Investigations on shunt active power filter in a PV-wind-FC based hybrid renewable energy system to improve power quality using hardware-in-the-loop testing platform

2019 ◽  
Vol 177 ◽  
pp. 105957 ◽  
Author(s):  
Kumar Ravinder ◽  
Hari Om Bansal
2021 ◽  
Vol 1 (4) ◽  
pp. 23-29
Author(s):  
Adel Elgammal ◽  
Tagore Ramlal

Increased usage of combined PV-Wind renewable energy sources is seen as a positive step toward reducing air pollution and carbon emissions. However, since non-linear loads have increased dramatically, voltage quality and harmonic distortion concerns have arisen, affecting the operation of combined PV-Wind RES and smart-grid electrical transmission structures. This study shows how a Shunt active power filter may improve energy quality in a microgrid structure at the distribution level. The major goal of this article is to find an appropriate controller approach for improving the shunt active power filter's compensating capacity. This paper simulates a PV-Wind hybrid renewable energy system that operates in the presence of unpredictably variable solar and wind energy resources. The objective is to allow the construction of an electrical control structure that produces the right duty cycle. It will aid in the regulation and stabilization of voltages at dc/dc energy conversion plant. Simulation is used to assess the proposed control system's ability to enhance power quality. The device's compensating capability is mostly determined by the DC link capacitor voltage control. The closed loop functioning of a proportional integral controller is used to attain this voltage regulation in the past. To increase the functioning of a shunt active power filter, the MOPSO procedure approach has been presented. The performance of suggested approaches and the comparison of different pulse generating strategies have been validated in the SIMULINK/MATLAB model environment. The suggested technology successfully improves power quality on the grid and maintains a steady voltage on the grid despite variations in RE output and load.


2020 ◽  
Vol 10 (12) ◽  
pp. 4061 ◽  
Author(s):  
Naoto Takatsu ◽  
Hooman Farzaneh

After the Great East Japan Earthquake, energy security and vulnerability have become critical issues facing the Japanese energy system. The integration of renewable energy sources to meet specific regional energy demand is a promising scenario to overcome these challenges. To this aim, this paper proposes a novel hydrogen-based hybrid renewable energy system (HRES), in which hydrogen fuel can be produced using both the methods of solar electrolysis and supercritical water gasification (SCWG) of biomass feedstock. The produced hydrogen is considered to function as an energy storage medium by storing renewable energy until the fuel cell converts it to electricity. The proposed HRES is used to meet the electricity demand load requirements for a typical household in a selected residential area located in Shinchi-machi in Fukuoka prefecture, Japan. The techno-economic assessment of deploying the proposed systems was conducted, using an integrated simulation-optimization modeling framework, considering two scenarios: (1) minimization of the total cost of the system in an off-grid mode and (2) maximization of the total profit obtained from using renewable electricity and selling surplus solar electricity to the grid, considering the feed-in-tariff (FiT) scheme in a grid-tied mode. As indicated by the model results, the proposed HRES can generate about 47.3 MWh of electricity in all scenarios, which is needed to meet the external load requirement in the selected study area. The levelized cost of energy (LCOE) of the system in scenarios 1 and 2 was estimated at 55.92 JPY/kWh and 56.47 JPY/kWh, respectively.


Sign in / Sign up

Export Citation Format

Share Document