Extracellular polymers in relation to settling properties of activated sludge

1989 ◽  
Vol 68 (5) ◽  
pp. 365-370 ◽  
Author(s):  
Kazuo Kakii ◽  
Kunihiko Nakatani ◽  
Takashi Shirakashi ◽  
Mitsuo Kuriyama
1991 ◽  
Vol 24 (7) ◽  
pp. 21-28 ◽  
Author(s):  
L. Eriksson ◽  
B. Alm

Electrostatic interactions between bacterial surfaces, extracellular polymers (ECP) and polyvalent metal ions are important in activated sludge flocculation. An indirect study of these mechanisms was done by adding different concentrations of EDTA to activated sludge samples from 6 Swedish wastewater treatment plants. The effects on sludge properties were studied with sedimentation and filtration tests as well as analysis of released extracellular polymers. EDTA had a significant effect on sedimentation velocity in all investigated sludges. This shows that charged polymers are important for the properties of the floc surfaces and in building up the sludge macroflocs. The effect on filtration resistance where the bulk properties of the primary flocs are more important varied considerably for the different sludges. Thus, both electrostatic and other interactions are involved to a varying extent in building up the primary flocs in the sludges investigated. Variations in sedimentation velocity, residual turbidity, filtration resistance and release of ECP with variations in EDTA concentrations could be explained by effects of polyvalent metal ions on ECP binding and conformation.


2006 ◽  
Vol 40 (7) ◽  
pp. 1359-1366 ◽  
Author(s):  
Mohamed Lamin Sesay ◽  
Gülay Özcengiz ◽  
F. Dilek Sanin

2001 ◽  
Vol 44 (10) ◽  
pp. 137-142 ◽  
Author(s):  
J.C. Liu ◽  
C.H. Lee ◽  
J.Y. Lai ◽  
K.C. Wang ◽  
Y.C. Hsu ◽  
...  

Effect of ozonation on characteristics of waste activated sludge was investigated in the current study. Concentrations of cell-bound extracellular polymers (washed ECPs) did not change much upon ozonation, whereas the sum of cell-bound and soluble extracellular polymers (unwashed ECPs) increased with increasing ozone dose. Washed ECPs in original sludge as divided by molecular weight distribution was 39% < 1,000 Da (low MW), 30% from 1,000 to 10,000 Da (medium MW), and 31% > 10,000 Da (high MW). It was observed that the low-MW fraction decreased, and the high-MW fraction increased in ozonized sludge. The unwashed ECPs were characterized as 44% in low MW, 30% in medium MW, and 26% in high MW. Both low-MW and medium-MW fractions of unwashed ECPs decreased while high-MW fraction increased in ozonized sludge. The dewaterability of ozonized sludge, assessed by capillary suction time (CST) and specific resistance to filtration (SRF), deteriorated with ozone dose. The optimal dose of cationic polyelectrolyte increased with increasing ozone dose. The production rate and the accumulated amount of methane gas of ozonized sludge were also higher.


1996 ◽  
Vol 30 (8) ◽  
pp. 1749-1758 ◽  
Author(s):  
Bo Frølund ◽  
Rikke Palmgren ◽  
Kristian Keiding ◽  
Per Halkjær Nielsen

2002 ◽  
Vol 46 (10) ◽  
pp. 269-279 ◽  
Author(s):  
B. Örmeci ◽  
P.A. Vesilind

In this study, the effects of extracellular polymers on freeze-thaw conditioning of activated sludge are investigated. Various physical and chemical extraction methods including centrifugation, blending, heat, EDTA, EGTA, and NaOH extraction were used to remove extracellular material from sludge matrix. The improvements in freeze-thaw conditioning were evaluated by commonly used measures of sludge dewaterability. The results of this study indicate that removal of extracellular polymers using relatively gentle extraction methods before freeze-thaw conditioning improves the sludge dewaterability after the freeze-thaw. In addition to extracellular polymers, cations also play an important role in determining the freeze-thaw effectiveness on activated sludge. Best dewaterability is achieved when both extracellular polymers and cations are removed from activated sludge before freeze-thaw conditioning.


Sign in / Sign up

Export Citation Format

Share Document