Heterogeneous Nucleation in a 2-D Model of Martensitic Transformation with Volume Changes

Author(s):  
Wenwu Cao ◽  
Rajeev Ahluwalia
Author(s):  
R-R. Lee

Partially-stabilized ZrO2 (PSZ) ceramics have considerable potential for advanced structural applications because of their high strength and toughness. These properties derive from small tetragonal ZrO2 (t-ZrO2) precipitates in a cubic (c) ZrO2 matrix, which transform martensitically to monoclinic (m) symmetry under applied stresses. The kinetics of the martensitic transformation is believed to be nucleation controlled and the nucleation is always stress induced. In situ observation of the martensitic transformation using transmission electron microscopy provides considerable information about the nucleation and growth aspects of the transformation.


Author(s):  
J. W. Mellowes ◽  
C. M. Chun ◽  
I. A. Aksay

Mullite (3Al2O32SiO2) can be fabricated by transient viscous sintering using composite particles which consist of inner cores of a-alumina and outer coatings of amorphous silica. Powder compacts prepared with these particles are sintered to almost full density at relatively low temperatures (~1300°C) and converted to dense, fine-grained mullite at higher temperatures (>1500°C) by reaction between the alumina core and the silica coating. In order to achieve complete mullitization, optimal conditions for coating alumina particles with amorphous silica must be achieved. Formation of amorphous silica can occur in solution (homogeneous nucleation) or on the surface of alumina (heterogeneous nucleation) depending on the degree of supersaturation of the solvent in which the particles are immersed. Successful coating of silica on alumina occurs when heterogeneous nucleation is promoted and homogeneous nucleation is suppressed. Therefore, one key to successful coating is an understanding of the factors such as pH and concentration that control silica nucleation in aqueous solutions. In the current work, we use TEM to determine the optimal conditions of this processing.


Author(s):  
K.B. Reuter ◽  
D.B. Williams ◽  
J.I. Goldstein

In the Fe-Ni system, although ordered FeNi and ordered Ni3Fe are experimentally well established, direct evidence for ordered Fe3Ni is unconvincing. Little experimental data for Fe3Ni exists because diffusion is sluggish at temperatures below 400°C and because alloys containing less than 29 wt% Ni undergo a martensitic transformation at room temperature. Fe-Ni phases in iron meteorites were examined in this study because iron meteorites have cooled at slow rates of about 10°C/106 years, allowing phase transformations below 400°C to occur. One low temperature transformation product, called clear taenite 2 (CT2), was of particular interest because it contains less than 30 wtZ Ni and is not martensitic. Because CT2 is only a few microns in size, the structure and Ni content were determined through electron diffraction and x-ray microanalysis. A Philips EM400T operated at 120 kV, equipped with a Tracor Northern 2000 multichannel analyzer, was used.


Author(s):  
Jenö Beyer ◽  
Lajos Tóth

The structural changes during reversible martensitic transformation of near-equiatomic NiTi alloys can best be studied in TEM at around room temperature. Ternary additions like Mn offer this possibility by suppressing the Ms temperature below RT. Besides the stable intermetallic phases (Ti2Ni, TiNi, TiNi3) several metastable phases with various crystallographic structures (rhombohedral, hexagonal, monoclinic, cubic) have also been reported to precipitate due to suitable annealing procedures.TiNi:Mn samples with 0.9 and 1.3 at% Mn were arc melted in argon atmosphere and homogenized at 948 °C for 72 hours in high vacuum in an infrared furnace. After spark cutting slices of 0.2 mm, TEM specimens were prepared by electrochemical polishing with the twin-jet technique in methanol - perchloric acid electrolyte. The TEM study was carried out in a JEOL 200 CX analytical electron microscope.In this paper a new intermetallic phase is reported which has been observed in both samples by TEM during the martensitic transformation process.


1997 ◽  
Vol 94 ◽  
pp. 1816-1826 ◽  
Author(s):  
M Glazov ◽  
LM Pavlova ◽  
SV Stankus
Keyword(s):  

1995 ◽  
Vol 05 (C8) ◽  
pp. C8-973-C8-978
Author(s):  
M. Jurado ◽  
Ll. Mañosa ◽  
A. González-Comas ◽  
C. Stassis ◽  
A. Planes

2003 ◽  
Vol 112 ◽  
pp. 495-498
Author(s):  
V. V. Kokorin ◽  
L. E. Kozlova ◽  
A. N. Titenko

Sign in / Sign up

Export Citation Format

Share Document