Improved‐quality graphene film decorated with ultrafine MnO 2 nanoparticles as a multifunctional current collector for high‐reversibility zinc‐ion batteries

Author(s):  
Young‐Geun Lee ◽  
Seoyeong Kim ◽  
Keun Young Lee ◽  
Yong‐Ryun Jo ◽  
Geon‐Hyoung An
2021 ◽  
Vol 105 (1) ◽  
pp. 135-142
Author(s):  
Mikhail A. Kamenskii ◽  
Svetlana N. Eliseeva ◽  
Veniamin V. Kondratiev

Electrochemical properties of δ-MnO2-based cathode materials were studied in dependence on current collector used for electrode casting (stainless steel mesh, carbon paper and titanium foil) by galvanostatic charge/discharge measurements and cyclic voltammetry. It was shown that δ-MnO2-based electrodes cast on carbon paper demonstrate the most stable electrochemical performance in comparison with two other current collectors. This can be explained by corrosion of steel and passivation of titanium in mild aqueous electrolytes. Detailed study of carbon paper as current collector shows that pressing of electrodes leads to decreasing the porosity and fast capacity fading.


Energies ◽  
2019 ◽  
Vol 13 (1) ◽  
pp. 31 ◽  
Author(s):  
Lyn Marie De Juan-Corpuz ◽  
Ryan Dula Corpuz ◽  
Anongnat Somwangthanaroj ◽  
Mai Thanh Nguyen ◽  
Tetsu Yonezawa ◽  
...  

Recently, rechargeable aqueous zinc-ion batteries (AZBs) have attracted extensive interest due to their safety, abundance, low cost, and low toxicity. However, aqueous electrolytes require a polymeric binder to prevent dissolution of the active material in addition to its binding properties. This study highlights binder-free, centimeter long, single-crystal, V2O5 nanofibers (BCS-VONF) on carbon cloth, as the cathode material for AZBs synthesized via a simple one-step hydrothermal process. BCS-VONF in 3.0 M Zn(OTf)2 exhibit promising electrochemical performance with excellent capacity retention. Even in the absence of a binder, BCS-VONF were found to be very stable in 3.0 M Zn(OTf)2. They will not yield to the dissolution and detachment of the active material on the current collector. The novel strategy described in this study is an essential step for the development of BCS-VONF on carbon cloth, as a promising cathode material for AZBs.


Author(s):  
А.С. Шадрина ◽  
И.В. Терешкина ◽  
Я.З. Плиева ◽  
Д.Н. Кушлинский ◽  
Д.О. Уткин ◽  
...  

Матриксные металлопротеиназы (ММП) - ферменты класса гидролаз, осуществляющие ферментативный катализ с помощью связанного в активном центре иона цинка. Функции ММП разнообразны, и нарушение баланса их активности может быть одним из этиологических факторов различных заболеваний. В данном обзоре рассмотрена классификация ММП человека, особенности их структуры и регуляции, а также роль в физиологических и патологических процессах в организме человека. Приведен перечень наиболее изученных на настоящий момент полиморфных вариантов генов MMП, описаны их функциональные эффекты и представлены результаты ассоциативных исследований. Matrix metalloproteinases (MMPs) are enzymes of the hydrolase class that carry out enzymatic catalysis with the help of a zinc ion bound in the active center. MMP functions are diverse, and a disturbance in the balance of their activity may be one of the etiological factors of various diseases. In this review, the classification of human MMP, the features of their structure and regulation, as well as the role in physiological and pathological processes in the human body are considered. A list of the most studied polymorphic versions of MMP genes has been given, their functional effects have been described, and the results of associative studies have been presented.


2018 ◽  
Author(s):  
Hakeem K. Henry ◽  
Sang Bok Lee

The PMo<sub>12</sub>-PPy heterogeneous cathode was synthesized electrochemically. In doing so, the PMo<sub>12</sub> redox-active material was impregnated throughout the conductive polymer matrix of the poly(pyrrole) nanowires. All chemicals and reagents used were purchased from Sigma-Aldrich. Anodized aluminum oxide (AAO) purchased from Whatman served as the porous hard template for nanowire deposition. A thin layer of gold of approximately 200nm was sputtered onto the disordered side of the AAO membrane to serve as the current collector. Copper tape was connected to the sputtered gold for contact and the device was sealed in parafilm with heat with an exposed area of 0.32 cm<sup>2</sup> to serve as the electroactive area for deposition. All electrochemical synthesis and experiments were conducted using a Bio-Logic MPG2 potentiostat. The deposition was carried out using a 3-electrode beaker cell setup with a solution of acetonitrile containing 5mM and 14mM of the phosphomolybdic acid and pyrrole monomer, respectively. The synthesis was achieved using chronoamperometry to apply a constant voltage of 0.8V vs. Ag/AgCl (BASi) to oxidatively polymerize the pyrrole monomer to poly(pyrrole). To prevent the POM from chemically polymerizing the pyrrole, an injection method was used in which the pyrrole monomer was added to the POM solution only after the deposition voltage had already been applied. The deposition was well controlled by limiting the amount of charge transferred to 300mC. Following deposition, the AAO template was removed by soaking in 3M sodium hydroxide (NaOH) for 20 minutes and rinsed several times with water. After synthesis, all cathodes underwent electrochemical testing to determine their performance using cyclic voltammetry and constant current charge-discharge cycling in 0.1 M Mg(ClO<sub>4</sub>)<sub>2</sub>/PC electrolyte. The cathodes were further characterized using scanning electron microscopy (SEM), transmission electron microscopy (TEM), scanning transmission electron microscopy (STEM), and x-ray photoelectron spectroscopy (XPS).


2019 ◽  
Author(s):  
Yujie Tu ◽  
Junkai Liu ◽  
Haoke Zhang ◽  
Qian Peng ◽  
Jacky W. Y. Lam ◽  
...  

Aggregation-induced emission (AIE) is an unusual photophysical phenomenon and provides an effective and advantageous strategy for the design of highly emissive materials in versatile applications such as sensing, imaging, and theragnosis. "Restriction of intramolecular motion" is the well-recognized working mechanism of AIE and have guided the molecular design of most AIE materials. However, it sometimes fails to be workable to some heteroatom-containing systems. Herein, in this work, we take more than one excited state into account and specify a mechanism –"restriction of access to dark state (RADS)" – to explain the AIE effect of heteroatom-containing molecules. An anthracene-based zinc ion probe named APA is chosen as the model compound, whose weak fluorescence in solution is ascribed to the easy access from the bright (π,π*) state to the closelying dark (n,π*) state caused by the strong vibronic coupling of the two excited states. By either metal complexation or aggregation, the dark state is less accessible due to the restriction of the molecular motion leading to the dark state and elevation of the dark state energy, thus the emission of the bright state is restored. RADS is found to be powerful in elucidating the photophysics of AIE materials with excited states which favor non-radiative decay, including overlap-forbidden states such as (n,π*) and CT states, spin-forbidden triplet states, which commonly exist in heteroatom-containing molecules.


Sign in / Sign up

Export Citation Format

Share Document