Measurement of Size, Number Concentration and Velocity of Aerosol Particles using an optical particle counter

1993 ◽  
Vol 10 (2) ◽  
pp. 56-61 ◽  
Author(s):  
Bernd Sachweh
1987 ◽  
Vol 30 (4) ◽  
pp. 39-42
Author(s):  
Y. Kousaka ◽  
T. Niida ◽  
Y. Tanaka ◽  
Y. Sato ◽  
H. Kano ◽  
...  

A new monitoring system has been developed for continuously measuring the concentration of total nonvolatile impurities in ultrapure water. The measuring method is based on the principle of determining the Residue After Evaporation (RAE) of atomized droplets, taking account of the particle deposition loss. The system consists of a water atomizing unit, a droplet evaporating and drying unit, an air diluter, a fine particle counter, etc. For the particle counter, a Condensation Nucleus Counter (CMC) is used; this counter is a mixing type, able to detect particles larger than 0.01 μm. It is verified from both the theoretical analysis and the experimental results that this monitor can rapidly detect very low impurity concentrations by counting the number concentration of aerosol particles.


2021 ◽  
Vol 14 (9) ◽  
pp. 6101-6118
Author(s):  
Zixia Liu ◽  
Martin Osborne ◽  
Karen Anderson ◽  
Jamie D. Shutler ◽  
Andy Wilson ◽  
...  

Abstract. We first validate the performance of the Portable Optical Particle Spectrometer (POPS), a small light-weight and high sensitivity optical particle counter, against a reference scanning mobility particle sizer (SMPS) for a month-long deployment in an environment dominated by biomass burning aerosols. Subsequently, we examine any biases introduced by operating the POPS on a quadcopter drone, a DJI Matrice 200 V2. We report the root mean square difference (RMSD) and mean absolute difference (MAD) in particle number concentrations (PNCs) when mounted on the UAV and operating on the ground and when hovering at 10 m. When wind speeds are low (less than 2.6 m s−1), we find only modest differences in the RMSDs and MADs of 5 % and 3 % when operating at 10 m altitude. When wind speeds are between 2.6 and 7.7 m s−1 the RMSDs and MADs increase to 26.2 % and 19.1 %, respectively, when operating at 10 m altitude. No statistical difference in PNCs was detected when operating on the UAV in either ascent or descent. We also find size distributions of aerosols in the accumulation mode (defined by diameter, d, where 0.1 ≤ d ≤ 1 µm) are relatively consistent between measurements at the surface and measurements at 10 m altitude, while differences in the coarse mode (here defined by d >  1 µm) are universally larger. Our results suggest that the impact of the UAV rotors on the POPS PNCs are small at low wind speeds, but when operating under a higher wind speed of up to 7.6 m s−1, larger discrepancies occur. In addition, it appears that the POPS measures sub-micron aerosol particles more accurately than super-micron aerosol particles when airborne on the UAV. These measurements lay the foundations for determining the magnitude of potential errors that might be introduced into measured aerosol particle size distributions and concentrations owing to the turbulence created by the rotors on the UAV.


2021 ◽  
Author(s):  
Zixia Liu ◽  
Martin Osborne ◽  
Jim Haywood ◽  
Karen Anderson ◽  
Jamie D. Shulter ◽  
...  

Abstract. The Printed Optical Particle Spectrometer (POPS) is an advanced and small low-cost, light-weight, and high-sensitivity optical particle counter (OPC), particularly designed for deployed on unpiloted aerial vehicles (UAVs) and balloon sondes. We report the performance of the POPS against a reference scanning mobility particle sizer (SMPS) and an airborne passive cavity aerosol spectrometer probe (PCASP) while the POPS is operated on the ground and also while operated on a quadcopter drone, a DJI Matrice 200 V2. This is the first such documented test of the performance of a POPS instrument on a UAV. We investigate the root mean square difference (RMSD) and mean absolute difference (MAD) in particle number concentrations (PNCs) when operating on the ground and on the Matrice 200. When windspeeds are less than 2.6 m/s, we find only modest differences in the RMSDs and MADs of 2.4 % and 2.3 % respectively when operating on the ground, and to 5 % and 3 % when operating at 10m altitude. When windspeeds are greater than 2.6 m/s but less than 7.7 m/s the RMSDs and MADs increase to 10.2 % and 7.8 % respectively when operating on the ground, and 26.2 % and 19.1 %, respectively when operating at 10m altitude. No statistical difference in PNCs was detected when operating on the UAV in either ascent or descent. We also find size distributions of aerosols in the accumulation mode (here defined by diameter, d, where 0.1 ≤ d ≤ 1 µm) are relatively consistent between measurements at the surface and measurements at 10m altitude with RMSD and MAD of less than 21.6 % and 15.7 %, respectively. However, the differences between coarse mode (here defined by d > 1 µm) are universally larger than those measured at the surface with a RMSD and MAD approaching 49.5 % and 40.4 %. Our results suggest that the impact of the UAV rotors on the POPS does not unduly affect the performance of the POPS for wind speed less than 2.6 m/s, but when operating under higher wind speed of up to 7.6 m/s, larger discrepancies are noted. In addition to this, it appears that the POPS measures sub-micron aerosol particles more accurately than super-micron aerosol particles when airborne on the UAV. These measurements lay the foundations for determining the magnitude of potential errors that might be introduced into measured aerosol particle size distributions and concentrations owing to the turbulence created by the rotors on the UAV.


Author(s):  
S. Bezantakos ◽  
M. Costi ◽  
K. Barmpounis ◽  
P. Antoniou ◽  
P. Vouterakos ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document