Low-temperature biochars from cork-rich and phloem-rich wastes: fuel, leaching, and methylene blue adsorption properties

Author(s):  
A. U. Şen ◽  
C. Nobre ◽  
L. Durão ◽  
I. Miranda ◽  
H. Pereira ◽  
...  
2020 ◽  
Vol 361 ◽  
pp. 624-632 ◽  
Author(s):  
S. Asuha ◽  
F. Fei ◽  
W. Wurendaodi ◽  
S. Zhao ◽  
H. Wu ◽  
...  

2019 ◽  
Vol 5 (1) ◽  
pp. 10 ◽  
Author(s):  
Lok Shrestha ◽  
Mamata Thapa ◽  
Rekha Shrestha ◽  
Subrata Maji ◽  
Raja Pradhananga ◽  
...  

Iodine and methylene blue adsorption properties of the high surface area nanoporous carbon materials derived from agro-waste and rice husk is reported. Rice husk was pre-carbonized at 300 °C in air followed by leaching out the silica nanoparticles by extraction with sodium hydroxide solution. The silica-free rice husk char was mixed with chemical activating agents sodium hydroxide (NaOH), zinc chloride (ZnCl2), and potassium hydroxide (KOH) separately at a mixing ratio of 1:1 (wt%) and carbonized at 900 °C under a constant flow of nitrogen. The prepared carbon materials were characterized by scanning electron microscopy (SEM), Fourier transformed-infrared spectroscopy (FT-IR), powder X-ray diffraction (pXRD), and Raman scattering. Due to the presence of bimodal micro- and mesopore structures, KOH activated samples showed high specific surface area ca. 2342 m2/g and large pore volume ca. 2.94 cm3/g. Oxygenated surface functional groups (hydroxyl, carbonyl, and carboxyl) were commonly observed in all of the samples and were essentially non-crystalline porous particle size of different sizes (<200 μm). Adsorption study revealed that KOH activated samples could be excellent material for the iodine and methylene blue adsorption from aqueous phase. Iodine and methylene blue number were ca. 1726 mg/g and 608 mg/g, respectively. The observed excellent iodine and methylene blue adsorption properties can be attributed to the well-developed micro- and mesopore structure in the carbon material. This study demonstrates that the agricultural waste, rice husk, and derived nanoporous carbon materials would be excellent adsorbent materials in water purifications.


2020 ◽  
Vol 121 ◽  
pp. 108217
Author(s):  
Abdessalem Badri ◽  
Inmaculada Alvarez-Serrano ◽  
María Luisa López ◽  
Mongi Ben Amara

2012 ◽  
Vol 626 ◽  
pp. 706-710 ◽  
Author(s):  
Athiwat Sirimuangjinda ◽  
Duangduen Atong ◽  
Chiravoot Pechyen

Two activated carbons employing Scrap Tire as precursor were produced by using two different activating agents, HCl and H2SO4 (fixed impregnation ratio 1:1). Both of activated carbons were allowed by single-step to get difference carbonized at 500, 600 and 700°C in a muffle furnace for 1 h. Activated carbons differed with the physical structure, chemical and adsorption properties which were derived from Scanning Electron Microscope, and N2 adsorption/desorption isotherms. Batched sorption studies were performed to compare the iodine and methylene blue adsorption properties of two carbons. The carbon materials obtained from sulfuric acid activation of 500°C has BET surface area as high as 1066.70 m2/g, Methylene blue adsorption and Iodine number of 288.90 and 590.50 mg/g, respectively. The surface area and adsorption properties of carbon produced using sulfuric acid activation were higher than that produced using hydrochloric acid activation. The results suggest the feasibility of the process from the point of view of both porous texture and adsorption yield.


Author(s):  
Napat Kaewtrakulchai ◽  
Ampol Putta ◽  
Warit Pasee ◽  
Kajornsak Fuangnawakij ◽  
Gasidit Panomsuwan ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document