Quantitative evaluation of gait pattern in patients with osteoarthrosis of the knee before and after total knee arthroplasty. Gait analysis using a pressure measuring system

1999 ◽  
Vol 4 (2) ◽  
pp. 99-105 ◽  
Author(s):  
Takeo Otsuki ◽  
Koji Nawata ◽  
Makoto Okuno
2001 ◽  
Vol 50 (2) ◽  
pp. 312-315
Author(s):  
Eiichi Goto ◽  
Etsuo Chosa ◽  
Tomomi Matsuoka ◽  
Shinji Watanabe ◽  
Takero Sakamoto ◽  
...  

2017 ◽  
Vol 2017 ◽  
pp. 1-5 ◽  
Author(s):  
Xubo Wu ◽  
Lixi Chu ◽  
Lianbo Xiao ◽  
Yong He ◽  
Shuyun Jiang ◽  
...  

Purpose. With the aim of investigating the spatiotemporal features of early gait pattern and knee kinematics after total knee arthroplasty and analyzing the association between outcomes of gait analyses and knee kinematic parameters, the relationship between walking and dynamic knee deformity at the early period after total knee arthroplasty was assessed in this study. Methods. Eighteen patients including 14 women and 4 men who underwent total knee arthroplasty were analyzed using three-dimensional gait analysis system to observe gait parameters and values of maximum knee flexion angle (MKFA) during swing phase and knee flexion angle (KFA) and knee valgus angle (KVA) at midstance phase. Results. 3D gait analysis showed that operated side exhibited significantly less total support time and single support time as well as significantly longer swing phase compared with the other side. During walking, the operated side had significantly smaller MKFA and greater KFA and KVA than the nonoperated side. There was moderate to significant correlation between gait pattern and the dynamic knee kinematics. Conclusion. The gait abnormality of patients after TKA was associated with inadequate flexion of knees at swing phase and insufficient extension at stance phase as well as increased range of valgus.


2021 ◽  
Vol 29 (1) ◽  
pp. 230949902110020
Author(s):  
Seikai Toyooka ◽  
Hironari Masuda ◽  
Nobuhiro Nishihara ◽  
Takashi Kobayashi ◽  
Wataru Miyamoto ◽  
...  

Purpose: To evaluate the integrity of lateral soft tissue in varus osteoarthritis knee by comparing the mechanical axis under varus stress during navigation-assisted total knee arthroplasty before and after compensating for a bone defect with the implant. Methods: Sixty-six knees that underwent total knee arthroplasty were investigated. The mechanical axis of the operated knee was evaluated under manual varus stress immediately after knee exposure and after navigation-assisted implantation. The correlation between each value of the mechanical axis and degree of preoperative varus deformity was compared by regression analysis. Results: The maximum mechanical axis under varus stress immediately after knee exposure increased in proportion to the degree of preoperative varus deformity. Moreover, the maximum mechanical axis under varus stress after implantation increased in proportion to the degree of preoperative varus deformity. Therefore, the severity of varus knee deformity leads to a progressive laxity of the lateral soft tissue. However, regression coefficients after implantation were much smaller than those measured immediately after knee exposure (0.99 vs 0.20). Based on the results of the regression formula, the postoperative laxity of the lateral soft tissue was negligible, provided that an appropriate thickness of the implant was compensated for the bone and cartilage defect in the medial compartment without changing the joint line. Conclusion: The severity of varus knee deformity leads to a progressive laxity of the lateral soft tissue. However, even if the degree of preoperative varus deformity is severe, most cases may not require additional procedures to address the residual lateral laxity.


2015 ◽  
Vol 2015 ◽  
pp. 1-3 ◽  
Author(s):  
Dongquan Shi ◽  
Xingquan Xu ◽  
Anyun Guo ◽  
Jin Dai ◽  
Zhihong Xu ◽  
...  

Introduction. Mechanical alignment deviation after total knee arthroplasty is a major reason for early loosening of the prosthesis. Achieving optimum cement penetration during fixation of the femoral and tibial component is an essential step in performing a successful total knee arthroplasty. Bone cement is used to solidify the bone and prosthesis. Thickness imbalance of bone cement leads to the deviation of mechanical alignment. To estimate the influence of bone cement, a retrospective study was conducted.Materials and Methods. A total of 36 subjects were studied. All the TKA were performed following the standard surgical protocol for navigated surgery by medial approach with general anaesthesia. Prostheses were fixed by bone cement.Results. We compared the mechanical axis, flexion/extension, and gap balance before and after cementation. All the factors were different compared with those before and after cementation. Internal rotation was reached with statistical significance (P=0.03).Conclusion. Bone cement can influence the mechanical axis, flexion/extension, and gap balance. It also can prompt us to make a change when poor knee kinematics were detected before cementation.


2012 ◽  
Vol 45 (13) ◽  
pp. 2215-2221 ◽  
Author(s):  
K.C.T. Ho ◽  
S.K. Saevarsson ◽  
H. Ramm ◽  
R. Lieck ◽  
S. Zachow ◽  
...  

2014 ◽  
Vol 29 (7) ◽  
pp. 1388-1393 ◽  
Author(s):  
David A.J. Wilson ◽  
Janie L. Astephen Wilson ◽  
Glen Richardson ◽  
Michael J. Dunbar

Sign in / Sign up

Export Citation Format

Share Document