Hybrid Sensorless MPPT Algorithm for Detecting Fast Irradiation Changes and Partial Shading Conditions on PV Systems

Author(s):  
Balaji Veerasamy ◽  
Takaharu Takeshita ◽  
Viswanath Anbazhagan ◽  
Angamuthu Ananth ◽  
Selvagopinath Mayandi
Keyword(s):  
Electronics ◽  
2021 ◽  
Vol 10 (9) ◽  
pp. 1121
Author(s):  
Kamran Ali Khan Niazi ◽  
Yongheng Yang ◽  
Tamas Kerekes ◽  
Dezso Sera

A reconfiguration technique using a switched-capacitor (SC)-based voltage equalizer differential power processing (DPP) concept is proposed in this paper for photovoltaic (PV) systems at a cell/subpanel/panel-level. The proposed active diffusion charge redistribution (ADCR) architecture increases the energy yield during mismatch and adds a voltage boosting capability to the PV system under no mismatch by connected the available PV cells/panels in series. The technique performs a reconfiguration by measuring the PV cell/panel voltages and their irradiances. The power balancing is achieved by charge redistribution through SC under mismatch conditions, e.g., partial shading. Moreover, PV cells/panels remain in series under no mismatch. Overall, this paper analyzes, simulates, and evaluates the effectiveness of the proposed DPP architecture through a simulation-based model prepared in PSIM. Additionally, the effectiveness is also demonstrated by comparing it with existing conventional DPP and traditional bypass diode architecture.


Energies ◽  
2021 ◽  
Vol 14 (8) ◽  
pp. 2308
Author(s):  
Kamran Ali Khan Niazi ◽  
Yongheng Yang ◽  
Tamas Kerekes ◽  
Dezso Sera

Partial shading affects the energy harvested from photovoltaic (PV) modules, leading to a mismatch in PV systems and causing energy losses. For this purpose, differential power processing (DPP) converters are the emerging power electronic-based topologies used to address the mismatch issues. Normally, PV modules are connected in series and DPP converters are used to extract the power from these PV modules by only processing the fraction of power called mismatched power. In this work, a switched-capacitor-inductor (SCL)-based DPP converter is presented, which mitigates the non-ideal conditions in solar PV systems. A proposed SCL-based DPP technique utilizes a simple control strategy to extract the maximum power from the partially shaded PV modules by only processing a fraction of the power. Furthermore, an operational principle and loss analysis for the proposed converter is presented. The proposed topology is examined and compared with the traditional bypass diode technique through simulations and experimental tests. The efficiency of the proposed DPP is validated by the experiment and simulation. The results demonstrate the performance in terms of higher energy yield without bypassing the low-producing PV module by using a simple control. The results indicate that achieved efficiency is higher than 98% under severe mismatch (higher than 50%).


Energies ◽  
2021 ◽  
Vol 14 (3) ◽  
pp. 751
Author(s):  
Mariam A. Sameh ◽  
Mostafa I. Marei ◽  
M. A. Badr ◽  
Mahmoud A. Attia

During the day, photovoltaic (PV) systems are exposed to different sunlight conditions in addition to partial shading (PS). Accordingly, maximum power point tracking (MPPT) techniques have become essential for PV systems to secure harvesting the maximum possible power from the PV modules. In this paper, optimized control is performed through the application of relatively newly developed optimization algorithms to PV systems under Partial Shading (PS) conditions. The initial value of the duty cycle of the boost converter is optimized for maximizing the amount of power extracted from the PV arrays. The emperor penguin optimizer (EPO) is proposed not only to optimize the initial setting of duty cycle but to tune the gains of controllers used for the boost converter and the grid-connected inverter of the PV system. In addition, the performance of the proposed system based on the EPO algorithm is compared with another newly developed optimization technique based on the cuttlefish algorithm (CFA). Moreover, particle swarm optimization (PSO) algorithm is used as a reference algorithm to compare results with both EPO and CFA. PSO is chosen since it is an old, well-tested, and effective algorithm. For the evaluation of performance of the proposed PV system using the proposed algorithms under different PS conditions, results are recorded and introduced.


Energies ◽  
2021 ◽  
Vol 14 (9) ◽  
pp. 2521
Author(s):  
Alfredo Gil-Velasco ◽  
Carlos Aguilar-Castillo

There are multiples conditions that lead to partial shading conditions (PSC) in photovoltaic systems (PV). Under these conditions, the harvested energy decreases in the PV system. The maximum power point tracking (MPPT) controller aims to harvest the greatest amount of energy even under partial shading conditions. The simplest available MPPT algorithms fail on PSC, whereas the complex ones are effective but require high computational resources and experience in this type of systems. This paper presents a new MPPT algorithm that is simple but effective in tracking the global maximum power point even in PSC. The simulation and experimental results show excellent performance of the proposed algorithm. Additionally, a comparison with a previously proposed algorithm is presented. The comparison shows that the proposal in this paper is faster in tracking the maximum power point than complex algorithms.


Energies ◽  
2021 ◽  
Vol 14 (13) ◽  
pp. 3863
Author(s):  
Tiago Alves ◽  
João Paulo N. Torres ◽  
Ricardo A. Marques Lameirinhas ◽  
Carlos A. F. Fernandes

The effect of partial shading in photovoltaic (PV) panels is one of the biggest problems regarding power losses in PV systems. When the irradiance pattern throughout a PV panel is inequal, some cells with the possibility of higher power production will produce less and start to deteriorate. The objective of this research work is to present, test and discuss different techniques to help mitigate partial shading in PV panels, observing and commenting the advantages and disadvantages for different PV technologies under different operating conditions. The motivation is to contribute with research, simulation, and experimental work. Several state-of-the-artsolutions to the problem will be presented: different topologies in the interconnection of the panels; different PV system architectures, and also introducing new solution hypotheses, such as different cell interconnections topologies. Alongside, benefits and limitations will be discussed. To obtain actual results, the simulation work was conducted by creating MATLAB/Simulink models for each different technique tested, all centered around the 1M5P PV cell model. The several techniques tested will also take into account different patterns and sizes of partial shading, different PV panel technologies, different values of source irradiation, and different PV array sizes. The results will be discussed and validated by experimental tests.


Energies ◽  
2021 ◽  
Vol 14 (4) ◽  
pp. 953
Author(s):  
Ali M. Eltamaly

The problem of partial shading has serious effects on the performance of photovoltaic (PV) systems. Adding a bypass diode in shunt to each PV module avoids hot-spot phenomena, but causes multi-peaks in the power–voltage (P–V) characteristics of the PV array, which cause traditional maximum power point tracking (MPPT) techniques to become trapped in local peaks. This problem has forced researchers to search for smart techniques to track global peaks and prevent the possibility of convergence at local peaks. Swarm optimization techniques have been used to fill this shortcoming; unfortunately, however, these techniques suffer from unacceptably long convergence time. Cuckoo search (CS) is one of the fastest and most reliable optimization techniques, making it an ideal option to be used as an MPPT of PV systems under dynamic partial shading conditions. The standard CS algorithm has a long conversion time, high failure rate, and high oscillations at steady state; this paper aims to overcome these problems and to fill this research gap by improving the performance of the CS. The results obtained from this technique are compared to five swarm optimization techniques. The comparison study shows the superiority of the improved CS strategy introduced in this paper over the other swarm optimization techniques.


2021 ◽  
Author(s):  
Angelo G. Santos ◽  
Filipe A. C. Bahia ◽  
Fabiano F. Costa ◽  
Andre P. N. Tahim ◽  
Leandro L. O. Carralero
Keyword(s):  

2019 ◽  
Vol 130 ◽  
pp. 1159-1175 ◽  
Author(s):  
Mohamed A. Mohamed ◽  
Ahmed A. Zaki Diab ◽  
Hegazy Rezk

Author(s):  
Mustapha Alaoui ◽  
Hattab Maker ◽  
Azeddine Mouhsen ◽  
Hicham Hihi

In the last decades, researchers and scientists have been trending towards photovoltaic (PV) solar energy research as one of the noteworthy renewable energies. As a matter of fact, the need for a laboratory system devoted to performing measurements and experimentation on PV systems is being increased. The PV array emulator is designed to accomplish this task by reproducing accurately the electrical behavior of real PV sources. The present paper proposes thus a new control and design of PV array emulators. It is based essentially on a hybrid Damping Injection controller. The proposed control strategy circumvents obviously the existing PV emulator's limitations in terms of accuracy, speed and partial shading emulation. Several results are given and discussed to show the efficiency of the proposed system to emulate PV modules and different PV array configurations under uniform solar irradiance and partial shading conditions.


Sign in / Sign up

Export Citation Format

Share Document