Properties of lithium ion-conducting ceramics based on rare-earth titanates

Ionics ◽  
1998 ◽  
Vol 4 (5-6) ◽  
pp. 360-363 ◽  
Author(s):  
A. G. Belous
Keyword(s):  
Rare Earth ◽  
Lithium Ion ◽  
Ion Conducting

(Rare Earth/Li) Titanates and Niobates as Ionic Conductors

2000 ◽  
Vol 658 ◽  
Author(s):  
A. Morata-Orrantia ◽  
S. García-Martín ◽  
E. Morán ◽  
U. Amador ◽  
M. A. Alario-Franco
Keyword(s):  
Rare Earth ◽  
Ionic Conductivity ◽  
Lithium Ion ◽  
Related Structure ◽  
Ionic Conductors ◽  
X Ray Diffraction ◽  
X Ray ◽  
Properties Of Materials ◽  
Ion Conducting ◽  
Diffraction Patterns

ABSTRACTThe lithium ion conducting properties of materials of composition La0.58Li0.26TiO3, Nd0.58Li0.26TiO3, La0.67Li0.25Ti0.75Al0.25O3 and La0.29Li0.12NbO3 have been compared in relation with their microstructure. All the oxides have powder X-ray diffraction patterns characteristic of a perovskite-related structure with lattice parameters a∼√2ap, b∼√2ap, c∼2ap (p refers to cubic perovskite). However, some important differences are observed in their microstructure by SAED and HRTEM. Ordering between vacancies, Li+ and La3+ or Nd3+ and twinning of the NbO6 or TiO6 octahedra tilting system are shown in La0.29Li0.12NbO3 and Nd0.58Li0.26TiO3, which are the materials having a lower ionic conductivity. The La0.58Li0.26TiO3 and La0.67Li0.25Ti0.75Al0.25O3 oxides do not show ordering between cations.

Atomic Layer Deposition of LiF and Lithium Ion Conducting (AlF3)(LiF)x Alloys Using Trimethylaluminum, Lithium Hexamethyldisilazide and Hydrogen Fluoride

2017 ◽  
Author(s):  
Younghee Lee ◽  
Daniela M. Piper ◽  
Andrew S. Cavanagh ◽  
Matthias J. Young ◽  
Se-Hee Lee ◽  
...  
Keyword(s):  
Lithium Ion ◽  
Atomic Layer ◽  
Mass Gain ◽  
Alloy Film ◽  
Ex Situ ◽  
X Ray ◽  
Layer Deposition ◽  
Ion Conducting ◽  
Good Agreement

<div>Atomic layer deposition (ALD) of LiF and lithium ion conducting (AlF<sub>3</sub>)(LiF)<sub>x</sub> alloys was developed using trimethylaluminum, lithium hexamethyldisilazide (LiHMDS) and hydrogen fluoride derived from HF-pyridine solution. ALD of LiF was studied using in situ quartz crystal microbalance (QCM) and in situ quadrupole mass spectrometer (QMS) at reaction temperatures between 125°C and 250°C. A mass gain per cycle of 12 ng/(cm<sup>2</sup> cycle) was obtained from QCM measurements at 150°C and decreased at higher temperatures. QMS detected FSi(CH<sub>3</sub>)<sub>3</sub> as a reaction byproduct instead of HMDS at 150°C. LiF ALD showed self-limiting behavior. Ex situ measurements using X-ray reflectivity (XRR) and spectroscopic ellipsometry (SE) showed a growth rate of 0.5-0.6 Å/cycle, in good agreement with the in situ QCM measurements.</div><div>ALD of lithium ion conducting (AlF3)(LiF)x alloys was also demonstrated using in situ QCM and in situ QMS at reaction temperatures at 150°C A mass gain per sequence of 22 ng/(cm<sup>2</sup> cycle) was obtained from QCM measurements at 150°C. Ex situ measurements using XRR and SE showed a linear growth rate of 0.9 Å/sequence, in good agreement with the in situ QCM measurements. Stoichiometry between AlF<sub>3</sub> and LiF by QCM experiment was calculated to 1:2.8. XPS showed LiF film consist of lithium and fluorine. XPS also showed (AlF<sub>3</sub>)(LiF)x alloy consists of aluminum, lithium and fluorine. Carbon, oxygen, and nitrogen impurities were both below the detection limit of XPS. Grazing incidence X-ray diffraction (GIXRD) observed that LiF and (AlF<sub>3</sub>)(LiF)<sub>x</sub> alloy film have crystalline structures. Inductively coupled plasma mass spectrometry (ICP-MS) and ionic chromatography revealed atomic ratio of Li:F=1:1.1 and Al:Li:F=1:2.7: 5.4 for (AlF<sub>3</sub>)(LiF)<sub>x</sub> alloy film. These atomic ratios were consistent with the calculation from QCM experiments. Finally, lithium ion conductivity (AlF<sub>3</sub>)(LiF)<sub>x</sub> alloy film was measured as σ = 7.5 × 10<sup>-6</sup> S/cm.</div>

scholarly journals Synthesis of Lithium-ion Conducting Polymers Designed by Machine Learning-based Prediction and Screening

2019 ◽  
Vol 48 (2) ◽  
pp. 130-132 ◽  
Author(s):  
Kan Hatakeyama-Sato ◽  
Toshiki Tezuka ◽  
Yoshinori Nishikitani ◽  
Hiroyuki Nishide ◽  
Kenichi Oyaizu
Keyword(s):  
Machine Learning ◽  
Conducting Polymers ◽  
Lithium Ion ◽  
Ion Conducting ◽  
Ion Conducting Polymers

scholarly journals Sodium, Silver and Lithium-Ion Conducting β″-Alumina + YSZ Composites, Ionic Conductivity and Stability

Crystals ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 293
Author(s):  
Liangzhu Zhu ◽  
Anil V. Virkar
Keyword(s):  
Ion Exchange ◽  
Electrochemical Impedance ◽  
Ionic Conductivities ◽  
Lithium Ion ◽  
Co2 Corrosion ◽  
Ionic Conductors ◽  
Ion Conductor ◽  
Sensor Applications ◽  
Potential Applications ◽  
Ion Conducting

Na-β″-alumina (Na2O.~6Al2O3) is known to be an excellent sodium ion conductor in battery and sensor applications. In this study we report fabrication of Na- β″-alumina + YSZ dual phase composite to mitigate moisture and CO2 corrosion that otherwise can lead to degradation in pure Na-β″-alumina conductor. Subsequently, we heat-treated the samples in molten AgNO3 and LiNO3 to respectively form Ag-β″-alumina + YSZ and Li-β″-alumina + YSZ to investigate their potential applications in silver- and lithium-ion solid state batteries. Ion exchange fronts were captured via SEM and EDS techniques. Their ionic conductivities were measured using electrochemical impedance spectroscopy. Both ion exchange rates and ionic conductivities of these composite ionic conductors were firstly reported here and measured as a function of ion exchange time and temperature.

scholarly journals Improved electrochemical performance of rare earth doped LiMn1.5-xNi0.5RExO4 based composite cathodes for lithium-ion batteries

2018 ◽  
Vol 139 ◽  
pp. 55-63 ◽  
Author(s):  
Pura Ram ◽  
Attila Gören ◽  
Renato Gonçalves ◽  
Ganpat Choudhary ◽  
Stanislav Ferdov ◽  
...  
Keyword(s):  
Rare Earth ◽  
Electrochemical Performance ◽  
Lithium Ion Batteries ◽  
Lithium Ion ◽  
Composite Cathodes ◽  
Rare Earth Doped

scholarly journals Lithium Ion Conducting Solid Electrolytes for Aqueous Lithium-air Batteries

2014 ◽  
Vol 82 (11) ◽  
pp. 938-945 ◽  
Author(s):  
Nobuyuki IMANISHI ◽  
Masaki MATSUI ◽  
Yasuo TAKEDA ◽  
Osamu YAMAMOTO
Keyword(s):  
Solid Electrolytes ◽  
Lithium Ion ◽  
Ion Conducting ◽  
Lithium Air Batteries

scholarly journals PEO Infiltration of Porous Garnet-Type Lithium-Conducting Solid Electrolyte Thin Films

Ceramics ◽  
2021 ◽  
Vol 4 (3) ◽  
pp. 421-436
Author(s):  
Aamir Iqbal Waidha ◽  
Vanita Vanita ◽  
Oliver Clemens
Keyword(s):  
Thin Films ◽  
Solid State ◽  
Ionic Conductivity ◽  
Electrochemical Impedance ◽  
Three Dimensional ◽  
Lithium Ion ◽  
Interfacial Resistance ◽  
Composite Electrolytes ◽  
Ion Conducting ◽  
Polymer Infiltration

Composite electrolytes containing lithium ion conducting polymer matrix and ceramic filler are promising solid-state electrolytes for all solid-state lithium ion batteries due to their wide electrochemical stability window, high lithium ion conductivity and low electrode/electrolyte interfacial resistance. In this study, we report on the polymer infiltration of porous thin films of aluminum-doped cubic garnet fabricated via a combination of nebulized spray pyrolysis and spin coating with subsequent post annealing at 1173 K. This method offers a simple and easy route for the fabrication of a three-dimensional porous garnet network with a thickness in the range of 50 to 100 µm, which could be used as the ceramic backbone providing a continuous pathway for lithium ion transport in composite electrolytes. The porous microstructure of the fabricated thin films is confirmed via scanning electron microscopy. Ionic conductivity of the pristine films is determined via electrochemical impedance spectroscopy. We show that annealing times have a significant impact on the ionic conductivity of the films. The subsequent polymer infiltration of the porous garnet films shows a maximum ionic conductivity of 5.3 × 10−7 S cm−1 at 298 K, which is six orders of magnitude higher than the pristine porous garnet film.

Sign in / Sign up

Export Citation Format

Share Document