Theory of Boundary Layer Instability: Particle or Wave?

2006 ◽  
pp. 483-494 ◽  
Author(s):  
Ka-Kheng Tan
Keyword(s):  
Boundary Layer ◽  
Boundary Layer Instability

scholarly journals Boundary layer instability over a rotating slender cone under non-axial inflow

2021 ◽  
Vol 910 ◽  
Author(s):  
Sumit Tambe ◽  
Ferry Schrijer ◽  
Arvind Gangoli Rao ◽  
Leo Veldhuis
Keyword(s):  
Boundary Layer ◽  
Boundary Layer Instability

Abstract

scholarly journals Energy dissipation caused by boundary layer instability at vanishing viscosity – ERRATUM

2018 ◽  
Vol 857 ◽  
pp. 952-952
Author(s):  
Natacha Nguyen van yen ◽  
Matthias Waidmann ◽  
Rupert Klein ◽  
Marie Farge ◽  
Kai Schneider
Keyword(s):  
Boundary Layer ◽  
Energy Dissipation ◽  
Vanishing Viscosity ◽  
Boundary Layer Instability

Acoustic receptivity and evolution of two-dimensional and oblique disturbances in a Blasius boundary layer

2001 ◽  
Vol 432 ◽  
pp. 69-90 ◽  
Author(s):  
RUDOLPH A. KING ◽  
KENNETH S. BREUER
Keyword(s):  
Boundary Layer ◽  
Surface Roughness ◽  
Acoustic Wave ◽  
Three Dimensional ◽  
Two Dimensional ◽  
Surface Waviness ◽  
S Wave ◽  
Boundary Layer Instability ◽  
Blasius Boundary Layer ◽  
Tollmien Schlichting

An experimental investigation was conducted to examine acoustic receptivity and subsequent boundary-layer instability evolution for a Blasius boundary layer formed on a flat plate in the presence of two-dimensional and oblique (three-dimensional) surface waviness. The effect of the non-localized surface roughness geometry and acoustic wave amplitude on the receptivity process was explored. The surface roughness had a well-defined wavenumber spectrum with fundamental wavenumber kw. A planar downstream-travelling acoustic wave was created to temporally excite the flow near the resonance frequency of an unstable eigenmode corresponding to kts = kw. The range of acoustic forcing levels, ε, and roughness heights, Δh, examined resulted in a linear dependence of receptivity coefficients; however, the larger values of the forcing combination εΔh resulted in subsequent nonlinear development of the Tollmien–Schlichting (T–S) wave. This study provides the first experimental evidence of a marked increase in the receptivity coefficient with increasing obliqueness of the surface waviness in excellent agreement with theory. Detuning of the two-dimensional and oblique disturbances was investigated by varying the streamwise wall-roughness wavenumber αw and measuring the T–S response. For the configuration where laminar-to-turbulent breakdown occurred, the breakdown process was found to be dominated by energy at the fundamental and harmonic frequencies, indicative of K-type breakdown.

Influences of Oblique Surface Corrugation on Boundary-Layer Instability

2014 ◽  
Vol 83 (8) ◽  
pp. 084402 ◽  
Author(s):  
Mochamad Dady Ma’mun ◽  
Masahito Asai
Keyword(s):  
Boundary Layer ◽  
Surface Corrugation ◽  
Boundary Layer Instability

Boundary-layer instability noise on aerofoils

1999 ◽  
Vol 382 ◽  
pp. 27-61 ◽  
Author(s):  
EMMA C. NASH ◽  
MARTIN V. LOWSON ◽  
ALAN McALPINE
Keyword(s):  
Boundary Layer ◽  
Boundary Layer Separation ◽  
Noise Generation ◽  
Tonal Noise ◽  
Instability Waves ◽  
S Waves ◽  
Pressure Surface ◽  
Boundary Layer Instability ◽  
Moderate Reynolds Number ◽  
Tollmien Schlichting

An experimental and theoretical investigation has been carried out to understand the tonal noise generation mechanism on aerofoils at moderate Reynolds number. Experiments were conducted on a NACA0012 aerofoil section in a low-turbulence closed working section wind tunnel. Narrow band acoustic tones were observed up to 40 dB above background noise. The ladder structure of these tones was eliminated by modifying the tunnel to approximate to anechoic conditions. High-resolution flow velocity measurements have been made with a three-component laser-Doppler anemometer (LDA) which have revealed the presence of strongly amplified boundary-layer instabilities in a region of separated shear flow just upstream of the pressure surface trailing edge, which match the frequency of the acoustic tones. Flow visualization experiments have shown these instabilities to roll up to form a regular Kármán-type vortex street.A new mechanism for tonal noise generation has been proposed, based on the growth of Tollmien–Schlichting (T–S) instability waves strongly amplified by inflectional profiles in the separating laminar shear layer on the pressure surface of the aerofoil. The growth of fixed frequency, spatially growing boundary-layer instability waves propagating over the aerofoil pressure surface has been calculated using experimentally obtained boundary-layer characteristics. The effect of boundary-layer separation has been incorporated into the model. Frequency selection and prediction of T–S waves are in remarkably good agreement with experimental data.

An experiment on the stability of hypersonic laminar boundary layers

1960 ◽  
Vol 7 (3) ◽  
pp. 385-396 ◽  
Author(s):  
Anthony Demetriades
Keyword(s):  
Boundary Layer ◽  
Flat Surface ◽  
Hypersonic Boundary Layer ◽  
Natural Disturbances ◽  
Hot Wire ◽  
Amplitude Variation ◽  
Laminar Boundary Layers ◽  
Boundary Layer Instability ◽  
The Stability ◽  
Maximum Amplification

An experimental investigation of the hydrodynamic stability of the laminar hypersonic boundary layer was carried out with the aid of a hot-wire anemometer. The case investigated was that of a flat surface at zero angle of attack and no heat transfer.The streamwise amplitude variation of both natural disturbances and of disturbances artifically excited with a siren mechanism was studied. In both cases it was found that such small fluctuations amplify for certain ranges of frequency and Reynolds number Rθ, and damp for others. The demarcation boundaries for the amplification (instability) zone were found to resemble the corresponding limits of boundary-layer instability at lower speeds. A ‘line of maximum amplification’ of disturbances was also found. The amplification rates and hence the degree of selectivity of the hypersonic layer were found, however, to be considerably lower than those at the lower speeds. The disturbances selected by the layer for maximum amplifications have a wavelength which was estimated to be about twenty times the boundary-layer thickness δ.

High-Speed Boundary Layer Instability on a Flat Plate at Angle of Attack with Porous Walls

2022 ◽  
Author(s):  
Samantha A. Miller ◽  
Derek Mamrol ◽  
Joel J. Redmond ◽  
Karl Jantze ◽  
Carlo Scalo ◽  
...  
Keyword(s):  
Boundary Layer ◽  
Flat Plate ◽  
High Speed ◽  
Angle Of Attack ◽  
Boundary Layer Instability ◽  
Porous Walls
Sign in / Sign up

Export Citation Format

Share Document