Experimental study on bump-foil gas bearing with different diametric clearance configurations

2015 ◽  
Vol 29 (5) ◽  
pp. 2089-2095 ◽  
Author(s):  
Yu Hou ◽  
Bin Ma ◽  
Shanju Yang ◽  
Xingya Chen ◽  
Yueqing Zheng ◽  
...  
1968 ◽  
Vol 90 (4) ◽  
pp. 687-696 ◽  
Author(s):  
R. Y. Wong ◽  
W. L. Stewart ◽  
H. E. Rohlik

This paper describes findings obtained to date in the area of journal gas bearings from an experimental study of a Brayton cycle turbocompressor designed for the requirements of a two-shaft 10-kw space power system. The journal bearing design utilizes three pads pivoted on conforming balls and sockets. Two of the pivots are rigidly mounted to the frame, and the third pivot is mounted to the frame through a low-spring-rate diaphragm. This paper describes the salient package and bearing design features and then presents the principal results obtained from testing the package in both a spin calibration rig and operation at design temperature conditions with an inert gas. The results discussed include (a) the successful use of a pneumatic loading device to vary pad load during operation, (b) the operating characteristics of the bearings as obtained over a range of pad loads and ambient conditions, (c) structural and dynamic behavior of the bearing-support system during design temperature operation and (d) a discussion of the wear characteristics of the conforming ball-and-socket pivot as obtained from the tests made to date.


2012 ◽  
Vol 220-223 ◽  
pp. 611-614
Author(s):  
Ru Gang Chen ◽  
Ya Jun Nie ◽  
Quan Zhou ◽  
Chao Gong ◽  
Tao Chen

A new type of hydrostatic journal gas bearing with axial slot of tangential gas entry for miniature air turboexpander is firstly developed in this paper. This bearing configuration is presented and constructed to fit manufacture simplicity. The experimental investigations are carried out to reveal the relationship between bearing parameters and instability threshold speed. It is feasible to increase the stability of hydrostatic journal gas bearing by adopting this kind of configuration with axial slot of tangential gas entry. Some valuable tested results are obtained to reveal the optimum slot height and radial clearance for this miniature air turboexpander.


2017 ◽  
Vol 2017.23 (0) ◽  
pp. 1910
Author(s):  
Tomonori MATSUSHITA ◽  
Yuta SUNAMI ◽  
Hiromu HASHIMOTO ◽  
Masayuki OCHIAI

2004 ◽  
Vol 2004.3 (0) ◽  
pp. 351-352
Author(s):  
Hideo YOSHIDA ◽  
Hideomi ISHIBE ◽  
Hiroki MATSUI ◽  
Takeshi EGAWA ◽  
Satoshi YOSHITOMI ◽  
...  

2019 ◽  
Vol 33 (12) ◽  
pp. 12587-12600 ◽  
Author(s):  
Xidong Du ◽  
Min Gu ◽  
Zhenkun Hou ◽  
Zhenjian Liu ◽  
Tengfei Wu

Cryogenics ◽  
1992 ◽  
Vol 32 ◽  
pp. 76-79 ◽  
Author(s):  
Chunzheng Chen ◽  
Zhihai Dong ◽  
Guining Cui ◽  
Yuyuan Wu ◽  
Runquan Tang ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document