Coverage Area-Based Power Control for Interference Management in LTE Femtocells

2018 ◽  
pp. 84-103
Author(s):  
Ghazanfar Ali Safdar
2016 ◽  
Vol 2016 ◽  
pp. 1-12 ◽  
Author(s):  
Arbab Waheed Ahmad ◽  
Heekwon Yang ◽  
Gul Shahzad ◽  
Chankil Lee

In Long Term Evolution-Advanced (LTE-A) heterogeneous networks (HetNets), small cells are deployed within the coverage area of macrocells having 1 : 1 frequency reuse. The coexistence of small cells and a macrocell in the same frequency band poses cross-tier interference which causes outage for macrocells users and/or small cell users. To address this problem, in this paper, we propose two algorithms that consider the received interference level at the evolved NodeB (eNB) while allocating transmit power to the users. In the proposed algorithm, the transmit power of all users is updated according to the target and instantaneous signal-to-noise-plus-interference ratio (SINR) condition as long as the effective received interference at the serving eNB is below the given threshold. Otherwise, if the effective received interference at the eNB is greater than the threshold, the transmit power of small cell users is gradually reduced in order to guarantee the target SINR for all macrocells users, aiming for zero-outage for macrocells users at the cost of an increased outage ratio for small cell users. Further, in the second algorithm, the transmit power of all users is additionally controlled by the power headroom report that considers the current channel condition while updating the transmit power which results in the outage ratio decreasing for small cell users. The extensive system-level simulations show significant improvements in the average throughput and outage ratio when compared with the conventional transmit power control technique.


2018 ◽  
Vol 10 (3) ◽  
pp. 25 ◽  
Author(s):  
Tehseen Hassan ◽  
Fei Gao ◽  
Babur Jalal ◽  
Sheeraz Arif

2018 ◽  
Vol 22 (S4) ◽  
pp. 8581-8588 ◽  
Author(s):  
Yang Wang ◽  
Jianbiao He ◽  
Bo Zou

2008 ◽  
Vol 4 (4) ◽  
pp. 347-368 ◽  
Author(s):  
Kainan Cha ◽  
Anil Ramachandran ◽  
Sarangapani Jagannathan

In radio frequency identification (RFID) systems, the detection range and read rates will suffer from interference among high power reading devices. This problem grows severely and degrades system performance in dense RFID networks. Consequently, medium access protocols (MAC) protocols are needed for such networks to assess and provide access to the channel so that tags can be read accurately. In this paper, we investigate a suite of feasible power control schemes to ensure overall coverage area of the system while maintaining a desired read rate. The power control scheme and MAC protocol dynamically adjusts the RFID reader power output in response to the interference level seen during tag reading and acceptable signal-to-noise ratio (SNR). We present novel distributed adaptive power control (DAPC) and probabilistic power control (PPC) as two possible solutions. A suitable back off scheme is also added with DAPC to improve coverage. Both the methodology and implementation of the schemes are presented, simulated, compared, and discussed for further work.


2021 ◽  
Vol 13 (2) ◽  
pp. 79-88
Author(s):  
Misfa Susanto ◽  
Sitronella Nurfitriani Hasim ◽  
Helmy Fitriawan

Femtocell is one of solutions to improve quality of services and network capacity for users in indoor areas. Radio resources used by femtocells are shared from macrocell network, thus it saves the use of frequency spectrum. However, one of problems in deploying femtocells within coverage area of macrocells is interference due to radio resources sharing between femtocells and macrocells. It creates interferences called as cross-tier (macrocell-femtocell/femtocell-macrocell) and co-tier (macrocell-macrocell/femtocell-femtocell) interferences. This paper proposes a relay-based clustering method to mitigate interference in femtocells located in the whole edge area of macrocell and the cell edge area of sectorized macrocells. Relay nodes are deployed statically (fixed location) in the neighboring macrocell area. Relay node will recruit their members based on the shortest distance. Certain relay node’s members do not need to transmit large amounts of power to enhanced Node B (eNB), such that interference from Macrocell User Equipment (MUE) to Home enhanced Node B (HeNB) can be minimized. Simulation experiments has been carried out and optimistic results for the sectorized macrocells scenario show that Signal-to-Interference-plus-Noise-Ratio (SINR) of femtocells for the conventional system that does not reach the targeted SINR of 20 dB is 87%. Meanwhile, after applying the relay-based clustering method, SINR value of femtocells below or equal to 20 dB reaches 72%. Optimistic results for throughput and Bit Error Rate (BER) show improvement of 15% and 14%, respectively. It has been shown that the relay-based clustering method can provide better performance compared to the conventional system even for femtocells densely deployed.


Sign in / Sign up

Export Citation Format

Share Document