Evaluating Thermoelectric Power Generation Device Performance Using a Rectangular Microchannel Heat Sink

2011 ◽  
Vol 40 (5) ◽  
pp. 481-488 ◽  
Author(s):  
A. Rezania ◽  
L. A. Rosendahl
Keyword(s):  
Power Generation ◽  
Thermoelectric Power ◽  
Heat Sink ◽  
Device Performance ◽  
Microchannel Heat Sink ◽  
Rectangular Microchannel ◽  
Thermoelectric Power Generation ◽  
Power Generation Device

Energy Payback Optimization of Thermoelectric Power Generator Systems

2010 ◽  
Author(s):  
Kazuaki Yazawa ◽  
Ali Shakouri
Keyword(s):  
Power Generation ◽  
Heat Source ◽  
Thermal Resistance ◽  
Thermoelectric Power ◽  
Output Power ◽  
Heat Sink ◽  
Generation System ◽  
Thermoelectric Power Generation ◽  
Energy Payback ◽  
Power Generation System

An analytic model for optimizing thermoelectric power generation system is developed and utilized for parametric studies. This model takes into account the external thermal resistances with hot and cold reservoirs. In addition, the spreading thermal resistance in the module substrates is considered to find the impact of designing small fraction of thermo elements per unit area. Previous studies are expanded by a full optimization of the electrical and thermal circuits. The optimum condition satisfies both electrical load resistance match with the internal resistance and the thermal resistance match with the heat source and the heat sink. Thermoelectric element aspect ratio and fill factor are found to be key parameters to optimize. The optimum leg length and the maximum output power are determined by a simple formula. The output power density per mass of the thermoelectric material has a peak when thermo elements cover a fractional area of ∼1%. The role of the substrate heat spreading for thermoelectric power generation is equally significant as thermoelement. For a given heat source, the co-optimization of the heat sink and the thermoelectric module should be performed. Active cooling and the design of the heat sink are customized to find the energy payback for the power generation system. The model includes both the air cooled heat sinks and the water cooled micro channels. We find that one can reduce the mass of thermoelement to around 3∼10% of that in commercial modules for the same output power, as long as the module and elements are designed properly. Also one notes that higher heat flux sources have significantly larger energy payback and reduced cost per output power.

Sign in / Sign up

Export Citation Format

Share Document