Trajectory planning of a 4-RR(SS)2 high-speed parallel robot

The trajectory-planning method for a novel 4-degree-of-freedom high-speed parallel robot is studied herein. The robot’s motion mechanism adopts RR(SS)2 as branch chains and has a single moving platform structure. Compared with a double moving platform structure, the proposed parallel robot has better acceleration and deceleration performance since the mass of its moving platform is lighter. An inverse kinematics model of the mechanism is established, and the corresponding relationship between the motion parameters of the end-moving platform and the active arm with three end-motion laws is obtained, followed by the optimization of the motion laws by considering the motion laws’ duration and stability. A Lamé curve is used to transition the right-angled part of the traditional gate trajectory, and the parameters of the Lamé curve are optimized to achieve the shortest movement time and minimum acceleration peak. A method for solving Lamé curve trajectory interpolation points based on deduplication optimization is proposed, and a grasping frequency experiment is conducted on a robot prototype. Results show that the grasping frequency of the optimized Lamé curve prototype can be increased to 147 times/min, and its work efficiency is 54.7% higher than that obtained using the traditional Adept gate-shaped trajectory.

Dynamic Simulation Modeling of Industrial Robot Kinematics in Industry 4.0

This paper studies the kinematic dynamic simulation modeling of industrial robots in the Industry 4.0 environment and guides the kinematic dynamic simulation modeling of industrial robots in the Industry 4.0 environment in the context of the research. To address the problem that each parameter error has different degrees of influence on the end position error, a method is proposed to calculate the influence weight of each parameter error on the end position error based on the MD-H error model. The error model is established based on the MD-H method and the principle of differential transformation, and then the function of uniform variation of six joint angles with time t is constructed to ensure that each linkage geometric parameter is involved in the motion causing error accumulation. Through the analysis of the robot marking process, the inverse solution is optimized for multiple solutions, and a unique engineering solution is obtained. Linear interpolation, parabolic interpolation, polynomial interpolation, and spline curve interpolation are performed on the results after multisolution optimization in the joint angle, and the pros and cons of various interpolation results are analyzed. The trajectory planning and simulation of industrial robots in the Industry 4.0 environment are carried out by using a special toolbox. The advantages and disadvantages of the two planning methods are compared, and the joint space trajectory planning method is selected to study the planning of its third and fifth polynomials. The kinetic characteristics of the robot were simulated and tested by experimental methods, and the reliability of the simulation results of the kinetic characteristics was verified. The kinematic solutions of industrial robots and the results of multisolution optimization are simulated. The methods, theories, and strategies studied in this paper are slightly modified to provide theoretical and practical support for another dynamic simulation modeling of industrial robot kinematics with various geometries.

Application of Optimal-Jerk Trajectory Planning in Gait-balance Training Robot

To accommodate the gait and balance disorder of the elderly with age progression and the occurrence of various senile diseases, this paper proposes a novel gait balance training robot (G-Balance) based on a six degree-of-freedom parallel platform. Using the platform movement and IMU wearable sensors, two training modes, i.e., active and passive, are developed to achieve vestibular stimulation. Virtual reality technology is applied to achieve visual stimulation. In the active training mode, the elderly actively exercises to control the posture change of the platform and the switching of the virtual scene. In the passive training mode, the platform movement is combined with the virtual scene to simulate bumpy environments, such as earthquakes, to enhance the human anti-interference ability. To achieve a smooth switching of the scene, continuous speed and acceleration of the platform motion are required in some scenarios, in which a trajectory planning algorithm is applied. This paper describes the application of the trajectory planning algorithm in the balance training mode and the optimization of jerk (differential of acceleration) based on cubic spline planning, which can reduce impact on the joint and enhance stability.