An estimate of the contribution to the cross section due to the break-up of a trapped complex in the reaction of S on Co and S on Ge

1981 ◽  
Vol 301 (4) ◽  
pp. 343-347
Author(s):  
C. Barbagallo ◽  
J. Richert ◽  
A. Lejeune
Keyword(s):  
Break Up ◽  
2003 ◽  
Vol 18 (02n06) ◽  
pp. 452-455 ◽  
Author(s):  
IMAM FACHRUDDIN ◽  
CHARLOTTE ELSTER ◽  
WALTER GLÖCKLE

The pd break-up amplitude in the Faddeev scheme is calculated by employing a three-dimensional method without partial wave decomposition (PWD). In the first step and in view of higher energies only the leading term is evaluated and this for the process d(p,n)pp. A comparison with the results based on PWD reveals discrepancies in the cross section around 200 MeV. This indicates the onset of a limitation of the partial wave scheme. Also around 200 MeV relativistic effects are clearly visible and the use of relativistic kinematics shifts the cross section peak to where the experimental peak is located. The theoretical peak height, however, is wrong and calls first of all for the inclusion of rescattering terms, which are shown to be important in a nonrelativistic full Faddeev calculation in PWD.


Author(s):  
H. Tavakoli-Zaniani ◽  
M. Eslami-Kalantari ◽  
H. R. Amir-Ahmadi ◽  
M. T. Bayat ◽  
A. Deltuva ◽  
...  

AbstractA selection of measured cross sections and vector analyzing powers, $$A_{x}$$ A x and $$A_{y}$$ A y , are presented for the $$\vec {p}{d}$$ p → d break-up reaction. The data are taken with a polarized proton beam with a kinetic energy of 135 MeV using the Big Instrument for Nuclear-polarization Analysis (BINA) at KVI, the Netherlands. With this setup, $$A_{x}$$ A x is extracted for the first time for a large range of energies as well as polar and azimuthal angles of the two outgoing protons. For most of the configurations, the results at small and large relative azimuthal angles differ in behavior when comparing experimental data with the theoretical calculations. We also performed a more global comparison of our data with theoretical calculations. The cross-section results show huge values of $$\chi ^{2}$$ χ 2 /d.o.f.. The absolute values of $$\chi ^{2}$$ χ 2 /d.o.f. for the components of vector analyzing powers, $$A_{x}$$ A x and $$A_{y}$$ A y , are smaller than the ones for the cross section, partly due to larger uncertainties for these observables. However, also for these observables no satisfactory agreement is found for all angular combinations. This implies that the present models of a three-nucleon force are not able to provide a satisfactory description of experimental data.


Author(s):  
Alessandro Grassi ◽  
Jacek Golak ◽  
Roman Skibiński ◽  
Kacper Topolnicki ◽  
Henryk Witała ◽  
...  

For several decades there has been an interest in studying neutrino scattering on light nuclei, with the hope of increasing knowledge about the theory of weak interactions and electroweak unification. A study of several neutrino induced reactions on light nuclei (^22H, ^33H and ^33He) is presented here. The cross section for these reactions is evaluated using the nuclear response functions, which holds the information about the nuclear interactions and structure. This approach has been tested for break-up reactions on the deuteron before and is now extended to three-nucleon break-up reactions.


Author(s):  
V. Mizuhira ◽  
Y. Futaesaku

Previously we reported that tannic acid is a very effective fixative for proteins including polypeptides. Especially, in the cross section of microtubules, thirteen submits in A-tubule and eleven in B-tubule could be observed very clearly. An elastic fiber could be demonstrated very clearly, as an electron opaque, homogeneous fiber. However, tannic acid did not penetrate into the deep portion of the tissue-block. So we tried Catechin. This shows almost the same chemical natures as that of proteins, as tannic acid. Moreover, we thought that catechin should have two active-reaction sites, one is phenol,and the other is catechole. Catechole site should react with osmium, to make Os- black. Phenol-site should react with peroxidase existing perhydroxide.


Author(s):  
Tamotsu Ohno

The energy distribution in an electron; beam from an electron gun provided with a biased Wehnelt cylinder was measured by a retarding potential analyser. All the measurements were carried out with a beam of small angular divergence (<3xl0-4 rad) to eliminate the apparent increase of energy width as pointed out by Ichinokawa.The cross section of the beam from a gun with a tungsten hairpin cathode varies as shown in Fig.1a with the bias voltage Vg. The central part of the beam was analysed. An example of the integral curve as well as the energy spectrum is shown in Fig.2. The integral width of the spectrum ΔEi varies with Vg as shown in Fig.1b The width ΔEi is smaller than the Maxwellian width near the cut-off. As |Vg| is decreased, ΔEi increases beyond the Maxwellian width, reaches a maximum and then decreases. Note that the cross section of the beam enlarges with decreasing |Vg|.


2009 ◽  
Author(s):  
Marci Culley ◽  
Holly Angelique ◽  
Courte Voorhees ◽  
Brian John Bishop ◽  
Peta Louise Dzidic ◽  
...  

The work of multilayer glass structures for central and eccentric compression and bending are considered. The substantiation of the chosen research topic is made. The description and features of laminated glass for the structures investigated, their characteristics are presented. The analysis of the results obtained when testing for compression, compression with bending, simple bending of models of columns, beams, samples of laminated glass was made. Overview of the types and nature of destruction of the models are presented, diagrams of material operation are constructed, average values of the resistance of the cross-sections of samples are obtained, the table of destructive loads is generated. The need for development of a set of rules and guidelines for the design of glass structures, including laminated glass, for bearing elements, as well as standards for testing, rules for assessing the strength, stiffness, crack resistance and methods for determining the strength of control samples is emphasized. It is established that the strength properties of glass depend on the type of applied load and vary widely, and significantly lower than the corresponding normative values of the strength of heat-strengthened glass. The effect of the connecting polymeric material and manufacturing technology of laminated glass on the strength of the structure is also shown. The experimental values of the elastic modulus are different in different directions of the cross section and in the direction perpendicular to the glass layers are two times less than along the glass layers.


CFA Digest ◽  
2008 ◽  
Vol 38 (3) ◽  
pp. 55-56
Author(s):  
Kathryn Dixon Jost

Sign in / Sign up

Export Citation Format

Share Document