A study on water-quenching waste heat recovery from molten slag of slag-tap boilers

2016 ◽  
Vol 108 ◽  
pp. 538-545 ◽  
Author(s):  
Lei Deng ◽  
Xiaowen Tan ◽  
Chunli Tang ◽  
Defu Che
Author(s):  
Lei Deng ◽  
Chunli Tang ◽  
Xiaowen Tan ◽  
Ke Sun ◽  
Song Wu ◽  
...  

For a better utilization of Zhundong coals which have high fouling and slagging tendency, the slag-tap boiler has attracted much attention. To avoid the high sensible heat loss of discharged molten slag, an air-cooling waste heat recovery system is proposed. Energy and economic analyses are conducted to investigate the effectiveness of heating the desulfurized flue gas by hot air and the influences of partially substituting the secondary air by hot air on heat transfer of air preheater and thermal efficiency of boiler. A case study is performed by referring to a typical 50 MW cyclone boiler with nine types of low fusion temperature coals. The results show that for coals with low ash content, the temperature increment of desulfurized flue gas can be over 7 ℃. While for coals with high ash content, the flue gas temperature can be heated to more than 70 ℃, and the surplus hot air can be sent to the furnace. When the hot air is introduced to partially substitute the secondary air, an instantaneous impact on the air preheater will give rise to a decrement of quantity of heat transferred and increments of temperatures of exit flue gas and hot secondary air. The variations of these thermodynamic parameters become smaller with increasing hot air temperature. After introduction of hot air, the thermal efficiency of boiler can increase, resulting in a decrease of fuel consumption rate. In addition, the heating surface area of air preheater can be reduced.


2016 ◽  
Vol 103 ◽  
pp. 1112-1118 ◽  
Author(s):  
Junxiang Liu ◽  
Qingbo Yu ◽  
Zongliang Zuo ◽  
Wenjun Duan ◽  
Zhicheng Han ◽  
...  

2019 ◽  
Vol 118 ◽  
pp. 01045
Author(s):  
Wenjun Duan ◽  
Yunke Gao ◽  
Qingbo Yu ◽  
Zhimei Wang

A novel method that a heat recovery system from blast furnace slag integrated with coal gasification reaction to generate syngas was proposed. The motion characteristic and critical velocity of the coal particles in the molten slag were estimated. Meanwhile, the effects of temperature and steam to coal ratio on coal gasification product distribution and gas characterization were discussed. The results showed that the coal particles (~75 μm) would break through the bondage of bubbles and transport into molten slag when the velocity of coal particles were above 4.20 m·s-1 and the diameter of bubbles were less 6 mm. There had higher gasification efficiency, gas yield production and H2 production by this method. The results suggested that the optimal conditions for slag waste heat recovery were achieved at 1623 K and steam to coal ratio of 2.0. Under these conditions, the gas yield and carbon conversion reached 133.48 mol·kg-1 and 97.81%, respectively. The proposed method enhanced the coal gasification efficiency and recovered the high quality of molten blast furnace slag waste heat effectively, and had important guidance for industrial manufacture.


2013 ◽  
Vol 112 ◽  
pp. 956-966 ◽  
Author(s):  
Hui Zhang ◽  
Hong Wang ◽  
Xun Zhu ◽  
Yong-Jun Qiu ◽  
Kai Li ◽  
...  

2019 ◽  
Author(s):  
Sakil Hossen ◽  
AKM M. Morshed ◽  
Amitav Tikadar ◽  
Azzam S. Salman ◽  
Titan C. Paul

Sign in / Sign up

Export Citation Format

Share Document