Drift velocities of electrons, saturation characteristics of ionization and W-values for conversion electrons in liquid argon, liquid argon-gas mixtures and liquid xenon

1975 ◽  
Vol 131 (2) ◽  
pp. 249-258 ◽  
Author(s):  
Eido Shibamura ◽  
Akira Hitachi ◽  
Tadayoshi Doke ◽  
Tan Takahashi ◽  
Shinzou Kubota ◽  
...  
Instruments ◽  
2021 ◽  
Vol 5 (1) ◽  
pp. 13
Author(s):  
Matthew Szydagis ◽  
Grant A. Block ◽  
Collin Farquhar ◽  
Alexander J. Flesher ◽  
Ekaterina S. Kozlova ◽  
...  

Detectors based upon the noble elements, especially liquid xenon as well as liquid argon, as both single- and dual-phase types, require reconstruction of the energies of interacting particles, both in the field of direct detection of dark matter (weakly interacting massive particles WIMPs, axions, etc.) and in neutrino physics. Experimentalists, as well as theorists who reanalyze/reinterpret experimental data, have used a few different techniques over the past few decades. In this paper, we review techniques based on solely the primary scintillation channel, the ionization or secondary channel available at non-zero drift electric fields, and combined techniques that include a simple linear combination and weighted averages, with a brief discussion of the application of profile likelihood, maximum likelihood, and machine learning. Comparing results for electron recoils (beta and gamma interactions) and nuclear recoils (primarily from neutrons) from the Noble Element Simulation Technique (NEST) simulation to available data, we confirm that combining all available information generates higher-precision means, lower widths (energy resolution), and more symmetric shapes (approximately Gaussian) especially at keV-scale energies, with the symmetry even greater when thresholding is addressed. Near thresholds, bias from upward fluctuations matters. For MeV-GeV scales, if only one channel is utilized, an ionization-only-based energy scale outperforms scintillation; channel combination remains beneficial. We discuss here what major collaborations use.


1993 ◽  
Vol 212 (3-4) ◽  
pp. 326-328 ◽  
Author(s):  
U. Asaf ◽  
S. Felps ◽  
K. Rupnik ◽  
S.P. McGlynn

1989 ◽  
Vol 24 (6) ◽  
pp. 1141-1146 ◽  
Author(s):  
W. Khechen ◽  
J.R. Laghari
Keyword(s):  

1988 ◽  
Vol 8 (4) ◽  
pp. 367-378 ◽  
Author(s):  
D. Douguet ◽  
J. Raynaud ◽  
A. Capderou ◽  
C. Pánnier ◽  
G. Reiss ◽  
...  

2020 ◽  
Vol 19 (04) ◽  
pp. 629-640
Author(s):  
Hardik Beravala ◽  
Pulak M. Pandey

The present research was focussed to investigate the influence of liquid-gaseous dielectric on debris formation in magnetic field-assisted electrical discharge machining. The air and argon gas were used to make two-phase dielectric fluids such as liquid-air and liquid-argon gas, respectively. Experimentation was conducted to compare the effect of different liquid-gaseous dielectric environments on debris formation. The morphology and diameter distribution of debris were analyzed. In addition, the effect on elemental analysis, phase transformation and magnetic property of debris was investigated. The experimental results showed the exothermic reaction due to air from liquid–air dielectric, and inert property of argon gas from liquid-gaseous dielectric affected the formation of debris. The XRD results confirmed the formation of oxides in the debris produced using liquid-air mixed dielectric. The oxide-free debris formed while using the argon gas. Low saturation of magnetization was found in the debris, formed in the liquid–air dielectric which showed the weak attraction toward magnet when compared with that in the liquid–argon gas mixed dielectric.


Sign in / Sign up

Export Citation Format

Share Document