scholarly journals Comparison of CO2 trapping in highly heterogeneous reservoirs with Brooks-Corey and van Genuchten type capillary pressure curves

2016 ◽  
Vol 96 ◽  
pp. 225-236 ◽  
Author(s):  
Naum I. Gershenzon ◽  
Robert W. Ritzi Jr. ◽  
David F. Dominic ◽  
Edward Mehnert ◽  
Roland T. Okwen
2007 ◽  
Vol 10 (02) ◽  
pp. 191-204 ◽  
Author(s):  
Shehadeh K. Masalmeh ◽  
Issa M. Abu-Shiekah ◽  
Xudong Jing

Summary An oil/water capillary transition zone often contains a sizable portion of a field's initial oil in place, especially for those carbonate reservoirs with low matrix permeability. The field-development plan and ultimate recovery may be influenced heavily by how much oil can be recovered from the transition zone. This in turn depends on a number of geological and petrophysical properties that influence the distribution of initial oil saturation (Sor) against depth, and on the rock and fluid interactions that control the residual oil saturation (Sor), capillary pressure, and relative permeability characteristics as a function of initial oil saturation. Because of the general lack of relevant experimental data and the insufficient physical understanding of the characteristics of the transition zone, modeling both the static and dynamic properties of carbonate fields with large transition zones remains an ongoing challenge. In this paper, we first review the transition-zone definition and the current limitations in modeling transition zones. We describe the methodology recently developed, based on extensive experimental measurements and numerical simulation, for modeling both static and dynamic properties in capillary transition zones. We then address how to calculate initial-oil-saturation distribution in the carbonate fields by reconciling log and core data and taking into account the effect of reservoir wettability and its impact on petrophysical interpretations. The effects of relative permeability and imbibition capillary pressure curves on oil recovery in heterogeneous reservoirs with large transition zones are assessed. It is shown that a proper description of relative permeability and capillary pressure curves including hysteresis, based on experimental special-core-analysis (SCAL) data, has a significant impact on the field-performance predictions, especially for heterogeneous reservoirs with transition zones. Introduction The reservoir interval from the oil/water contact (OWC) to a level at which water saturation reaches irreducible is referred to as the capillary transition zone. Fig. 1 illustrates a typical capillary transition zone in a homogeneous reservoir interval within which both the oil and water phases are mobile. The balance of capillary and buoyancy forces controls this so-called capillary transition zone during the primary-drainage process of oil migrating into an initially water-filled reservoir trap. Because the water-filled rock is originally water-wet, a certain threshold pressure must be reached before the capillary pressure in the largest pore can be overcome and the oil can start to enter the pore. Hence, the largest pore throat determines the minimum capillary rise above the free-water level (FWL). As shown schematically in Fig. 2, close to the OWC, the oil/water pressure differential (i.e., capillary pressure) is small; therefore, only the large pores can be filled with oil. As the distance above the OWC increases, an increasing proportion of smaller pores are entered by oil owing to the increasing capillary pressure with height above the FWL. The height of the transition zone and its saturation distribution is determined by the range and distribution of pore sizes within the rock, as well as the interfacial-force and density difference between the two immiscible fluids.


1965 ◽  
Vol 5 (01) ◽  
pp. 15-24 ◽  
Author(s):  
Norman R. Morrow ◽  
Colin C. Harris

Abstract The experimental points which describe capillary pressure curves are determined at apparent equilibria which are observed after hydrodynamic flow has ceased. For most systems, the time required to obtain equalization of pressure throughout the discontinuous part of a phase is prohibitive. To permit experimental points to be described as equilibria, a model of capillary behavior is proposed where mass transfer is restricted to bulk fluid flow. Model capillary pressure curves follow if the path described by such points is independent of the rate at which the saturation was changed to attain a capillary pressure point. A modified suction potential technique is used to study cyclic relationships between capillary pressure and moisture content for a porous mass. The time taken to complete an experiment was greatly reduced by using small samples. Introduction Capillary retention of liquid by porous materials has been investigated in the fields of hydrology, soil science, oil reservoir engineering, chemical engineering, soil mechanics, textiles, paper making and building materials. In studies of the immiscible displacement of one fluid by another within a porous bed, drainage columns and suction potential techniques have been used to obtain relationships between pressure deficiency and saturation (Fig. 1). Except where there is no hysteresis of contact angle and the solid is of simple geometry, such as a tube of uniform cross section, there is hysteresis in the relationship between capillary pressure and saturation. The relationship which has received most attention is displacement of fluid from an initially saturated bed (Fig. 1, Curve Ro), the final condition being an irreducible minimum fluid saturation Swr. Imbibition (Fig. 1, Curve A), further desaturation (Fig. 1, Curve R), and intermediate scanning curves have been studied to a lesser but increasing extent. This paper first considers the nature of the experimental points tracing the capillary pressure curves with respect to the modes and rates of mass transfer which are operative during the course of measurement. There are clear indications that the experimental points which describe these curves are obtained at apparent equilibria which are observed when viscous fluid flow has ceased; and any further changes in the fluid distribution are the result of much slower mass transfer processes, such as diffusion. Unless stated otherwise, this discussion applies to a stable packing of equal, smooth, hydrophilic spheres supported by a suction plate with water as the wetting phase and air as the nonwetting phase. SPEJ P. 15ˆ


2019 ◽  
Vol 200 ◽  
pp. 268-284 ◽  
Author(s):  
Sayed Alireza Hosseinzadeh Hejazi ◽  
Saurabh Shah ◽  
Ronny Pini

Sign in / Sign up

Export Citation Format

Share Document