Rearrangement of the molecular orientation of Alq3 in organic light-emitting diodes under constant current aging investigated using sum frequency generation spectroscopy

2014 ◽  
Vol 616-617 ◽  
pp. 86-90 ◽  
Author(s):  
Takayuki Miyamae ◽  
Noriyuki Takada ◽  
Toshihiro Yoshioka ◽  
Satoshi Miyaguchi ◽  
Hiroshi Ohata ◽  
...  
2015 ◽  
Vol 106 (6) ◽  
pp. 063301 ◽  
Author(s):  
L. Zhao ◽  
T. Komino ◽  
M. Inoue ◽  
J.-H. Kim ◽  
J. C. Ribierre ◽  
...  

2015 ◽  
Vol 3 (31) ◽  
pp. 6429-6438 ◽  
Author(s):  
S. Bellani ◽  
M. Porro ◽  
C. Caddeo ◽  
M. I. Saba ◽  
P. B. Miranda ◽  
...  

Polythiophene/water interfaces are investigated by sum frequency generation spectroscopy and molecular dynamics simulations, showing a preferential edge-on molecular orientation.


Langmuir ◽  
2011 ◽  
Vol 27 (10) ◽  
pp. 6049-6058 ◽  
Author(s):  
A. Ballard Andrews ◽  
Arthur McClelland ◽  
Oona Korkeila ◽  
Alexander Demidov ◽  
Amber Krummel ◽  
...  

2011 ◽  
Vol 1359 ◽  
Author(s):  
J. Boizot ◽  
V. Gohri ◽  
H. Doyeux

ABSTRACTThe aim of this study is to analyze and mitigate the voltage drift phenomenon observed in top-emitting organic light emitting diodes (OLED) when driven at constant current. An operating device may experience voltage increase over time due to factors such as interface or bulk material degradation, charge accumulation and formation of trap states. Single-carrier devices were fabricated to understand the contribution to voltage drift from each of these causes. Doping in electron injection layer (4, 7-diphenyl-1,10-phenanthroline or Bphen) and hole injection layer (2,2’,7,7’-tetra(N,N-di-tolyl)amino-spiro-bifluorene or Spiro-TTB) were optimized to obtain ohmic injection contacts. Devices with tris(8-hydroxy-quinoline) aluminium (Alq3) degrade significantly with holes injection and undergo high voltage increase in lifetime test measurements. On the contrary, devices with N,N’-di(naphtalen-1-y1)-N,N’-diphenyl-benzidine (NPB) exhibit an ambipolar charge transport behavior and low voltage drift under both hole and electron injection.


2015 ◽  
Vol 3 (42) ◽  
pp. 11178-11191 ◽  
Author(s):  
Maki Shibata ◽  
Yoshiya Sakai ◽  
Daisuke Yokoyama

Film densities, transition temperatures, and degrees of horizontal molecular orientation of vacuum-deposited and spin-coated amorphous organic semiconductor films used for OLEDs are systematically and quantitatively compared, and their general differences are discussed.


Sign in / Sign up

Export Citation Format

Share Document