Transition from horizontal expansion to vertical growth in the oyster prismatic layer

2021 ◽  
Vol 563 ◽  
pp. 47-53
Author(s):  
Jingliang Huang ◽  
Taifeng Jiang ◽  
Chuang Liu ◽  
Yangjia Liu ◽  
Guilan Zheng ◽  
...  
2005 ◽  
Vol 156 (12) ◽  
pp. 481-486 ◽  
Author(s):  
Jurij Diaci ◽  
Lahorka Kozjek

The objective of our research was to examine the effect of canopy shading on beech sapling architecture in the oldgrowth silver fir-beech forests of Pecka and Rajhenavski Rog. In August 2003 we sampled one plot (352 m2) in a large gap in Pecka, which was a result of a strong windstorm in 1983, and eight small gaps (26–78 m2) with similar sapling heights (3.8–8 m). A ground view of each gap was drawn including the characteristics of gap border trees and the density of separate sapling layers was recorded. The height and diameter were measured for each sapling, as well as the following quality characteristics on selected dominant saplings: width of the crown,number of larger branches and knots (>1/3 DBH), intensity of stem bending, deviation from vertical growth, number of terminal shoots, and the type of damage. The results show a negative effect of high canopy shading (estimated relative light intensity was below 5%) on the architectural quality of saplings. A lower overall density of saplings, greater intensity of bending and deviation from vertical growth, a shorter stem length without branches, a larger number of saplings with two terminal shoots, and a larger number of damaged saplings were observed in small gaps.


2019 ◽  
Vol 10 ◽  
Author(s):  
Hak-Jin Kim ◽  
Hye-Jin Tak ◽  
Joo-Won Moon ◽  
Sang-Hoon Kang ◽  
Seong Taek Kim ◽  
...  

2008 ◽  
Vol 28 (5-6) ◽  
pp. 383-393 ◽  
Author(s):  
Séverine Vancolen ◽  
Eric Verrecchia

2022 ◽  
Author(s):  
Hashem Al-Obaid ◽  
Sultan A. Asel ◽  
Jon Hansen ◽  
Rio Wijaya

Abstract Many techniques have been used to model, diagnose and detect fracture dimension and propagation during hydraulic fracturing. Diagnosing fracture dimension growth vs time is of paramount importance to reach the desired geometry to maximize hydrocarbon production potential and prevent contacting undesired fluid zones. The study presented here describes a technique implemented to control vertical fracture growth in a tight sandstone formation being stimulated near a water zone. This gas well was completed vertically as openhole with Multi- Stage Fracturing (MSF). Pre-Fracturing diagnostic tests in combination with high-resolution temperature logs provided evidence of vertical fracture height growth downward toward water zone. Pre-fracturing flowback indicated water presence that was confirmed by lab test. Several actions were taken to mitigate fracture vertical growth during the placement of main treatment. An artificial barrier with proppant was placed in the lower zone of the reservoir before main fracturing execution. The rate and viscosity of fracturing fluids were also adjusted to control the net pressure aiming to enhance fracture length into the reservoir. The redesigned proppant fracturing job was placed into the formation as planned. Production results showed the effectiveness of the artificial lower barrier placed to prevent fracture vertical growth down into the water zone. Noise log consists of Sonic Noise Log (SNL) and High Precision Temperature (HPT) was performed. The log analysis indicated that two major fractures were initiated away from water-bearing zone with minimum water production. Additionally, in- situ minimum stress profile indicated no enough contrast between layers to help confine fracture into the targeted reservoir. Commercial gas production was achieved after applying this stimulation technique while keeping water production rate controlled within the desired range. The approach described in this paper to optimize gas production in tight formation with nearby water contact during hydraulic fracturing treatments has been applied with a significant improvement in well production. This will serve as reference for future intervention under same challenging completion conditions.


Sign in / Sign up

Export Citation Format

Share Document