scholarly journals Advances in Rare‐Earth Tritelluride Quantum Materials: Structure, Properties, and Synthesis

2021 ◽  
pp. 2004762
Author(s):  
Kentaro Yumigeta ◽  
Ying Qin ◽  
Han Li ◽  
Mark Blei ◽  
Yashika Attarde ◽  
...  
Keyword(s):  
Rare Earth ◽  
Quantum Materials ◽  
Structure Properties

scholarly journals Rare-earth based half-Heusler topological quantum materials: A perspective

APL Materials ◽  
2020 ◽  
Vol 8 (6) ◽  
pp. 060903
Author(s):  
Ashutosh Kumar Singh ◽  
S. D. Ramarao ◽  
Sebastian C. Peter
Keyword(s):  
Rare Earth ◽  
Topological Quantum ◽  
Quantum Materials

Strong effect of multiplicity fluctuations in rare-earth cobaltites on magnetic, electronic and crystal structure properties

2019 ◽  
Vol 19 (3/4) ◽  
pp. 56-60
Author(s):  
S.G. Ovchinnikovi ◽  
Yu Orlov ◽  
L.A. Solov'yov ◽  
S. Gavrilkin ◽  
A. Tsvetkov ◽  
...  
Keyword(s):  
Crystal Structure ◽  
Rare Earth ◽  
Structure Properties

Characterization of Rare-Earth Fluoride Anti-Stokes Phosphors by Scanning arid Transmission Electron Microscopy

1971 ◽  
Vol 29 ◽  
pp. 142-143
Author(s):  
N. M. P. Low ◽  
L. E. Brosselard
Keyword(s):  
Electron Microscopy ◽  
Rare Earth ◽  
Elevated Temperatures ◽  
Stoichiometric Composition ◽  
Rare Earth Ions ◽  
Crystalline Solid ◽  
Precipitation Process ◽  
Rare Earth Fluoride ◽  
Earth Fluoride ◽  
Rare Earth Fluorides

There has been considerable interest over the past several years in materials capable of converting infrared radiation to visible light by means of sequential excitation in two or more steps. Several rare-earth trifluorides (LaF3, YF3, GdF3, and LuF3) containing a small amount of other trivalent rare-earth ions (Yb3+ and Er3+, or Ho3+, or Tm3+) have been found to exhibit such phenomenon. The methods of preparation of these rare-earth fluorides in the crystalline solid form generally involve a co-precipitation process and a subsequent solid state reaction at elevated temperatures. This investigation was undertaken to examine the morphological features of both the precipitated and the thermally treated fluoride powders by both transmission and scanning electron microscopy.Rare-earth oxides of stoichiometric composition were dissolved in nitric acid and the mixed rare-earth fluoride was then coprecipitated out as fine granules by the addition of excess hydrofluoric acid. The precipitated rare-earth fluorides were washed with water, separated from the aqueous solution, and oven-dried.

Study of segregation in La1.8Sr0.2CuO4 superconductor by STEM-EDS microanalysis

1987 ◽  
Vol 45 ◽  
pp. 54-55
Author(s):  
T. F. Kelly ◽  
P. J. Lee ◽  
E. E. Hellstrom ◽  
D. C. Larbalestier
Keyword(s):  
Rare Earth ◽  
High Field ◽  
Transport Current ◽  
Total Thickness ◽  
New Class ◽  
Ceramic Superconductors ◽  
Current Densities ◽  
Group Ii ◽  
Eds Microanalysis

Recently there has been much excitement over a new class of high Tc (>30 K) ceramic superconductors of the form A1-xBxCuO4-x, where A is a rare earth and B is from Group II. Unfortunately these materials have only been able to support small transport current densities 1-10 A/cm2. It is very desirable to increase these values by 2 to 3 orders of magnitude for useful high field applications. The reason for these small transport currents is as yet unknown. Evidence has, however, been presented for superconducting clusters on a 50-100 nm scale and on a 1-3 μm scale. We therefore planned a detailed TEM and STEM microanalysis study in order to see whether any evidence for the clusters could be seen.A La1.8Sr0.2Cu04 pellet was cut into 1 mm thick slices from which 3 mm discs were cut. The discs were subsequently mechanically ground to 100 μm total thickness and dimpled to 20 μm thickness at the center.

Trace nanoanalysis

1994 ◽  
Vol 52 ◽  
pp. 940-941
Author(s):  
D. E. Newbury ◽  
R. D. Leapman
Keyword(s):  
High Performance ◽  
Secondary Ion Mass Spectrometry ◽  
Detection Efficiency ◽  
Volume Element ◽  
And Performance ◽  
Trace Constituents ◽  
Secondary Ion ◽  
Concentration Levels ◽  
Structure Properties

Trace constituents, which can be very loosely defined as those present at concentration levels below 1 percent, often exert influence on structure, properties, and performance far greater than what might be estimated from their proportion alone. Defining the role of trace constituents in the microstructure, or indeed even determining their location, makes great demands on the available array of microanalytical tools. These demands become increasingly more challenging as the dimensions of the volume element to be probed become smaller. For example, a cubic volume element of silicon with an edge dimension of 1 micrometer contains approximately 5×1010 atoms. High performance secondary ion mass spectrometry (SIMS) can be used to measure trace constituents to levels of hundreds of parts per billion from such a volume element (e. g., detection of at least 100 atoms to give 10% reproducibility with an overall detection efficiency of 1%, considering ionization, transmission, and counting).

Microstructural characterization of a cast RENi5-based alloy

1993 ◽  
Vol 51 ◽  
pp. 1176-1177
Author(s):  
G. M. Micha ◽  
L. Zhang
Keyword(s):  
Electron Microscopy ◽  
Rare Earth ◽  
Microstructural Characterization ◽  
Binary Compound ◽  
Nickel Metal ◽  
Cast Material ◽  
Nickel Metal Hydride ◽  
Transmission Electron ◽  
Cast Condition

RENi5 (RE: rare earth) based alloys have been extensively evaluated for use as an electrode material for nickel-metal hydride batteries. A variety of alloys have been developed from the prototype intermetallic compound LaNi5. The use of mischmetal as a source of rare earth combined with transition metal and Al substitutions for Ni has caused the evolution of the alloy from a binary compound to one containing eight or more elements. This study evaluated the microstructural features of a complex commercial RENi5 based alloy using scanning and transmission electron microscopy.The alloy was evaluated in the as-cast condition. Its chemistry in at. pct. determined by bulk techniques was 12.1 La, 3.2 Ce, 1.5 Pr, 4.9 Nd, 50.2 Ni, 10.4 Co, 5.3 Mn and 2.0 Al. The as-cast material was of low strength, very brittle and contained a multitude of internal cracks. TEM foils could only be prepared by first embedding pieces of the alloy in epoxy.

Advancing the use of Voronoi–Dirichlet polyhedra to describe interactions in organic molecular crystal structures by the example of galunisertib polymorphs

CrystEngComm ◽  
2021 ◽  
Author(s):  
Viktor N. Serezhkin ◽  
Anton V. Savchenkov
Keyword(s):  
Crystal Structures ◽  
Molecular Crystal ◽  
Noncovalent Interactions ◽  
Organic Molecular Crystal ◽  
Universal Approach ◽  
Structure Properties

The universal approach for studying structure/properties relationships shows that every polymorph of galunisertib is characterized with unique noncovalent interactions.

Rare Earth Production

1952 ◽  
Vol 44 (3) ◽  
pp. 442-442
Author(s):  
Frank Spedding ◽  
Harley Wilhelm ◽  
Wayne Keller et al
Keyword(s):  
Rare Earth
Sign in / Sign up

Export Citation Format

Share Document