Large magnetodielectric effect in nickel zinc ferrite–lithium niobate nanocomposite

2012 ◽  
Vol 541 ◽  
pp. 96-100 ◽  
Author(s):  
Shilpi Banerjee ◽  
Partha Hajra ◽  
Asim Bhaumik ◽  
Sri Bandyopadhyay ◽  
Dipankar Chakravorty
2013 ◽  
Vol 114 (18) ◽  
pp. 183903 ◽  
Author(s):  
B. Ghosh ◽  
M. Sardar ◽  
S. Banerjee

1986 ◽  
Vol 108 (1) ◽  
pp. 22-28 ◽  
Author(s):  
B. Bhushan ◽  
G. W. Nelson ◽  
M. E. Wacks

The transfer of wear debris of a nickel-zinc ferrite head to a magnetic tape was measured by autoradiography of the tape after it was worn against the irradiated ferrite head. Ferrite deposits on the tape were observed only after 5000 passes. Dots or specks on the autoradiograph of the tapes of about 200 micrometers in diameter, caused by particles of ferrite about 1 μm in diameter and mass of about 10−11 g, were measured. The average amount of ferrite deposited on the tape after 20,000 passes was about 0.6 nanogram per square centimeter; some areas showed uniform deposits of ferrite concentration of 10–20 ng/cm2. Based on our estimates of total head wear, only a small fraction (about 0.6 percent) of the total ferrite wear debris was transferred to the tape, about 0.2 percent was transferred to the tape-drive component surfaces, and the rest, we conclude, was airborne.


2010 ◽  
Vol 9 ◽  
pp. 20-23 ◽  
Author(s):  
Ashok Kumar ◽  
Annveer ◽  
Manju Arora ◽  
M.S. Yadav ◽  
R.P. Panta

2013 ◽  
Vol 332 ◽  
pp. 98-102 ◽  
Author(s):  
Shilpi Banerjee ◽  
Partha Hajra ◽  
Mykanth Reddy Mada ◽  
Asim Bhaumik ◽  
Sri Bandyopadhyay ◽  
...  

2016 ◽  
Vol 52 (9) ◽  
pp. 932-938 ◽  
Author(s):  
G. V. Bazuev ◽  
O. I. Gyrdasova ◽  
S. I. Novikov ◽  
A. Yu. Kuznetsov

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Ayman Galal ◽  
Olfat Sadek ◽  
Moataz Soliman ◽  
Shaker Ebrahim ◽  
M. Anas

AbstractElectric arc furnace dust (EAFD) and waste pickle liquor (WPL); two major side products of the steel industry with negative environmental impact were used for the synthesis of nickel zinc ferrite (NZF); the important magnetic ceramic material of versatile industrial applications. The structural and magnetic properties of the prepared material were examined which showed good magnetic properties (high saturation magnetization and low coercivity) compared with those synthesized from pure reagents. In the applied process, nano sized nickel zinc ferrite (NZF) with a composition of Nix(Zn + impurities)1−xFe2O4 (where x = 0, 0.25, 0.5, 0.75 and impurities of manganese, magnesium, and calcium were prepared using zinc-containing electric arc furnace dust (EAFD) and waste pickle liquor (WPL). The chemical compositions of the prepared samples were determined using X-ray fluorescence (XRF) analysis. The optimum acetic acid concentration for EAFD treatment was found 2% v/v that decreased Ca content of EAFD by 70.6% without loss of Fe and Zn. The structural and morphological characterization was done by X-ray diffraction (XRD), Fourier transform infrared (FTIR) and Field Emission Scanning Electron Microscope (FESEM) to confirm the formation of Ni–Zn ferrite nanoparticles and estimate the particle sizes. The maximum saturation magnetization (Ms) of 73.89 emu/g was achieved at 0.5 Ni content and the minimum coercivity of 2.55 Oe was obtained at 0.25 Ni content.


Sign in / Sign up

Export Citation Format

Share Document