Cooling mode experimental analysis of a direct expansion geothermal heat pump with a control depending on the discharge pressure

2019 ◽  
Vol 160 ◽  
pp. 113955 ◽  
Author(s):  
Jean-Louis Comlan Fannou ◽  
Louis Lamarche ◽  
Clarence Semassou Guy ◽  
Kajl Stanislaw ◽  
Antoine Vianou
2014 ◽  
Vol 75 ◽  
pp. 290-300 ◽  
Author(s):  
Jean-Louis Fannou ◽  
Clément Rousseau ◽  
Louis Lamarche ◽  
Kajl Stanislaw

2015 ◽  
Author(s):  
Rousseau Clément ◽  
Jean-Louis Comlan Fannou ◽  
Louis Lamarche ◽  
Stanislaw Kajl ◽  
Mohamed Ouzzane

2021 ◽  
Vol 11 (22) ◽  
pp. 10778
Author(s):  
Hong-Seok Mun ◽  
Muhammad Ammar Dilawar ◽  
Dhanushka Rathnayake ◽  
Il-Byung Chung ◽  
Chong-Dae Kim ◽  
...  

This study compared the effects of the cooling mode of a geothermal heat pump (GHP) system with those of a traditional cooling system (ventilation fans) inside a pig house on the internal house temperature, harmful gas emissions, and the growth performance of the pigs. During the 19-week experimental period, the temperature inside the house connected to the GHP cooling system was significantly lower (p < 0.05) than that of a house with a conventional cooling system. Similarly, the temperature–humidity index (THI) was significantly reduced (p < 0.05) in the GHP cooling system-connected pig house. Furthermore, the concentrations of ammonia (NH3) and hydrogen sulfide (H2S) were also decreased significantly in the GHP-installed pig house (p < 0.05). However, no differences were observed in the concentrations of particulate matter (PM2.5) and formaldehyde (p > 0.05). The pigs reared in the GHP-equipped pig house gained significantly more weight (p < 0.05) by the end of the experiment. The GHP cooling system can therefore be implemented as a renewable, environmentally friendly energy source in pig farms for sustainable swine production without adversely affecting the productivity parameters.


2017 ◽  
Vol 6 (2) ◽  
pp. 145 ◽  
Author(s):  
Clément Rousseau ◽  
Jean-Louis Comlan Fannou ◽  
Louis Lamarche ◽  
Stanislaw Kajl

Geothermal heat pump technology is currently one of the most interesting technologies used to heat buildings. There are two designs used in the industry: geothermal heat pump using a secondary ground loop and Direct Expansion (DX) ground source heat pump. The latter is less used, possibly because less research has been carried out for the design of this kind of heat pump. In this paper, a transient model using the Comsol Multiphysic of a DX ground heat pump is presented in heating mode with R22, and a comparison with experimental results is presented with a 24-hour test. It is shown that the model was adequately validated by our experiment with only a maximum difference of 15%. Following this validation, a parametric analysis was realised on the geometry of the borehole. This study concluded that to have the best heat extraction of the ground, the pipes shank spacing need to be important without increasing the borehole diameter.Keywords: Direct Expansion geothermal heat pump, Modeling, R22Article History: Received January 16th 2017; Received in revised form May 28th 2017; Accepted June 6th 2017; Available onlineHow to Cite This Article: Rousseau, C., Fannou, J.L.C., Lamarche, L. and Kajl, S. (2017) Modeling and Experimental Validation of a Transient Direct Expansion Heat Pump. International Journal of Renewable Energy Develeopment, 6(2), 145-155.https://doi.org/10.14710/ijred.6.2.145-155


Sign in / Sign up

Export Citation Format

Share Document