Comments on “X-ray and calorimetric investigations of cold working and annealing of a gold-silver alloy”

1958 ◽  
Vol 6 (2) ◽  
pp. 141-142 ◽  
Author(s):  
D. Michell
1956 ◽  
Vol 4 (5) ◽  
pp. 477-484 ◽  
Author(s):  
B.L Averbach ◽  
M.B Bever ◽  
M.F Comerford ◽  
J.S.Li Leach

1996 ◽  
Vol 462 ◽  
Author(s):  
W.S. Williams ◽  
J. W. Flanagan

ABSTRACTThirty-four gold solidi coins and two pairs of gold/jewel earrings were discovered at an archaeological site in Jordan, Tell Nimrin. The coins have stamped images of six late Roman/early Byzantine emperors who reigned from 346 AD to 518 AD. These objects were analyzed by X-ray radiography, SEM/EDS and density measurements to find the gold content for comparison with other coins ofthat period to support their authenticity and to see whether debasement of coinage had occurred. The average surface gold content was found by EDS to be 98.1 wt %--typical of the period--but the bulk content calculated from density values was 1 to 3 wt % lower. The reason offered is that when a molten gold-copper or gold-silver alloy solidifies, the region in contact with the blank coin mold freezes first and is gold-enriched. Small “silvery” specks were observed on the obverse (”heads”) side of several coins and found by EDS to be Os-Ir-Ru alloys, which come from placer mining and indicate that the gold also came from placer mining.


1953 ◽  
Vol 1 (2) ◽  
pp. 116-122 ◽  
Author(s):  
M.B Bever ◽  
L.B Ticknor

2020 ◽  
Vol 35 (S1) ◽  
pp. S38-S42
Author(s):  
Soraia Rodrigues de Azeredo ◽  
Roberto Cesareo ◽  
Angel Guillermo Bustamante Dominguez ◽  
Ricardo Tadeu Lopes

Precious ornaments from the Museum Royal Tombs of Sipán were analyzed by X-ray computed microtomography (microCT). The ornaments analyzed were golden earrings produced by the Moche culture that flourished along the north coast of present-day Peru between approximately 100 and 600 AD. Sipán, also known as Huava Rajada, is a mochica archaeological complex in the north of Peru. In particular, the spectacular jewelry, mainly composed of gold, silver, and copper alloys, gilded copper, and tumbaga, from the Museum “Royal Tombs of Sipán,” in Lambayeque, north of Peru, are some of the most sophisticated metalworking ever produced of pre-Columbian America. A portable microCT system consisting of a high-resolution flat panel detector and a mini X-ray tube were used for the structural analysis of these ornaments. The microCT images show parts of the internal structure, highlighting the manufacturing technique and gold sheets joining techniques of the Moche artisans. Furthermore, the advantage of using the portable microCT system for nondestructive testing is clear when the sample cannot be taken to the laboratory.


Proceedings ◽  
2018 ◽  
Vol 2 (13) ◽  
pp. 931
Author(s):  
Shuang Liang ◽  
Ran Gao ◽  
Mengying Zhang ◽  
Ning Xue ◽  
Zhi-mei Qi

A gold-silver alloy film based spectral surface plasmon resonance imaging (SPRi) sensor has been prepared for in-situ quantitative detection of biochemical analytes at the sensor surface. This novel sensor has lower detection cost yet higher sensitivity relative to the conventional counterpart with a gold film. Using the laboratory-made multifunctional SPR sensing platform, both the resonant color images and the resonant spectra for the Au-Ag alloy film were measured at different incident angles. The quantitative relationship between the resonant wavelength and the average hue of corresponding resonant color image was established. With this relationship the most hue-sensitive spectral range was determined. After setting the initial resonant wavelength in the hue-sensitive spectral range, the refractive-index sensitivity of the Au-Ag alloy film based SPRi sensor was measured as Δhue/Δnc = 29,879/RIU, being 8 times higher than that obtained with the gold-film SPRi sensor. The immunodetection of benzo(a)pyrene (BaP) in water was fulfilled using the Au-Ag alloy film based SPRi sensor. The average hue of the SPR color image linearly increases with increasing the BaP concentration up to C = 0.5 μg/L and the slope is Δhue/ΔC = 132.2/(μg/L). The sensor is responsive to a change of BaP concentration as low as ΔC = 0.01 μg/L.


2016 ◽  
Vol 685 ◽  
pp. 525-529
Author(s):  
Zhanna G. Kovalevskaya ◽  
Margarita A. Khimich ◽  
Andrey V. Belyakov ◽  
Ivan A. Shulepov

The changes of the phase composition, structure and physicomechanical properties of Ti‑40 mas % Nb after severe plastic deformation are investigated in this paper. By the methods of microstructural, X-ray diffraction analysis and scanning electron microscopy it is determined that phase and structural transformations occur simultaneously in the alloy after severe plastic deformation. The martensitic structure formed after tempering disappears. The inverse α'' → β transformation occurs. The structure consisting of oriented refined grains is formed. The alloy is hardened due to the cold working. The Young modulus is equal to 79 GPa and it is less than that of initial alloy and close to the value obtained after tempering. It is possible that Young modulus is reduced by additional annealing.


2019 ◽  
Author(s):  
Devender Kumar ◽  
Saroj Bala ◽  
Heena Wadhwa ◽  
Geeta Kandhol ◽  
Suman Mahendia ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document