<p>Ocean color remote sensing proved to be a good alternative to traditional methods for total suspended solids concentration (TSS) monitoring purposes: numerous sensors have been developed for ocean color applications and different algorithms to retrieve TSS from remotely sensed data already exist.</p><p>Nevertheless, their application is generally limited by site-specific factors, and presently there is no uniform remote sensing model to estimate TSS.</p><p>The present study is focused in the development, evaluation and validation of different algorithms to estimate total suspended solids concentration based on laboratory reflectance data.</p><p>At this aim, a laboratory experiment was designed to collect the spectral reflectance of water containing fixed suspended particulate matter in terms of its concentration.</p><p>During the experiment, a total of 10 silty clay loam sediment samples were introduced into a tank filled with clear water up to a depth of 22 cm, illuminated by two 45 W lamps focused on center of water surface. After sieving, sediments were weighed so that TSS concentration ranging from 150 up to 2000 mg/L were obtained in the tank, being soil sediments suspension guaranteed by means of a mechanical pump-driven device.</p><p>Optical data were collected few minutes after each sediment introduction, using an Ocean Optics Jaz spectroradiometer mounted on a platform above the tank.</p><p>In accordance with previous studies, collected reflectance spectra of water containing sediments showed that, whatever is sediment concentration in water, reflectance in the red region is larger than that in the NIR region. Furthermore, reflectance spectra generally present two peaks: one between 550 nm and 750 nm, and the other between 750 nm and 850 nm, being the second peak insignificant for samples with very small TSS (e.g., SSC=150 mg/L), due to strong absorption of water.</p><p>After collection, laboratory reflectance spectra were integrated over the bandpass of different sensors&#8217; selected bands, modulated by their relative response functions (RSR).</p><p>The basic principle of using a specific band, or band ratios to estimate a water parameter is to select spectral bands representative of its scattering/absorption features.</p><p>Band selection was achieved testing some previously formulated ocean color algorithms for the estimation of water quality parameters.</p><p>After band selection, linear regression model was applied to estimate the relationship between sensors&#8217; reflectance at these bands and suspended solids concentration.</p><p>Results showed high correlation between selected sensors&#8217; spectral red band and total suspended solids concentration higher than 500 mg/L up to 1360 mg/L, while less accuracy was observed for TSS concentrations higher than 1360 mg/L. Furthermore, the ratio between spectral red and green bands better estimates TSS in waters where total suspended concentration is not higher than 500 mg/L.</p><p>&#160;</p>
Distribution of Total Suspended Solids Concentration in a River