The effects of borosilicate glass and firing temperature on the microstructure and properties of the glass-ceramic composites were investigated. The results showed that the composites containing 0~40% (in mass fraction, the same below) borosilicate glass can be sintered at 850°C. The dielectric constant (εr) decreases with the increase of borosilicate glass content and can be adjusted in the range of 5.6~6.6. The coefficient of thermal expansion (CTE) increases with the increase of borosilicate glass content. Increasing sintering temperature favors the precipitations of crystal phases, which have lower εr than CBS glass, resulting in the decrease of εr for the composites.


2013 ◽  
Vol 45 (3) ◽  
pp. 331-339
Author(s):  
A. Faeghi-Nia

An Apatite-Wollastonite-Phlogopite glass-ceramic composite, was developed by sintering and crystallization of the powdered glass. The non-isothermal and isothermal sintering kinetics were studied for this glass-ceramic. Hot-stage microscopy (HSM) measurements demonstrated that it is possible to sinter and crystallize this glass-ceramic with 80% relative density. The activation energy of sintering was analyzed using previously reported model of sintering and it was obtained Q=193.83 KjmolK-1. Also it was shown that the microstructure of sample is a function of particle size distribution.


Author(s):  
A. Sinha ◽  
K. Kokini ◽  
K. J. Bowman

The changes in stiffness properties for a CAS matrix-Nicalon fiber unidirectional composite resulting from cyclic heating and cooling are presented. The measurements are made using an ultrasonic pulse-echo technique. It is shown that a significant decrease in stiffness is observed after 30 cycles.


1990 ◽  
Vol 51 (C1) ◽  
pp. C1-879-C1-883
Author(s):  
L. MAZEROLLES ◽  
D. MICHEL ◽  
L. ULMER ◽  
J. L. PASTOL ◽  
M. PARLIER ◽  
...  

2013 ◽  
Vol 12 ◽  
pp. E19-E27 ◽  
Author(s):  
Rama Krishna Chinnam ◽  
Aldo R. Boccaccini ◽  
Enrico Bernardo ◽  
Howard Epstein

Sign in / Sign up

Export Citation Format

Share Document