Numerical Analysis of the Wind Turbine Pitch Bearing Raceway Tribo-contact due to Cyclic Loading Under Constant Pitch Angle

Author(s):  
David Cubillas ◽  
Mireia Olave ◽  
Iñigo Llavori ◽  
Ibai Ulacia ◽  
Jon Larrañaga ◽  
...  
2016 ◽  
Vol 138 (5) ◽  
Author(s):  
Mohamed M. Hammam ◽  
David H. Wood ◽  
Curran Crawford

A simple unsteady blade element analysis is used to account for the effect of the trailing wake on the induced velocity of a wind turbine rotor undergoing fast changes in pitch angle. At sufficiently high tip speed ratio, the equation describing the thrust of the element reduces to a first order, nonlinear Riccti's equation which is solved in a closed form for a ramp change in pitch followed by a constant pitch. Finite tip speed ratio results in a first order, nonlinear Abel's equation. The unsteady aerodynamic forces on the NREL VI wind turbine are analyzed at different pitch rates and tip speed ratio, and it is found that the overshoot in the forces increases as the tip speed ratio and/or the pitch angle increase. The analytical solution of the Riccati's equation and numerical solution of Abel's equation gave very similar results at high tip speed ratio but the solutions differ as the tip speed ratio reduces, partly because the Abel's equation was found to magnify the error of assuming linear lift at low tip speed ratio. The unsteady tangential induction factor is expressed in the form of first order differential equation with the time constant estimated using Jowkowsky's vortex model and it was found that it is negligible for large tip speed ratio operation.


2011 ◽  
Vol 347-353 ◽  
pp. 2323-2329
Author(s):  
Zhi Chao Lan ◽  
Lin Tao Hu ◽  
Yin Xue ◽  
De Liang Zen

An increasing number of large wind turbines with a variable-speed variable pitch control mechanism are developed to improve the response speed of wind turbines and get maximum active power .Designing a reasonable pitch control system requires both a good control scheme and a more accurate wind turbine model. Base on the analysis of wind turbines’ principle, a local linearization model of wind turbine is built by using linearization method of small deviation in this paper. The model’s inputs are the data of wind speed and pitch angle, and the output is the active power. The accuracy of the model is verified by studying the active power output of wind turbine under different circumstances in which the pitch angle changes with a constant wind speed and the wind speed changes with a constant pitch angle. At the same time, this paper provides pitch control program based on internal model control after analyzing the disadvantages of PID pitch controller. When the wind speed is beyond the rating, the active power can be limited reasonably around the power rating of wind turbines by adjusting the pitch angle.


2021 ◽  
Vol 80 ◽  
pp. 103079
Author(s):  
Hongwang Ma ◽  
Zhiyue Lu ◽  
Yutao Li ◽  
Chen Chen ◽  
Jun Yang

2012 ◽  
Vol 499 ◽  
pp. 259-264
Author(s):  
Qi Yao ◽  
Ying Xue Yao ◽  
Liang Zhou ◽  
S.Y. Zheng

This paper presents a simulation study of an H-type vertical axis wind turbine. Two dimensional CFD model using sliding mesh technique was generated to help understand aerodynamics performance of this wind turbine. The effect of the pith angle on H-type vertical axis wind turbine was studied based on the computational model. As a result, this wind turbine could get the maximum power coefficient when pitch angle adjusted to a suited angle, furthermore, the effects of pitch angle and azimuth angle on single blade were investigated. The results will provide theoretical supports on study of variable pitch of wind turbine.


Author(s):  
Ali Al-Abadi ◽  
YouJin Kim ◽  
Jin-young Park ◽  
Hyunjin Kang ◽  
Özgür Ertunc ◽  
...  

An optimization method that changes the control strategy of the Horizontal Axis Wind Turbine (HAWT) from passive- to active-pitch has been developed. The method aims to keep the rated power constant by adjusting the blade pitch angle while matching the rotor and the drive torques. The method is applied to an optimized wind turbine model. Further, numerical simulations were performed to validate the developed method and for further investigations of the flow behavior over the blades.


Sign in / Sign up

Export Citation Format

Share Document