2001 debris flow and debris flood in Nam Ko area, Phetchabun province, central Thailand

2006 ◽  
Vol 51 (4) ◽  
pp. 545-564 ◽  
Author(s):  
S. Yumuang
Landslides ◽  
2020 ◽  
Vol 17 (4) ◽  
pp. 913-930 ◽  
Author(s):  
Pierre Friele ◽  
Tom H. Millard ◽  
Andrew Mitchell ◽  
Kate E. Allstadt ◽  
Brian Menounos ◽  
...  

AbstractTwo catastrophic landslides occurred in quick succession on 13 and 16 May 2019, from the north face of Joffre Peak, Cerise Creek, southern Coast Mountains, British Columbia. With headscarps at 2560 m and 2690 m elevation, both began as rock avalanches, rapidly transforming into debris flows along middle Cerise Creek, and finally into debris floods affecting the fan. Beyond the fan margin, a flood surge on Cayoosh Creek reached bankfull and attenuated rapidly downstream; only fine sediment reached Duffey Lake. The toe of the main debris flow deposit reached 4 km from the headscarp, with a travel angle of 0.28, while the debris flood phase reached the fan margin 5.9 km downstream, with a travel angle of 0.22. Photogrammetry indicates the source volume of each event is 2–3 Mm3, with combined volume of 5 Mm3. Lidar differencing, used to assess deposit volume, yielded a similar total result, although error in the depth estimate introduced large volume error masking the expected increase due to dilation and entrainment. The average velocity of the rock avalanche-debris flow phases, from seismic analysis, was ~ 25–30 m/s, and the velocity of the 16 May debris flood on the upper fan, from super-elevation and boulder sizes, was 5–10 m/s. The volume of debris deposited on the fan was ~ 104 m3, 2 orders of magnitude less than the avalanche/debris flow phases. Progressive glacier retreat and permafrost degradation were likely the conditioning factors; precursor rockfall activity was noted at least ~6 months previous; thus, the mountain was primed to fail. The 13 May landslide was apparently triggered by rapid snowmelt, with debuttressing triggering the 16 May event.


Landslides ◽  
2004 ◽  
Vol 1 (1) ◽  
pp. 61-66 ◽  
Author(s):  
D. J. Wilford ◽  
M. E. Sakals ◽  
J. L. Innes ◽  
R. C. Sidle ◽  
W. A. Bergerud

2015 ◽  
Vol 1 (3) ◽  
pp. 77
Author(s):  
Ali Cahyadi Achmad

One of disasters caused by volcanic activity of Mount Merapi is secondary disaster. The disaster usually occurs after eruption and this volcanic activity produces volcanic and pyroclastic material deposit around the top of the mountain as a result of previous eruption. This material might collapse downward in the form of debris flow as it is affected by natural event such as high intensity rainfall. Therefore, a research is needed to analyze whether existing forecasting and early warning system are capable to provide information for the people living in hazardous area before the debris flood occur. This research was carried out using field survey, observation and interview method. Data analysis used qualitative descriptive method by making description of actual condition of the researched location general condition and qualitative analysis of telemetry system installed on Mount Merapi. The qualitative analysis of telemetry system covers network, hardware, software, power supply, security system, operation and maintenance, also human resources. Research analysis used primary and secondary data. Research results revealed that mean rainfall intensity above of 60 mm/hour might trigger debris flood. Early warning should be given at the rainfall intensity level of 50-55 mm/hour, and debris flood time travel from the upstream to the observed location in Pulowatu Village is 45 minute. Based on the analysis of the present forecasting and early warning system, it is known that some of the equipment is not well functioned, so that debris flow cannot be predicted and detected. This is caused by the lack of human resource quality of the officers in operating and maintaining the equipment. Concerning that matter, it is necessary to conduct some improvement to achieve better forecasting and early warning system in order to give information regarding occurrence of debris flow.


2020 ◽  
Vol 45 (12) ◽  
pp. 2954-2964
Author(s):  
Matthias Jakob ◽  
Emily Mark ◽  
Scott McDougall ◽  
Pierre Friele ◽  
Carie‐Ann Lau ◽  
...  

Author(s):  
Matthieu Sturzenegger ◽  
Kris Holm ◽  
Carie-Ann Lau ◽  
Matthias Jakob

ABSTRACT Regional-scale assessments for debris-flow and debris-flood propagation and avulsion on fans can be challenging. Geomorphological mapping based on aerial or satellite imagery requires substantial field verification effort. Surface evidence of past events may be obfuscated by development or obscured by repeat erosion or debris inundation, and trenching may be required to record the sedimentary architecture and date past events. This paper evaluates a methodology for debris-flow and debris-flood susceptibility mapping at regional scale based on a combination of digital elevation model (DEM) metrics to identify potential debris source zones and flow propagation modeling using the Flow-R code that is calibrated through comparison to mapped alluvial fans. The DEM metrics enable semi-automated identification and preliminary, process-based classification of streams prone to debris flow and debris flood. Flow-R is a susceptibility mapping tool that models potential flow inundation based on a combination of spreading and runout algorithms considering DEM topography and empirical propagation parameters. The methodology is first evaluated at locations where debris-flow and debris-flood hazards have been previously assessed based on field mapping and detailed numerical modeling. It is then applied over a 125,000 km2 area in southern British Columbia, Canada. The motivation for the application of this methodology is that it represents an objective and repeatable approach to susceptibility mapping, which can be integrated in a debris-flow and debris-flood risk prioritization framework at regional scale to support risk management decisions.


Sign in / Sign up

Export Citation Format

Share Document