Thermal aging properties and chemical resistance of blends of natural rubber and epoxidized low molecular weight natural rubber

2005 ◽  
Vol 98 (4) ◽  
pp. 1733-1739 ◽  
Author(s):  
A. K. Akinlabi ◽  
F. E. Okieimen ◽  
A. I. Aigbodion
Keyword(s):  
Molecular Weight ◽  
Natural Rubber ◽  
Thermal Aging ◽  
Chemical Resistance ◽  
Low Molecular Weight ◽  
Aging Properties

Ozonolytic Degradation of Interpolymers of Natural Rubber with Methyl Methacrylate and Styrene

1958 ◽  
Vol 31 (1) ◽  
pp. 82-85
Author(s):  
D. Barnard
Keyword(s):  
Molecular Weight ◽  
Carbon Black ◽  
Natural Rubber ◽  
Accurate Determination ◽  
Synthetic Polymers ◽  
Polymer Chains ◽  
Low Molecular Weight ◽  
Rubber Content ◽  
Tert Butyl Hydroperoxide

Abstract The preparation of graft and block interpolymers of natural rubber and synthetic polymers has made it desirable that the number and size of polymer chains attached to rubber be readily determinate. The degradation of unsaturated polymers with tert-butyl hydroperoxide in the presence of osmium tet oxide has been used for the determination of free polystyrene in SBR and carbon black in several elastomers, and has recently been applied to the present problem. The accurate determination of the rubber content of interpolymers by quantitative ozonolysis essentially according to the method of Boer and Kooyman suggested that this might be made the basis of isolation of the attached polymer, the rubber being degraded into fragments of low molecular weight, from which the polymer could be separated by conventional techniques. The method should be applicable to any interpolymer, or mixture, of a polyunsaturated and a saturated polymer and is illustrated with reference to interpolymers of natural rubber (NR)-polymethyl methacrylate (PMM) and NR-polystyrene (PS).

Novel Method for Preparation of Low Molecular Weight Natural Rubber Latex

1998 ◽  
Vol 71 (4) ◽  
pp. 795-802 ◽  
Author(s):  
Jitladda Tangpakdee ◽  
Megumi Mizokoshi ◽  
Akiko Endo ◽  
Yasuyuki Tanaka
Keyword(s):  
Molecular Weight ◽  
Natural Rubber ◽  
Natural Rubber Latex ◽  
Oxidative Degradation ◽  
Low Molecular Weight ◽  
Rubber Latex ◽  
High Ammonia ◽  
Novel Method ◽  
Η Value ◽  
Telechelic Polymer

Abstract Low molecular-weight natural rubber (LNR) and LNR latex was prepared by oxidative degradation of de-proteinized natural rubber (DPNR) latex in the presence of 1 phr of K2S2O8 and 15 phr of propanal, by shaking at 60 °C. The intrinsic viscosity [η] of DPNR with only K2S2O8 decreased from 7.2 to 5.5 after 2 h and then increased to 6.5 after 3 h. By the addition of propanal, DPNR showed a significant decrease in the [η] value of LNR with [η] of about 0.5 after 5 h of the reaction, while rubber from high-ammonia natural rubber (HANR) latex showed a slight decrease in [η]. The concentration of latex and the kind of surfactant used for stabilizing the latex had little effect on the degradation rate of DPNR latex. The LNR latex is stable as the latex form and the dried rubber coagulated from latex is transparent and colorless. The LNR was a telechelic polymer containing aldehyde and ketone groups at both terminals as determined by NMR and molecular weight analyses.

Degradation of Polyisoprene Networks by Oxygen

1960 ◽  
Vol 33 (1) ◽  
pp. 51-59 ◽  
Author(s):  
E. M. Bevilacqua
Keyword(s):  
Molecular Weight ◽  
Natural Rubber ◽  
Present Report ◽  
Hydrocarbon Chain ◽  
Gas Absorption ◽  
Oxygen Absorption ◽  
Low Molecular Weight ◽  
Oxidation Reactions ◽  
Vulcanized Rubber ◽  
Mechanism Of Oxidation

Abstract The insolubility of vulcanized rubber and the relatively low concentration at which oxidation reactions completely degrade the vulcanizate have made it necessary that indirect methods be used to study the reaction of molecular oxygen with rubber. The literature contains many reports of measurements of the absorption of oxygen by vulcanized rubber, which is easy and convenient experimentally. In some of these the rate of oxygen absorption has been the only property measured. This alone gives little information about the mechanism of oxidation, although the fact that the general form of curves of oxygen absorption as a function of time can be predicted by equations based on the known mechanism of oxidation of low molecular weight olefins is indirect support for similar mechanisms of oxidation of polymers. The technologically important reaction accompanying oxidation of natural rubber is scission, not detected by gas absorption measurements. It has been studied principally by determining the decay in stress of a sample at constant strain. The results suggest that scission occurs by a first order process at selected sites in the network. This has been interpreted to mean that crosslinks are the primary locus of oxidation in vulcanized rubber. Estimates of the amount of oxygen required for breaking a bond are available only for samples vulcanized with sulfur. From these it may be calculated that initially 4– 5 moles of oxygen is required per scission, when allowance is made for the effect of entanglements on stress. A marked difference between the relaxation of peroxide-cured and sulfur-cured samples has been reported. Horikx has made an extensive investigation of the solubility and swelling of oxidized vulcanized rubber. His results show that the hydrocarbon chain must be broken during oxidation. The mechanism of scission of unvulcanized rubber has been determined; in this work it was found that low molecular weight products are an important index of scission reactions. The present report describes preliminary work on the scission mechanism in vulcanized natural rubber which has two objectives; to repeat Horikx's experiments with vulcanizates incapable of further cure, and to determine whether low molecular weight products accompany the scission reaction.

Refractive Index of Natural Rubber for Different Wave Lengths

1950 ◽  
Vol 23 (3) ◽  
pp. 661-669 ◽  
Author(s):  
L. A. Wood ◽  
L. W. Tilton
Keyword(s):  
Molecular Weight ◽  
Refractive Index ◽  
Natural Rubber ◽  
Wave Length ◽  
Low Molecular Weight

Abstract The refractive index of natural rubber and its variation with temperature and wave length are those which would be predicted for a similar hydrocarbon of low molecular weight. A two-constant equation of the Cauchy or Sellmeier type is inadequate to express the relation between refractive index and wave length for rubber. For convenient reference the best values resulting from the present investigation are recapitulated in Table VI.

Sign in / Sign up

Export Citation Format

Share Document