Simple Support-Based Distributed Search

2006 ◽  
pp. 159-170
Author(s):  
Peter Harvey ◽  
Chee Fon Chang ◽  
Aditya Ghose
Keyword(s):  
Distributed Search ◽  
Simple Support

Preliminary Investigation on the Flexural Behaviour of Steel Fibre Reinforced Self-Compacting Concrete Ribbed Slab

2018 ◽  
Vol 15 (1) ◽  
pp. 31
Author(s):  
Nur Aiman Suparlan ◽  
Muhammad Azrul Ku Ayob ◽  
Hazrina Ahmad ◽  
Siti Hawa Hamzah ◽  
Mohd Hisbany Mohd Hashim
Keyword(s):  
Ultimate Load ◽  
Steel Fibre ◽  
Preliminary Investigation ◽  
Bending Test ◽  
Flexural Behaviour ◽  
Self Compacting Concrete ◽  
Two Samples ◽  
Simple Support ◽  
Set Up ◽  
Ultimate Load Carrying Capacity

A ribbed slab structure has the advantage in the reduction of concrete volume in between the ribs resulting in a lower structural self-weight. In order to overcome the drawbacks in the construction process, the application of steel fibre self-compacting concrete (SCFRC) is seen as an alternative material to be used in the slab. This preliminary investigation was carried out to investigate the flexural behaviour of steel fibre self-compacting concrete (SCFRC) as the main material in ribbed slab omitting the conventional reinforcements. Two samples of ribbed slab were prepared for this preliminary study; 2-ribbed and 3-ribbed in 1 m width to identify the effect of the geometry to the slab’s flexural behaviour. The dimension of both samples is 2.5 m x 1 m with 150 mm thickness. The compressive strength of the mix is 48.6 MPa based on the cubes tested at 28 days. Load was applied to failure by using the four point bending test set-up with simple support condition. The result of the experiment recorded ultimate load carrying capacity at 30.68 kN for the 2-ribbed slab and 25.52 kN for 3-ribbed slab. From the results, the ultimate load of the 2-ribbed sample exceeds 3-ribbed by approximately 20%. This proved that even with lower concrete volume, the sample can still withstand an almost similar ultimate load. Cracks was also observed and recorded with the maximum crack width of 2 mm. It can be concluded that the steel fibres do have the potential to withstand flexural loadings. Steel fibre reduces macro-crack forming into micro-cracks and improves concrete ductility, as well as improvement in deflection. This shows that steel fibre reinforced self-compacting concrete is practical as it offers good concrete properties as well as it can be mixed, placed easier without compaction. 

scholarly journals Modelling of Amplitude Modulated Vocal Fry Glottal Area Waveforms Using an Analysis-by-Synthesis Approach

2021 ◽  
Vol 11 (5) ◽  
pp. 1990
Author(s):  
Vinod Devaraj ◽  
Philipp Aichinger
Keyword(s):  
Voice Quality ◽  
Low Frequency ◽  
Voice Disorder ◽  
Support Vector ◽  
Svm Classifier ◽  
Power Spectral ◽  
Analysis By Synthesis ◽  
Simple Support ◽  
Frequency Modulations ◽  
Synthesis Approach

The characterization of voice quality is important for the diagnosis of a voice disorder. Vocal fry is a voice quality which is traditionally characterized by a low frequency and a long closed phase of the glottis. However, we also observed amplitude modulated vocal fry glottal area waveforms (GAWs) without long closed phases (positive group) which we modelled using an analysis-by-synthesis approach. Natural and synthetic GAWs are modelled. The negative group consists of euphonic, i.e., normophonic GAWs. The analysis-by-synthesis approach fits two modelled GAWs for each of the input GAW. One modelled GAW is modulated to replicate the amplitude and frequency modulations of the input GAW and the other modelled GAW is unmodulated. The modelling errors of the two modelled GAWs are determined to classify the GAWs into the positive and the negative groups using a simple support vector machine (SVM) classifier with a linear kernel. The modelling errors of all vocal fry GAWs obtained using the modulating model are smaller than the modelling errors obtained using the unmodulated model. Using the two modelling errors as predictors for classification, no false positives or false negatives are obtained. To further distinguish the subtypes of amplitude modulated vocal fry GAWs, the entropy of the modulator’s power spectral density and the modulator-to-carrier frequency ratio are obtained.

Reliability of a Distributed Search Engine for Fresh Information Retrieval in Large-Scale Intranet

2006 ◽  
pp. 203-216
Author(s):  
Nobuyoshi Sato ◽  
Minoru Udagawa ◽  
Minoru Uehara ◽  
Yoshifumi Sakai ◽  
Hideki Mori
Keyword(s):  
Information Retrieval ◽  
Search Engine ◽  
Large Scale ◽  
Distributed Search

A Distributed Search and Simulation Method for Job Flow Scheduling

SIMULATION ◽  
1997 ◽  
Vol 68 (6) ◽  
pp. 377-401 ◽  
Author(s):  
S.R. Jernigan ◽  
S. Ramaswamy ◽  
K.S. Barber
Keyword(s):  
Simulation Method ◽  
Distributed Search

Calculation for Elastic Global Buckling of Sandwich Plates with Ribs

2012 ◽  
Vol 188 ◽  
pp. 25-30 ◽  
Author(s):  
Qi Chao Xue ◽  
Guang Ping Zou ◽  
Ye Wu ◽  
Hai Lin Xiong ◽  
Meng Chai
Keyword(s):  
Energy Method ◽  
Sandwich Plate ◽  
Plate Theory ◽  
Sandwich Plates ◽  
Buckling Stress ◽  
Global Buckling ◽  
Simple Support ◽  
Rectangular Sandwich Plate ◽  
Two Sides ◽  
Rectangular Sandwich Plates

Based on Reissner’s sandwich plate theory, the critical globlal buckling equation of sandwich plate with ribs is deduced by energy method under simple support boundary conditions. And the critical buckling solution is obtained and discussed here. Afterwards a rectangular sandwich plate with steel faceplate and polyurthane core is taken as an example. The influence on critical global buckling stress with different inertia moments in rectangular sandwich plates are discussed. simularly the effect of the lengh ratio of two sides and the thickness of rectangular sandwich plate are also studied.

Sign in / Sign up

Export Citation Format

Share Document