ChemInform Abstract: MECHANISM OF THE THERMAL DEHYDRATION OF SODIUM DIHYDROGEN PHOSPHATE.

1984 ◽  
Vol 15 (1) ◽  
Author(s):  
U. SCHUELKE ◽  
R. KAYSER ◽  
L. ARNDT
2014 ◽  
Vol 809-810 ◽  
pp. 477-484
Author(s):  
Zhao Qing Qi ◽  
Hong Tao Wang ◽  
Jun Liang Dang ◽  
Shi Hao Zhang ◽  
Jian Hua Ding

The capacity of 10%, 30%, and 50% ammonium dihydrogen phosphate were replaced with an equal amount of three phosphate (potassium dihydrogen phosphate, sodium dihydrogen phosphate, disodium hydrogen phosphate) respectively. Magnesium phosphate cement was made by phosphate of replaced, which strength, setting time, fluidity, hydration temperature, and the hydration products was researched. The results show that: MPC was made that replaced with the equal amount of three kind of phosphate, which has good mechanical properties. Setting time and fluidity change along with the replacment. Three kind of phosphate replace ammonium dihydrogen phosphate, which change the hydration process of MPC. When ammonium dihydrogen phosphate was replaced by an equal amount of disodium hydrogen phosphate, the temperature of hydration is only 69.4 °C. XRD showed that the diffraction peaks of composite’s magnesium phosphate cement increases.


2020 ◽  
pp. 1-14
Author(s):  
Dina El Sherbiny ◽  
Mary E. K. Wahba

Abstract A simple HPLC technique has been utilized for rapid and sensitive quantitative analysis of two mixtures of drugs that are used during pregnancy and lactation. Drugs of the first mixture are used to manage gastrointestinal tract illness that are common during early stages of pregnancy, while pharmaceutical agents of the second mixture are administered over the counter as galactagogues or to overcome postpartum depression. Mixture I includes famotidine (FMT), ranitidine (RNT), nizatidine (NZT), and pantoprazole (PNT), which were separated on a C18 column using a mobile phase composed of methanol: 0.02 M sodium dihydrogen phosphate (60:40, v/v) of pH 6.9, adopting UV detection at 240 nm at a flow rate of 1 mL/min. Mixture II on the other hand, consists of domperidone (DOM), metoclopramide (MET), and sulpiride (SUL). These drugs were eluted using the same column and flow rate as those in mixture I, using a mobile phase consisting of acetonitrile: 0.075 M sodium dihydrogen phosphate (30:70, v/v) of pH 6 adopting a detection wavelength 270 nm. Two optimization protocols were utilized to optimize the chromatographic separation conditions, namely one factor at a time (OFAT) and design of experiments (DOE) where face centered cube response surface experimental design was chosen for this investigation. Comparison of the results obtained from both protocols reveals the accordance between them. Full validation procedure under guidance of United States Pharmacopoeia (USP) was applied to the proposed methods which enabled their application to separate the drugs of both mixtures in spiked rat whole blood samples and in vivo analysis of rat heart blood.


1961 ◽  
Vol 7 (2) ◽  
pp. 156-164 ◽  
Author(s):  
Edward B Hendry

Abstract With the use of the Fiske Osmometer, the mean total osmolarity of normal human serum was found to be 289 mOsM (S.D., 4), which is equivalent to a mean freezing point of -0.537°. The isosmotic concentrations of some important biologic solutions were determined. It was also found that M/15 solutions of disodium hydrogen phosphate and of potassium dihydrogen phosphate are very hypotonic, and that 3.8% sodium citrate is hypertonic. Hemolysis of erythrocytes in isosmotic ammonium chloride solution can be considerably delayed by the addition of 3.0% glucose to the solution. Isosmotic concentrations of disodium hydrogen phosphate and sodium dihydrogen phosphate were precisely determined, as were pH levels of buffer solutions made from these two salts. The cause of the slight changes in osmolarity that occur when these two isosmotic solutions are mixed is discussed.


2012 ◽  
Vol 577 ◽  
pp. 115-118
Author(s):  
Wen Fu ◽  
Li Wang ◽  
Li Chen

The discharge characteristics of the potassium fluorozirconate electrolyte during plasma electrolytic oxidation process were investigated. Sodium dihydrogen phosphate was applied as additives. Ceramic films were prepared on magnesium alloy in electrolytes with different content additives under constant voltage. The effect of additives on the pH of the electrolyte and the dissolution of the substrate were investigated. It was found that the additives could influence the pH and dissolved magnesium ions effectively.


2014 ◽  
Vol 2014 ◽  
pp. 1-9 ◽  
Author(s):  
Ponnuswamy Vijayaraghavan ◽  
Samuel Gnana Prakash Vincent

Production of fibrinolytic enzyme by a newly isolatedPaenibacillussp. IND8 was optimized using wheat bran in solid state fermentation. A 25full factorial design (first-order model) was applied to elucidate the key factors as moisture, pH, sucrose, yeast extract, and sodium dihydrogen phosphate. Statistical analysis of the results has shown that moisture, sucrose, and sodium dihydrogen phosphate have the most significant effects on fibrinolytic enzymes production (P<0.05). Central composite design (CCD) was used to determine the optimal concentrations of these three components and the experimental results were fitted with a second-order polynomial model at 95% level (P<0.05). Overall, 4.5-fold increase in fibrinolytic enzyme production was achieved in the optimized medium as compared with the unoptimized medium.


Sign in / Sign up

Export Citation Format

Share Document